- 您現在的位置：買賣IC網 > PDF目錄371353 > 20068 and Am29243? EH Controller Data Sheet PDF資料下載
參數資料
| 型號： | 20068 |
| 英文描述： | and Am29243? EH Controller Data Sheet |
| 中文描述： | 和Am29243？高血壓控制器數據表 |
| 文件頁數： | 13/36頁 |
| 文件大?。?/td> | 428K |
| 代理商： | 20068 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁當前第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁
P R E L I M I N A R Y
13
Am29240 EH Microcontroller Series
RESET
Reset (input, asynchronous)
This input places the processor in the Reset mode. This
signal has special hardening against metastable states,
allowing it to be driven with a slow-rise-time signal.
ROMCS3–ROMCS0
ROM Chip Selects, Banks 3–0 (output, synchronous)
A Low level on one of these signals selects the memory
devices in the corresponding ROM bank. ROMCS3 se-
lects devices in ROM Bank 3, etc. The timing and access
parameters of each bank are individually programmable.
ROMOE
ROM Output Enable (output, synchronous)
This signal enables the selected ROM Bank to drive the
ID bus. It is used to prevent bus contention when switch-
ing between different ROM banks or switching between
a ROM bank and another device or DRAM bank.
RSWE
ROM Space Write Enable (output, synchronous)
This signal is used to write an alterable memory in a
ROM bank (such as an SRAM or Flash EPROM).
RXDA
Receive Data, Port A (input, asynchronous)
This input is used to receive serial data to Serial Port A.
RXDB
Receive Data, Port B (input, asynchronous)
This input is used to receive data to Serial Port B. This
signal is supported on the Am29240EH and
Am29243EH microcontrollers only.
STAT2–STAT0
CPU Status (output, synchronous)
These outputs indicate information about the processor
or the current access for the purposes of hardware
debug.
TCK
Test Clock Input
(input, asynchronous, pull-up resistor)
This input is used to operate the Test Access Port. The
state of the Test Access Port must be held if this clock is
held either High or Low. This clock is internally synchro-
nized to MEMCLK for certain operations of the Test Ac-
cess Port controller, so signals internally driven and
sampled by the Test Access Port are synchronous to
processor internal clocks.
TDI
Test Data Input
(input, synchronous to TCK, pull-up resistor)
This input supplies data to the test logic from an external
source. It is sampled on the rising edge of TCK. If it is not
driven, it appears High internally.
TDMA
Terminate DMA (input/output, synchronous)
This signal is either an input or an output as controlled by
the corresponding DMA Control Register. As an input,
this signal can be asserted during an external DMA
transfer (non-fly-by) to terminate the transfer after the
current access. The TDMA input is ignored during fly-by
transfers. As an output, this signal is asserted to indicate
the final transfer of a sequence.
TDO
Test Data Output
(three-state output, synchronous to TCK)
This output supplies data from the test logic to an exter-
nal destination. It changes on the falling edge of TCK. It
is in the high-impedance state except when scanning is
in progress.
TMS
Test Mode Select
(input, synchronous to TCK, pull-up resistor)
This input is used to control the Test Access Port. If it is
not driven, it appears High internally.
TR/OE
Video DRAM Transfer/Output Enable
(output, synchronous)
This signal is used with video DRAMs to transfer data to
the video shift register. It is also used as an output en-
able in normal video DRAM read cycles. This signal is
supported on the Am29240EH and Am29245EH micro-
controllers only.
TRAP1–TRAP0
Trap Requests 1–0
(input, asynchronous, internal pull-ups)
These inputs generate prioritized trap requests. The
trap caused by TRAP0 has the highest priority. These
trap requests are disabled by the DA bit of the Current
Processor Status Register. These signals have special
hardening against metastable states, allowing them to
be driven with slow-transition-time signals.
相關PDF資料 |
PDF描述 |
|---|---|
| 2007 | KUPPLUNG DIN STANDARD 7POL GRAU |
| 200955 | STROMVERSORGUNGS-MODUL |
| 2009 | DOPPELMUFFE |
| Z0204 | DOPPELMUFFE |
| 200CFX33M10x20 | MINIATURE ALUMINUM ELECTROLYTIC CAPACITORS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 20068-0005 | 制造商: 功能描述: 制造商:undefined 功能描述: |
| 2006-8001-90 | 功能描述:RF 連接器 M39012/82B3001 RoHS:否 制造商:Bomar Interconnect 產品:Connectors 射頻系列:BNC 型式:Jack (Female) 極性: 觸點電鍍:Gold 阻抗: 端接類型:Solder 主體類型:Straight Bulkhead 電纜類型: |
| 2006800392 | 制造商: 功能描述: 制造商:undefined 功能描述: |
| 2006-8008-92 | 制造商:TE CONNECTIVITY 功能描述:RF COAXIAL PANEL MOUNT CONNECTOR |
| 2-0068-05400-000-011-002 | 制造商:3M/TEXTOOL 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。