- 您現在的位置：買賣IC網 > PDF目錄24839 > 93725AFLF-T (INTEGRATED DEVICE TECHNOLOGY INC) 93725 SERIES, LOW SKEW CLOCK DRIVER, 6 TRUE OUTPUT(S), 0 INVERTED OUTPUT(S), PDSO48 PDF資料下載
參數資料
| 型號： | 93725AFLF-T |
| 廠商： | INTEGRATED DEVICE TECHNOLOGY INC |
| 元件分類： | 時鐘及定時 |
| 英文描述： | 93725 SERIES, LOW SKEW CLOCK DRIVER, 6 TRUE OUTPUT(S), 0 INVERTED OUTPUT(S), PDSO48 |
| 封裝： | 0.300 INCH, ROHS COMPLIANT, MO-118, SSOP-48 |
| 文件頁數： | 7/8頁 |
| 文件大小： | 94K |
| 代理商： | 93725AFLF-T |
7
ICS93725
0606A—08/01/03
1.
The ICS clock generator is a slave/receiver, I
2C component. It can read back the data stored in the latches for
verification. Read-Back will support Intel PIIX4 "Block-Read" protocol.
2.
The data transfer rate supported by this clock generator is 100K bits/sec or less (standard mode)
3.
The input is operating at 3.3V logic levels.
4.
The data byte format is 8 bit bytes.
5.
To simplify the clock generator I
2C interface, the protocol is set to use only "Block-Writes" from the controller.
The bytes must be accessed in sequential order from lowest to highest byte with the ability to stop after any
complete byte has been transferred. The Command code and Byte count shown above must be sent, but the
data is ignored for those two bytes. The data is loaded until a Stop sequence is issued.
6.
At power-on, all registers are set to a default condition, as shown.
Controller (Host)
ICS (Slave/Receiver)
Start Bit
Address
D4(H)
ACK
Dummy Command Code
ACK
Dummy Byte Count
ACK
Byte 0
ACK
Byte 1
ACK
Byte 2
ACK
Byte 3
ACK
Byte 4
ACK
Byte 5
ACK
Byte 6
ACK
Byte 7
ACK
Stop Bit
How to Write:
Controller (Host)
ICS (Slave/Receiver)
Start Bit
Address
D5(H)
ACK
Byte Count
ACK
Byte 0
ACK
Byte 1
ACK
Byte 2
ACK
Byte 3
ACK
Byte 4
ACK
Byte 5
ACK
Byte 6
ACK
Byte 7
Stop Bit
How to Read:
General I
2C serial interface information
The information in this section assumes familiarity with I
2C programming.
For more information, contact ICS for an I
2C programming application note.
How to Write:
Controller (host) sends a start bit.
Controller (host) sends the write address D4
(H)
ICS clock will acknowledge
Controller (host) sends a dummy command code
ICS clock will acknowledge
Controller (host) sends a dummy byte count
ICS clock will acknowledge
Controller (host) starts sending first byte (Byte 0)
through byte 6
ICS clock will acknowledge each byte one at a time.
Controller (host) sends a Stop bit
How to Read:
Controller (host) will send start bit.
Controller (host) sends the read address D5
(H)
ICS clock will acknowledge
ICS clock will send the byte count
Controller (host) acknowledges
ICS clock sends first byte (Byte 0) through byte 7
Controller (host) will need to acknowledge each byte
Controller (host) will send a stop bit
Notes:
相關PDF資料 |
PDF描述 |
|---|---|
| 93725AF | 93725 SERIES, LOW SKEW CLOCK DRIVER, 6 TRUE OUTPUT(S), 0 INVERTED OUTPUT(S), PDSO48 |
| 93732AFT | 93732 SERIES, PLL BASED CLOCK DRIVER, 6 TRUE OUTPUT(S), 6 INVERTED OUTPUT(S), PDSO28 |
| 93732AFLFT | 93732 SERIES, PLL BASED CLOCK DRIVER, 6 TRUE OUTPUT(S), 6 INVERTED OUTPUT(S), PDSO28 |
| 93732AF | 93732 SERIES, PLL BASED CLOCK DRIVER, 6 TRUE OUTPUT(S), 6 INVERTED OUTPUT(S), PDSO28 |
| 93732YFLFT | 93732 SERIES, PLL BASED CLOCK DRIVER, 6 TRUE OUTPUT(S), 6 INVERTED OUTPUT(S), PDSO28 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 937-260 | 功能描述:支架與墊片 Plastic Spcr .26 in Nylon White RoHS:否 制造商:Schurter 類型:Transipillar Spacers 長度:16 m 螺紋大小:M4 外徑:10 mm 材料:Nylon with Steel 電鍍:Zinc |
| 937269-000 | 制造商:TE Connectivity 功能描述:PTD-75-L-03 |
| 937269-2 | 制造商:TE Connectivity 功能描述:MINI APPL - Bulk |
| 937-270 | 功能描述:Round Spacer Unthreaded Nylon 0.270" (6.86mm) Natural 制造商:bivar inc. 系列:900 零件狀態:有效 類型:圓形墊片 有絲/無絲:無螺紋 公母:母頭，母頭 螺釘，螺紋規格:- 直徑 - 內部:0.090"（2.29mm） 直徑 - 外部:0.125"（3.18mm） 1/8" 板間高度:0.270"（6.86mm） 長度 - 總:0.270"（6.86mm） 特性:- 材料:尼龍 鍍層:- 顏色:自然色 重量:- 標準包裝:1,000 |
| 937270A | 制造商:Honeywell / Clarostat 功能描述:3450RC 04780011 |
發布緊急采購，3分鐘左右您將得到回復。