- 您現在的位置：買賣IC網 > PDF目錄373840 > ZXBM1004Q16TA (ZETEX PLC) CHOPPER STABILIZED SWITCH W/TIN PLATING PDF資料下載
參數資料
| 型號： | ZXBM1004Q16TA |
| 廠商： | ZETEX PLC |
| 元件分類： | 運動控制電子 |
| 英文描述： | CHOPPER STABILIZED SWITCH W/TIN PLATING |
| 中文描述： | BRUSHLESS DC MOTOR CONTROLLER, PDSO16 |
| 封裝： | MO-137AB, QSOP-16 |
| 文件頁數： | 6/12頁 |
| 文件大?。?/td> | 265K |
| 代理商： | ZXBM1004Q16TA |
As these threshold voltages are nominally setto V
=
3V and V
THL
= 1V the equations can be simplified as
follows:
T
C
2
I
C
2
I
PWM
PWMC
PWMD
=
+
C
LCK
- Locked rotor timing capacitor
Should the fan stop rotating for any reason, i.e. an
obstruction in the fan blade or a seized bearing, then
the device will enter a Rotor Locked condition. In this
condition aftera predetermined time(T
) theRD pin
will go high and the Phase outputs will be disabled.
After a further delay (T
) the controller will re-enable
the Phase drive fora defined period (T
) in an attempt
to re-start the fan. This cycle of (T
) and (T
ON
) will be
repeated indefinitely or until the fan re-starts.
GND - Ground
This is the device supply ground return pin and will
generally be the most negative supply pin to the fan.
RD - Locked Rotor error output
This pin is the Locked Rotor output as referred to in the
C
timing section above. It is high when the rotor is
stopped and low when it is running.
This is an open collector drive giving an active pull
down with the high level being provided by an external
pull up resistor.
FG - Frequency Generator (speed) output
This is the Frequency Generator output and is a
buffered signal from the Hall sensor.
This is an open collector drive giving an active pull
down with the high level being provided by an external
pull up resistor.
Ph1Lo & Ph2Lo - Low-side External H-bridge
Driver
This pair of outputs drive the Low side of the external
high power H-bridge devices which in turn drives the
single phase winding. These outputs provide both the
commutation and PWM waveforms.The outputs are of
the Darlington emitter follower type with an active
pull-down to help faster switch off when using bipolar
devices.Wheninthehighstatetheoutputs willprovide
up to 80mA of drive into the base or gates of external
transistors as shown in the Typical Application circuit
following.
When in the low state the active Phase drive is capable
of sinking up to 16mA when driving low to aid turn off
times during PWM operation. When the Phase is
inactive the outputis held low by an internal pull-down
resistor.
Ph1Hi & Ph2Hi - High-side External H-bridge
Driver
These are the High side outputs to the external
H-bridge and are open collector outputs capable of
sinking 100mA.This signalprovides commutationonly
to the H-bridge.
V+OP - Phase Outputs Supply Voltage
This pin is the supply to the Phase outputs and will be
connected differently dependant upon external
transistor type.
For bipolar devices this pin will be connected by a
resistor to the V
pin. The resistor is used to control
the current into the transistor base so its value is
chosen accordingly.
ForMOSFET devices the pin will connectdirectly to the
V
CC
pin.
ZXBM1004
S E M IC O N D U C T O R S
ISSUE 4 - SEPTEMBER 2004
6
相關PDF資料 |
PDF描述 |
|---|---|
| ZXBM1004Q16TC | CHOPPER STABILIZED SWITCH W/TIN PLATING |
| ZXBM2001 | PTSE 30C 1#16,29#20 SKT PLUG |
| ZXBM2001X10TA | VARIABLE SPEED 2-PHASE FAN MOTOR CONTROLLER |
| ZXBM2001X10TC | VARIABLE SPEED 2-PHASE FAN MOTOR CONTROLLER |
| ZXBM2002 | VARIABLE SPEED 2-PHASE FAN MOTOR CONTROLLER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ZXBM1004Q16TC | 功能描述:馬達/運動/點火控制器和驅動器 SNGLE PHSE PRE-DRVER RoHS:否 制造商:STMicroelectronics 產品:Stepper Motor Controllers / Drivers 類型:2 Phase Stepper Motor Driver 工作電源電壓:8 V to 45 V 電源電流:0.5 mA 工作溫度:- 25 C to + 125 C 安裝風格:SMD/SMT 封裝 / 箱體:HTSSOP-28 封裝:Tube |
| ZXBM1015 | 制造商:ZETEX 制造商全稱:ZETEX 功能描述:VARIABLE SPEED SINGLE- PHASE BLDC MOTOR CONTROLLER |
| ZXBM1015_07 | 制造商:ZETEX 制造商全稱:ZETEX 功能描述:VARIABLE SPEED SINGLE- PHASE BLDC MOTOR CONTROLLER |
| ZXBM1015ST20TC | 功能描述:馬達/運動/點火控制器和驅動器 Sngl Phase pre Drive RoHS:否 制造商:STMicroelectronics 產品:Stepper Motor Controllers / Drivers 類型:2 Phase Stepper Motor Driver 工作電源電壓:8 V to 45 V 電源電流:0.5 mA 工作溫度:- 25 C to + 125 C 安裝風格:SMD/SMT 封裝 / 箱體:HTSSOP-28 封裝:Tube |
| ZXBM1016 | 制造商:ZETEX 制造商全稱:ZETEX 功能描述:High efficiency variable speed single-phase fan motor controller |
發布緊急采購，3分鐘左右您將得到回復。