- 您現在的位置：買賣IC網 > PDF目錄24615 > 9148BF-36LF (INTEGRATED DEVICE TECHNOLOGY INC) 83.3 MHz, PROC SPECIFIC CLOCK GENERATOR, PDSO48 PDF資料下載
參數資料
| 型號： | 9148BF-36LF |
| 廠商： | INTEGRATED DEVICE TECHNOLOGY INC |
| 元件分類： | 時鐘產生/分配 |
| 英文描述： | 83.3 MHz, PROC SPECIFIC CLOCK GENERATOR, PDSO48 |
| 封裝： | 0.300 INCH, SSOP-48 |
| 文件頁數： | 13/18頁 |
| 文件大小： | 559K |
| 代理商： | 9148BF-36LF |
4
ICS9148-36
1.
The ICS clock generator is a slave/receiver, I2C component. It can read back the data stored in the latches for verification.
Read-BackwillsupportIntelPIIX4"Block-Read"protocol.
2.
The data transfer rate supported by this clock generator is 100K bits/sec or less (standard mode)
3.
The input is operating at 3.3V logic levels.
4.
The data byte format is 8 bit bytes.
5.
To simplify the clock generator I2C interface, the protocol is set to use only "Block-Writes" from the controller. The
bytes must be accessed in sequential order from lowest to highest byte with the ability to stop after any complete byte
has been transferred. The Command code and Byte count shown above must be sent, but the data is ignored for those
two bytes. The data is loaded until a Stop sequence is issued.
6.
At power-on, all registers are set to a default condition, as shown.
General I
2C serial interface information
The information in this section assumes familiarity with I2C programming.
For more information, contact ICS for an I2C programming application note.
How to Write:
Controller (host) sends a start bit.
Controller (host) sends the write address D2
(H)
ICS clock will acknowledge
Controller (host) sends a dummy command code
ICS clock will acknowledge
Controller (host) sends a dummy byte count
ICS clock will acknowledge
Controller (host) starts sending first byte (Byte 0)
through byte 5
ICS clock will acknowledge each byte one at a time.
Controller (host) sends a Stop bit
How to Read:
Controller (host) will send start bit.
Controler (host) sends the read address D3
(H)
ICS clock will acknowledge
ICS clock will send the byte count
Controller (host) acknowledges
ICS clock sends first byte (Byte 0) through byte 5
Controller (host) will need to acknowledge each byte
Controller (host) will send a stop bit
Notes:
Controller (Host)
ICS (Slave/Receiver)
Start Bit
Address
D3(H)
ACK
Byte Count
ACK
Byte 0
ACK
Byte 1
ACK
Byte 2
ACK
Byte 3
ACK
Byte 4
ACK
Byte 5
ACK
Stop Bit
How to Read:
Controller (Host)
ICS (Slave/Receiver)
Start Bit
Address
D2(H)
ACK
Dummy Command Code
ACK
Dummy Byte Count
ACK
Byte 0
ACK
Byte 1
ACK
Byte 2
ACK
Byte 3
ACK
Byte 4
ACK
Byte 5
ACK
Stop Bit
How to Write:
相關PDF資料 |
PDF描述 |
|---|---|
| 9148CF-10LF | 48 MHz, PROC SPECIFIC CLOCK GENERATOR, PDSO48 |
| 051-328-6909229 | RF Coaxial Connectors |
| 9148F-02LF | 66.6 MHz, PROC SPECIFIC CLOCK GENERATOR, PDSO48 |
| 9148F-32 | PROC SPECIFIC CLOCK GENERATOR, PDSO48 |
| 051-328-9399 | RF Coaxial Connectors |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 9148CF10LF | 制造商:Integrated Device Technology Inc 功能描述:PLL Clock Synthesizer Dual 48-Pin SSOP Tube |
| 9148CF-10LF | 制造商:Integrated Device Technology Inc 功能描述:PC MAIN CLOCK - Rail/Tube |
| 9148ES | 功能描述:DISCS 9148ES 5 IN COARSE 40 GRIT 制造商:3m 系列:* 零件狀態:在售 標準包裝:5 |
| 9148F-08 | 制造商:ICS 功能描述: |
| 9149 | 功能描述:電線導管 HF3C 1 BLACK 1 NPT W/NUT RoHS:否 制造商:Panduit 類型:Slotted SideWall Open finger design wiring cut 材料:Polypropylene 顏色:Light Gray 大小: 最大光束直徑: 抗拉強度: 外部導管寬度:25 mm 外部導管高度:25 mm |
發布緊急采購，3分鐘左右您將得到回復。