- 您現在的位置：買賣IC網 > PDF目錄9673 > XRT91L31IQ-F (Exar Corporation)IC TXRX SONET/SDH 8BIT 64QFP PDF資料下載
參數資料
| 型號： | XRT91L31IQ-F |
| 廠商： | Exar Corporation |
| 文件頁數： | 9/41頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC TXRX SONET/SDH 8BIT 64QFP |
| 標準包裝： | 1 |
| 類型： | 收發器，多路復用器 |
| PLL： | 是 |
| 主要目的： | 以太網，SONET/SDH |
| 輸入： | LVCMOS，LVPECL，LVTTL |
| 輸出： | LVCMOS，LVPECL，LVTTL |
| 電路數： | 1 |
| 差分 - 輸入:輸出： | 是/是 |
| 頻率 - 最大： | 622.08MHz |
| 電源電壓： | 3.135 V ~ 3.465 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 64-FQFP |
| 供應商設備封裝： | 64-PQFP（10x10） |
| 包裝： | 托盤 |
| 其它名稱： | 1016-1361 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁當前第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁
XRT91L31
17
REV. 1.0.2
STS-12/STM-4 OR STS-3/STM-1 SONET/SDH TRANSCEIVER
2.3
Receive Clock and Data Recovery
The clock and data recovery (CDR) unit accepts the high speed NRZ serial data from the Differential LVPECL
receiver and generates a clock that is the same frequency as the incoming data. The clock recovery can either
utilize the transmitter’s CMU reference clock from either REFCLKP/N or TTLREFCLK (+/- 20ppm) or it can use
independent clock source CDRAUXREFCLK (+/- 200ppm) to train and monitor its clock recovery PLL. Initially
upon startup, the PLL locks to the local reference clock. Once this is achieved, the PLL then attempts to lock
onto the incoming receive data stream. Whenever the recovered clock frequency deviates from the local
reference clock frequency by more than approximately ±500 ppm, the clock recovery PLL will switch and lock
back onto the local reference clock. Whenever a Loss of Lock or a Loss of Signal event occurs, the CDR will
continue to supply a receive clock (based on the local reference) to the framer/mapper device. When the
LOSEXT is asserted by the optical module or when LOS is detected, the receive parallel data output will be
forced to a logic zero state for the entire duration that a LOS condition is detected. This acts as a receive data
mute upon LOS function to prevent random noise from being misinterpreted as valid incoming data. When the
LOSEXT becomes inactive and the recovered clock is determined to be within ±500 ppm accuracy with respect
to the local reference source and LOS is no longer declared, the clock recovery PLL will switch and lock back
onto the incoming receive data stream. Table 7 shows Clock and Data Recovery reference clock settings.
Table 8 specifies the Clock and Data Recovery Unit performance characteristics.
TABLE 7: CLOCK DATA RECOVERY UNIT REFERENCE CLOCK SETTINGS
1Requires frequency accuracy better than +/- 20 ppm in order for the transmitted data rate frequency
to have the necessary accuracy required for SONET systems.
2CDRAUXREFCLK requires accuracy of 77.76 MHz +/- 200 ppm.
2.3.1
Internal Clock and Data Recovery Bypass
Optionally, the internal CDR unit can be disabled and bypassed in lieu of an externally recovered clock.
Asserting the CDRDIS "High" disables the internal Clock and Data Recovery unit and the received serial data
bypasses the integrated CDR block. RXINP/N is then sampled on the rising edge of the externally recovered
CMUFREQSEL CDRREFSEL
STS12/
STS3
REFCLKP/N1OR
TTLREFCLK1
FREQUENCY (MHZ)
CDRAUXREFCLK2
FREQUENCY (MHZ)
CDR OUTPUT
FREQUENCY (MHZ)
0
77.76 MHz
not used
155.52
0
1
77.76 MHz
not used
622.08
1
0
19.44 MHz
not used
155.52
1
0
1
19.44 MHz
not used
622.08
X
1
0
not referenced by CDR
77.76 MHz
155.52
X
1
not referenced by CDR
77.76 MHz
622.08
TABLE 8: CDR AUXREFCLK REFERENCE FREQUENCY REQUIREMENT FOR CLOCK AND DATA RECOVERY
NAME
PARAMETER
MIN
TYP
MAX
UNITS
REFDUTY
Reference clock duty cycle
40
60
%
REFTOL
Reference clock frequency tolerance
-200
+200
ppm
相關PDF資料 |
PDF描述 |
|---|---|
| MS27496E19A32S | CONN RCPT 32POS BOX MNT W/SCKT |
| AD9548BCPZ | IC CLOCK GEN/SYNCHRONIZR 88LFCSP |
| V375C36M150BL3 | CONVERTER MOD DC/DC 36V 150W |
| MAX3676EHJ+ | IC CLOCK RECOVERY 32-TQFP |
| ADN2813ACPZ | IC CLK/DATA REC 1.25GBPS 48LFCSP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| XRT91L31IQ-F | 制造商:Exar Corporation 功能描述:SONET Transceiver IC |
| XRT91L31IQTR | 功能描述:總線收發器 SONET/SDH, FULL DPLX 3.3V I/O, LOS, CMU RoHS:否 制造商:Fairchild Semiconductor 邏輯類型:CMOS 邏輯系列:74VCX 每芯片的通道數量:16 輸入電平:CMOS 輸出電平:CMOS 輸出類型:3-State 高電平輸出電流:- 24 mA 低電平輸出電流:24 mA 傳播延遲時間:6.2 ns 電源電壓-最大:2.7 V, 3.6 V 電源電壓-最小:1.65 V, 2.3 V 最大工作溫度:+ 85 C 封裝 / 箱體:TSSOP-48 封裝:Reel |
| XRT91L31IQTR-F | 功能描述:總線收發器 SONET/SDH, FULL DPLX 3.3V I/O, LOS, CMU RoHS:否 制造商:Fairchild Semiconductor 邏輯類型:CMOS 邏輯系列:74VCX 每芯片的通道數量:16 輸入電平:CMOS 輸出電平:CMOS 輸出類型:3-State 高電平輸出電流:- 24 mA 低電平輸出電流:24 mA 傳播延遲時間:6.2 ns 電源電壓-最大:2.7 V, 3.6 V 電源電壓-最小:1.65 V, 2.3 V 最大工作溫度:+ 85 C 封裝 / 箱體:TSSOP-48 封裝:Reel |
| XRT91L32 | 制造商:EXAR 制造商全稱:EXAR 功能描述:STS-12/STM-4 OR STS-3/STM-1 SONET/SDH TRANSCEIVER |
| XRT91L32ES | 功能描述:LIN 收發器 SONET SDH 8 bit TRANCEIVER RoHS:否 制造商:NXP Semiconductors 工作電源電壓: 電源電流: 最大工作溫度: 封裝 / 箱體:SO-8 |
發布緊急采購，3分鐘左右您將得到回復。