參數資料
型號: 93735AFLF
廠商: INTEGRATED DEVICE TECHNOLOGY INC
元件分類: 時鐘及定時
英文描述: 93735 SERIES, PLL BASED CLOCK DRIVER, 10 TRUE OUTPUT(S), 0 INVERTED OUTPUT(S), PDSO48
封裝: 0.300 INCH, ROHS COMPLIANTS, MO-118, SSOP-48
文件頁數: 3/9頁
文件大?。?/td> 155K
代理商: 93735AFLF
IDTTM/ICSTM Low Cost DDR Phase Lock Loop Zero Delay Buffer
ICS93735
REV F 02/11/07
ICS93735
Low Cost DDR Phase Lock Loop Zero Delay Buffer
1.
The ICS clock generator is a slave/receiver, I
2C component. It can read back the data stored in the latches for verification.
Read-Back will support Intel PIIX4 "Block-Read" protocol.
2.
The data transfer rate supported by this clock generator is 100K bits/sec or less (standard mode)
3.
The input is operating at 3.3V logic levels.
4.
The data byte format is 8 bit bytes.
5.
To simplify the clock generator I
2C interface, the protocol is set to use only "Block-Writes" from the controller. The bytes
must be accessed in sequential order from lowest to highest byte with the ability to stop after any complete byte has been
transferred. The Command code and Byte count shown above must be sent, but the data is ignored for those two bytes.
The data is loaded until a Stop sequence is issued.
6.
At power-on, all registers are set to a default condition, as shown.
Controller (Host)
ICS (Slave/Receiver)
Start Bit
Address
D4(H)
ACK
Dummy Command Code
ACK
Dummy Byte Count
ACK
Byte 0
ACK
Byte 1
ACK
Byte 2
ACK
Byte 3
ACK
Byte 4
ACK
Byte 5
ACK
Byte 6
ACK
Byte 7
ACK
Stop Bit
How to Write:
Controller (Host)
ICS (Slave/Receiver)
Start Bit
Address
D5(H)
ACK
Byte Count
ACK
Byte 0
ACK
Byte 1
ACK
Byte 2
ACK
Byte 3
ACK
Byte 4
ACK
Byte 5
ACK
Byte 6
ACK
Byte 7
Stop Bit
How to Read:
General I
2C serial interface information
The information in this section assumes familiarity with I
2C programming.
For more information, contact ICS for an I
2C programming application note.
How to Write:
Controller (host) sends a start bit.
Controller (host) sends the write address D4
(H)
ICS clock will
acknowledge
Controller (host) sends a dummy command code
ICS clock will
acknowledge
Controller (host) sends a dummy byte count
ICS clock will
acknowledge
Controller (host) starts sending first byte (Byte 0)
through byte 6
ICS clock will
acknowledge each byte one at a
time.
Controller (host) sends a Stop bit
How to Read:
Controller (host) will send start bit.
Controller (host) sends the read address D5
(H)
ICS clock will
acknowledge
ICS clock will send the
byte count
Controller (host) acknowledges
ICS clock sends first byte
(Byte 0) through byte
7
Controller (host) will need to acknowledge each
byte
Controller (host) will send a stop bit
Notes:
相關PDF資料
PDF描述
93735AF 93735 SERIES, PLL BASED CLOCK DRIVER, 10 TRUE OUTPUT(S), 0 INVERTED OUTPUT(S), PDSO48
9374PC LED DISPLAY DRIVER, DIP16
939 WIRE TERMINAL
968 WIRE TERMINAL
969 WIRE TERMINAL
相關代理商/技術參數
參數描述
937-375 功能描述:支架與墊片 Plastic Spcr .375 in Nylon White RoHS:否 制造商:Schurter 類型:Transipillar Spacers 長度:16 m 螺紋大小:M4 外徑:10 mm 材料:Nylon with Steel 電鍍:Zinc
937376-1 制造商:TE Connectivity 功能描述:STUFFER - Bulk
937377-1 功能描述:FEEDER,CONN.HOLDER 制造商:te connectivity amp connectors 系列:* 零件狀態:有效 標準包裝:1
937378-1 功能描述:手工工具 PLATE SPRING (MINI CT P-TOOL) RoHS:否 制造商:Molex 產品:Extraction Tools 類型: 描述/功能:Extraction tool
937383-1 功能描述:手工工具 HOLDER CONN RoHS:否 制造商:Molex 產品:Extraction Tools 類型: 描述/功能:Extraction tool