SN65HVD230Q-Q1
SN65HVD231Q-Q1
SN65HVD232Q-Q1
SGLS117C
–
JUNE 2001
–
REVISED JUNE 2002
6
www.ti.com
absolute maximum ratings over operating free-air temperature (see Note 1) (unless otherwise
noted)
Supply voltage range, V
CC
Voltage range at any bus terminal (CANH or CANL)
Voltage input range, transient pulse, CANH and CANL, through 100
(see Figure 7)
Input voltage range, V
I
(D or R)
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Electrostatic discharge: Human body model (see Note 2)
–
0.3 V to 6 V
–
7 V to 16 V
–
25 V to 25 V
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . .
–
0.5 V to V
CC
+ 0.5 V
. . . . . . . . . . . . . . . . . .
CANH, CANL and GND
All pins
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
15 kV
2.5 kV
4 kV
Charged-device model (see Note 3) All pins
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Storage temperature range, T
stg
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Lead temperature 1,6 mm (1/16 inch) from case for 10 seconds
Continuous total power dissipation
See Dissipation Rating table
–
65
°
C to 150
°
C
260
°
C
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Stresses beyond those listed under
“
absolute maximum ratings
”
may cause permanent damage to the device. These are stress ratings only, and
functional operation of the device at these or any other conditions beyond those indicated under
“
recommended operating conditions
”
is not
implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
NOTES:
1. All voltage values, except differential I/O bus voltages, are with respect to network ground terminal.
2. Tested in accordance with JEDEC Standard 22, Test Method A114-A.
3. Tested in accordance with JEDEC Standard 22, Test Method C101.
DISSIPATION RATING TABLE
DERATING FACTOR
ABOVE TA = 25
°
C
5.8 mW/
°
C
PACKAGE
TA
≤
25
°
C
POWER RATING
TA = 70
°
C
POWER RATING
TA = 85
°
C
POWER RATING
TA = 125
°
C
POWER RATING
D
725 mW
464 mW
377 mW
145 mW
This is the inverse of the junction-to-ambient thermal resistance when board-mounted and with no air flow.
recommended operating conditions
PARAMETER
MIN
NOM
MAX
UNIT
Supply voltage, VCC
Voltage at any bus terminal (common mode) VIC
Voltage at any bus terminal (separately) VI
High-level input voltage, VIH
Low-level input voltage, VIL
Differential input voltage, VID (see Figure 5)
V(RS)
V(RS) for standby or sleep
Rs wave-shaping resistance
3
3.6
V
–
2
§
7
V
–
2.5
7.5
V
D, R
2
V
D, R
0.8
V
–
6
6
V
0
VCC
VCC
100
V
0.75 VCC
V
k
0
High level output current I
High-level output current, IOH
Driver
–
40
mA
Receiver
–
8
Low level output current I
Low-level output current, IOL
Driver
48
mA
Receiver
8
Operating free-air temperature, TA
§
The algebraic convention, in which the least positive (most negative) limit is designated as minimum is used in this data sheet.
–
40
125
°
C