- 您現在的位置：買賣IC網 > PDF目錄371439 > 29F040C-90 (Macronix International Co., Ltd.) 4M-BIT [512K x 8] CMOS SINGLE VOLTAGE 5V ONLY EQUAL SECTOR FLASH MEMORY PDF資料下載
參數資料
| 型號： | 29F040C-90 |
| 廠商： | Macronix International Co., Ltd. |
| 英文描述： | 4M-BIT [512K x 8] CMOS SINGLE VOLTAGE 5V ONLY EQUAL SECTOR FLASH MEMORY |
| 中文描述： | 4分位[為512k × 8] CMOS單電壓5V只等于部門閃存 |
| 文件頁數： | 8/38頁 |
| 文件大小： | 592K |
| 代理商： | 29F040C-90 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁當前第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁
8
P/N:PM1201
REV. 1.0, DEC. 20, 2005
MX29F040C
SECTOR ERASE COMMANDS
The Automatic Sector Erase does not require the device
to be entirely pre-programmed prior to executing the Au-
tomatic Set-up Sector Erase command and Automatic
Sector Erase command. Upon executing the Automatic
Sector Erase command, the device will automatically pro-
gram and verify the sector(s) memory for an all-zero data
pattern. The system is not required to provide any con-
trol or timing during these operations.
When the sector(s) is automatically verified to contain
an all-zero pattern, a self-timed sector erase and verify
begin. The erase and verify operations are complete
when the data on Q7 is "1" and the data on Q6 stops
toggling for two consecutive read cycles, at which time
the device returns to the Read mode. The system is not
required to provide any control or timing during these op-
erations.
When using the Automatic Sector Erase algorithm, note
that the erase automatically terminates when adequate
erase margin has been achieved for the memory array
(no erase verification command is required). Sector erase
is a six-bus cycle operation. There are two "unlock" write
cycles. These are followed by writing the set-up com-
mand 80H. Two more "unlock" write cycles are then fol-
lowed by the sector erase command 30H. The sector
address is latched on the falling edge of WE# or CE#,
whichever happens later, while the command (data) is
latched on the rising edge of WE# or CE#, whichever
happens first. Sector addresses selected are loaded
into internal register on the sixth falling edge of WE# or
CE#, whichever happens later. Each successive sector
load cycle started by the falling edge of WE# or CE#,
whichever happens later must begin within 30us from
the rising edge of the preceding WE# or CE#, whichever
happens first. Otherwise, the loading period ends and
internal auto sector erase cycle starts. (Monitor Q3 to
determine if the sector erase timer window is still open,
see section Q3, Sector Erase Timer.) Any command other
than Sector Erase (30H) or Erase Suspend (B0H) during
the time-out period resets the device to read mode.
Status
Q7
Q6
Q5
Q3
Q2
Note1
Q7#
0
1
Note2
0
0
0
Byte Program in Auto Program Algorithm
Auto Erase Algorithm
Toggle
Toggle
No
Toggle
Data
N/A
1
N/A
No Toggle
Toggle
Toggle
Erase Suspend Read
(Erase Suspended Sector)
Erase Suspend Read
(Non-Erase Suspended Sector)
Erase Suspend Program
In Progress
Erase Suspended Mode
Data
Data
Data
Data
Q7#
Q7#
0
Q7#
Toggle
Toggle
Toggle
Toggle
0
1
1
1
N/A
N/A
1
N/A
N/A
Byte Program in Auto Program Algorithm
Auto Erase Algorithm
Time Limits Erase Suspend Program
No Toggle
Toggle
N/A
Exceeded
TABLE 4. Write Operation Status
Note:
1. Q7 and Q2 require a valid address when reading status information. Refer to the appropriate subsection for further
details.
2. Q5 switches to '1' when an Auto Program or Auto Erase operation has exceeded the maximum timing limits.
See "Q5:Exceeded Timing Limits " for more information.
相關PDF資料 |
PDF描述 |
|---|---|
| 29F080-12 | 8M-BIT [1024K x 8] CMOS EQUAL SECTOR FLASH MEMORY |
| 29F080-70 | 8M-BIT [1024K x 8] CMOS EQUAL SECTOR FLASH MEMORY |
| 29F080-90 | 8M-BIT [1024K x 8] CMOS EQUAL SECTOR FLASH MEMORY |
| 29F1610 | The CAT24FC02 is a 2-kb Serial CMOS EEPROM internally organized as 256 words of 8 bits each |
| 29F1610A | The CAT24FC02 is a 2-kb Serial CMOS EEPROM internally organized as 256 words of 8 bits each |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 29F0418-0SR (900PC RL) | 制造商:Laird Technologies Inc 功能描述:SMD,6.1X4.5MM,6A I MAX,83 OHM,GULL WING,4 LINES,-55-+125,BLK - Tape and Reel |
| 29F0418-0SR-10 | 功能描述:信號調節 83ohms 100MHz 6A Thru-hole RoHS:否 制造商:EPCOS 產品:Duplexers 頻率:782 MHz, 751 MHz 頻率范圍: 電壓額定值: 帶寬: 阻抗:50 Ohms 端接類型:SMD/SMT 封裝 / 箱體:2.5 mm x 2 mm 工作溫度范圍:- 30 C to + 85 C 封裝:Reel |
| 29F0418-1SR | 功能描述:FERRITE 6A 119 OHM SMD RoHS:否 類別:濾波器 >> 鐵氧體磁珠和芯片 系列:- 標準包裝:1,000 系列:EMI1812 頻率對應阻抗:120 歐姆 @ 100MHz 額定電流:200mA DC 電阻(DCR):最大 400 毫歐 濾波器類型:差模 - 單線 封裝/外殼:1812（4532 公制） 安裝類型:表面貼裝 包裝:帶卷 (TR) 高度（最大）:0.069"（1.75mm） 尺寸/尺寸:0.177" L x 0.126" W（4.50mm x 3.20mm） 其它名稱:Q1712807A |
| 29F0418-1SR (900PC RL) | 制造商:Laird Technologies Inc 功能描述:SMD,6.1X4.5MM,6A I MAX,119 OHM,GULL WING,4 LINES,-55-+125 - Tape and Reel |
| 29F0418-1SR-10 | 功能描述:EMI/RFI 抑制器及鐵氧體 119ohms 100MHz 6A Thru-hole RoHS:否 制造商:Fair-Rite 產品:Ferrite Cores 阻抗:365 Ohms 容差: 最大直流電流: 最大直流電阻: 工作溫度范圍:- 55 C to + 125 C 封裝 / 箱體: 端接類型:SMD/SMT |
發布緊急采購，3分鐘左右您將得到回復。