- 您現在的位置：買賣IC網 > PDF目錄8933 > AD5410ACPZ-REEL7 (Analog Devices Inc)IC DAC 12BIT SRL 40LFCSP PDF資料下載
參數資料
| 型號： | AD5410ACPZ-REEL7 |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 22/32頁 |
| 文件大小： | 0K |
| 描述： | IC DAC 12BIT SRL 40LFCSP |
| 設計資源： | Simplified 12-Bit, 4 mA-to-20 mA Output Solution Using AD5410 (CN0081) |
| 標準包裝： | 1 |
| 設置時間： | 40µs |
| 位數： | 12 |
| 數據接口： | DSP，MICROWIRE?，QSPI?，串行，SPI? |
| 轉換器數目： | 1 |
| 電壓電源： | 模擬和數字 |
| 功率耗散（最大）： | 950mW |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 40-VFQFN 裸露焊盤，CSP |
| 供應商設備封裝： | 40-LFCSP-VQ（6x6） |
| 包裝： | 標準包裝 |
| 輸出數目和類型： | 1 電流，單極 |
| 采樣率（每秒）： | * |
| 其它名稱： | AD5410ACPZ-REEL7DKR |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁當前第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁
Data Sheet
AD5410/AD5420
Rev. F | Page 29 of 32
INDUSTRIAL, HART COMPATIBLE ANALOG
OUTPUT APPLICATION
Many industrial control applications have requirements for
accurately controlled current output signals, and the AD5410/
AD5420 are ideal for such applications. Figure 55 shows the
cifically for use in an industrial control application. The design
provides for a HART-enabled current output, with the HART
capability provided by the AD5700/AD5700-1 HART modem, the
industry’s lowest power and smallest footprint HART-compliant IC
modem. For additional space-savings, the AD5700-1 offers a 0.5%
precision internal oscillator. The HART_OUT signal from the
AD5700 is attenuated and ac-coupled into the CAP2 pin of the
AD5420. Further information on this configuration can be found
in Application Note AN-1065. An alternative method of coupling
the HART signal into the RSET pin (only applicable of the external
RSET is used), is available in Circuit Note CN-0270. Use of
either configuration results in the AD5700 HART modem output
modulating the 4 mA to 20 mA analog current without affecting
the dc level of the current. This circuit adheres to the HART
physical layer specifications as defined by the HART
Communication Foundation.
The module is powered from a field supply of 24 V. This supplies
AVDD directly. For transient overvoltage protection, transient
voltage suppressors (TVS) are placed on both the IOUT and field
supply connections. A 24 V TVS is placed on the IOUT connection,
and a 36 V TVS is placed on the field supply input. For added
protection, clamping diodes are connected from the IOUT pin to the
AVDD and GND power supply pins. The recommended external
band-pass filter for the AD5700 HART modem includes a 150 kΩ
resistor, which limits current to a sufficiently low level to adhere
to intrinsic safety requirements. In this case, the input has higher
transient voltage protection and should, therefore, not require
additional protection circuitry, even in the most demanding of
industrial environments.
circuitry is provided with the ADuM1400 and ADuM1200
iCoupler digital isolators; further information on iCoupler
products is available at www.analog.com. The internally generated
side of the digital isolators, removing the need to generate a
digital power supply on the field side of the isolation barrier.
The AD5410/AD5420 digital supply out-put supplies up to 5 mA,
which is more than enough to supply the 2.8 mA requirement
of the ADuM1400 and ADuM1200 operating at a logic signal
frequency of up to 1 MHz. To reduce the number of isolators
required, nonessential signals such as CLEAR can be connected
to GND and FAULT, and SDO can be left unconnected, reducing
the isolation requirements to just three signals. Doing so,
however, disables the fault alert features of the part.
07027-
048
DVCC
AVDD
IOUT
DVCC
SELECT
CAP1
GND
CAP2
REFOUT REFIN
CLEAR
LATCH
SCLK
SDIN
FAULT
SDO
AD5700/AD5700-1
AD5410/AD5420
10F
0.1F
BACKP
L
ANE
I
NT
E
RF
ACE
BACKPLANE SUPPLY
IOUT
C3
0.1F
10k
1F
150pF
18
+
VDD1
VDD2
GND2
GND1
VIA
VIB
VOA
VOB
ADuM1200
VDD2
GND1
VIA
NC
GND1
VIC
VID
VIB
VOA
VOC
VOD
VOB
GND2
VE2
GND2
ADuM1400
VDD1
MICROCONTROLLER
DIGITAL
OUTPUTS
DIGITAL
INTPUTS
UART
INTERFACE
VDD2
GND1
VIA
VE1
GND1
VOC
VIB
VOA
VIC
VID
VOB
GND2
VE2
GND2
ADuM1402
VDD1
HART_OUT
TXD
RTS
RXD
CD
REF
ADC_IP
VCC
DGND
AGND
0.1F
C1
2.2nF
C2
22nF
AVDD
24V
FIELD
SUPPLY
FIELD
GROUND
SMAJ36CA
36V
150k
1.2M
300pF
相關PDF資料 |
PDF描述 |
|---|---|
| VI-252-MY-F3 | CONVERTER MOD DC/DC 15V 50W |
| VI-B6M-MV-F4 | CONVERTER MOD DC/DC 10V 150W |
| VI-B6M-MV-F2 | CONVERTER MOD DC/DC 10V 150W |
| VI-251-MY-F2 | CONVERTER MOD DC/DC 12V 50W |
| VI-B6M-MV-F1 | CONVERTER MOD DC/DC 10V 150W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD5410AREZ | 功能描述:IC DAC 12BIT 1CH SER 24TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:50 系列:- 設置時間:4µs 位數:12 數據接口:串行 轉換器數目:2 電壓電源:單電源 功率耗散（最大）:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-TSSOP，8-MSOP（0.118"，3.00mm 寬） 供應商設備封裝:8-uMAX 包裝:管件 輸出數目和類型:2 電壓，單極 采樣率（每秒）:* 產品目錄頁面:1398 (CN2011-ZH PDF) |
| AD5410AREZ-REEL7 | 功能描述:IC DAC 12BIT 1CH SER 24TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 產品培訓模塊:LTC263x 12-, 10-, and 8-Bit VOUT DAC Family 特色產品:LTC2636 - Octal 12-/10-/8-Bit SPI VOUT DACs with 10ppm/°C Reference 標準包裝:91 系列:- 設置時間:4µs 位數:10 數據接口:MICROWIRE?，串行，SPI? 轉換器數目:8 電壓電源:單電源 功率耗散（最大）:2.7mW 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-WFDFN 裸露焊盤 供應商設備封裝:14-DFN-EP（4x3） 包裝:管件 輸出數目和類型:8 電壓，單極 采樣率（每秒）:* |
| AD5412 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Low Power HART Modem |
| AD5412_09 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Single Channel, 12-/16-Bit, Serial Input, Current Source and Voltage Output DACs |
| AD5412ACPZ | 制造商:Analog Devices 功能描述:DAC 1-CH Segment 12-bit 40-Pin LFCSP EP |
發布緊急采購，3分鐘左右您將得到回復。