
XRT94L33
xr
Rev.1.2.0.
3-CHANNEL DS3/E3/STS-1 TO STS-3/STM-1 MAPPER IC DATA SHEET
456
This step configures an internal “Receive UTOPIA Address assignment” pointer to point to “STS-3c Channel
2” within the XRT94L33.
STEP 3b – Set Bits 0 through 4 (“Rx_UTOPIA_Addr[4:0]”) within the “Receive UTOPIA Address”
Register to the desired “Multi-PHY” Address value for this channel [c4, c3, c2, c1, c0]; as depicted
below.
Receive UTOPIA Address Register (Address = 0x0513)
BIT 7
BIT 6
BIT 5
BIT 4
BIT 3
BIT 2
BIT 1
BIT 0
Unused
Rx_UTOPIA_Addr[4:0]
RO
R/W
0
C4
C3
C2
C1
C0
This step configures the Receive UTOPIA Address, of the value [C4, C3, C2, C1, C0] to be assigned to STS-
3c Channel 2.
Notes:
During this step, the user can write in any value, between 0x00 and 0x1E, provided this “Multi-PHY Address” is unique
among all of the Receive UTOPIA Interface addresses within a “Multi-PHY” system.
Use of the value “0x1F” is NOT permitted.
These steps do not assign a Transmit UTOPIA Address value to STS-3c Channel 2. This assignment must be performed
separately per the “Transmit UTOPIA Address Assignment” instructions presented in Section _.
Once the user has executed STEPS 3a and 3b then STS-3c Channel 2 (within the XRT94L33) has been
assigned the “Receive UTOPIA Address” of [c4, c3, c2, c1, c0].
STEP 4 – Assign a “Receive UTOPIA Address” to STS-3c Channel 3
The user can accomplish this by doing the following.
STEP 4a – Set Bits 0 through 4 (“Rx_UTOPIA_Port_Number[4:0]”) within the “Receive UTOPIA Port
Number Register” to “0x03”; as depicted below.
Receive UTOPIA Port Number Register (Address = 0x0517)
BIT 7
BIT 6
BIT 5
BIT 4
BIT 3
BIT 2
BIT 1
BIT 0
Unused
Rx_UTOPIA_Port_Number[4:0]
R/O
R/W
0
1
This step configures an internal “Receive UTOPIA Address assignment” pointer to point to “STS-3c Channel
3” within the XRT94L33.
STEP 4b – Set Bits 0 through 4 (“Rx_UTOPIA_Addr[4:0]”) within the “Receive UTOPIA Address”
Register to the “Multi-PHY” Address value for this channel [d4, d3, d2, d1, d0]; as depicted below.
Receive UTOPIA Address Register (Address = 0x0513)
BIT 7
BIT 6
BIT 5
BIT 4
BIT 3
BIT 2
BIT 1
BIT 0
Unused
Rx_UTOPIA_Addr[4:0]
RO
R/W
0
D4
D3
D2
D1
D0
This step configures the Receive UTOPIA Address, of the value [D4, D3, D2, D1, D0] to be assigned to STS-
3c Channel 3.