- 您現在的位置：買賣IC網 > PDF目錄8555 > AD5516ABCZ-1 (Analog Devices Inc)IC DAC 12BIT 16CH 74-CSPBGA PDF資料下載
參數資料
| 型號： | AD5516ABCZ-1 |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 4/16頁 |
| 文件大小： | 0K |
| 描述： | IC DAC 12BIT 16CH 74-CSPBGA |
| 標準包裝： | 1 |
| 設置時間： | 32µs |
| 位數： | 12 |
| 數據接口： | DSP，MICROWIRE?，QSPI?，串行，SPI? |
| 轉換器數目： | 16 |
| 電壓電源： | 模擬和數字 |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 74-LBGA，CSPBGA |
| 供應商設備封裝： | 74-CSPBGA（12x12） |
| 包裝： | * |
| 輸出數目和類型： | * |
| 采樣率（每秒）： | 750k |
REV. B
–12–
AD5516
A data transfer is initiated by writing a word to the TX Register
after the SPORT has been enabled. In write sequences, data is
clocked out on each rising edge of the DSP’s serial clock and
clocked into the AD5516 on the falling edge of its SCLK. The
SPORT transmit control register should be set up as follows:
DTYPE
=
00, Right Justify Data
ICLK
=
1, Internal Serial Clock
TFSR
=
1, Frame Every Word
INTF
=
1, Internal Frame Sync
LTFS
=
1, Active Low Frame Sync Signal
LAFS
=
0, Early Frame Sync
SENDN =
0, Data Transmitted MSB First
SLEN
=
10011, 18-Bit Data-Words (SLEN = Serial Word)
Figure 6 shows the connection diagram.
AD5516*
ADSP-2106x*
SYNC
DIN
SCLK
TFS
DT
SCLK
*ADDITIONAL PINS OMITTED FOR CLARITY
Figure 6. AD5516 to ADSP-2106x Interface
AD5516 to MC68HC11
The serial peripheral interface (SPI) on the MC68HC11 is
configured for Master Mode (MSTR = 1), Clock Polarity Bit
(CPOL) = 0, and the Clock Phase Bit (CPHA) = 1. The SPI is
configured by writing to the SPI Control Register (SPCR)—see
the 68HC11 User Manual. SCK of the 68HC11 drives the SCLK
of the AD5516, the MOSI output drives the serial data line
(DIN) of the AD5516. The SYNC signal is derived from a port
line (PC7). When data is being transmitted to the AD5516, the
SYNC line is taken low (PC7). Data appearing on the MOSI
output is valid on the falling edge of SCK. Serial data from the
68HC11 is transmitted in 8-bit bytes with only eight falling
clock edges occurring in the transmit cycle. Data is transmitted
MSB first. In order to transmit 18 data bits, it is important to
left justify the data in the SPDR Register. PC7 must be pulled
low to start a transfer and taken high and low again before any
further read/write cycles can take place. A connection diagram is
shown in Figure 7.
AD5516*
MC68HC11*
SYNC
SCLK
DIN
PC7
SCK
MOSI
*ADDITIONAL PINS OMITTED FOR CLARITY
Figure 7. AD5516 to MC68HC11 Interface
AD5516 to PIC16C6x/7x
The PIC16C6x/7x synchronous serial port (SSP) is configured
as an SPI master with the Clock Polarity Bit (CKP) = 0. This is
done by writing to the Synchronous Serial Port Control Register
(SSPCON). See the PIC16/17 Microcontroller User Manual. In this
example, I/O port RA1 is being used to provide a
SYNC signal
and enable the serial port of the AD5516. This microcontroller
transfers only eight bits of data during each serial transfer opera-
tion; therefore, three consecutive write operations are required.
Figure 8 shows the connection diagram.
AD5516*
PIC16C6x/7x*
SCLK
DIN
SYNC
SCK/RC3
SDI/RC4
RA1
*ADDITIONAL PINS OMITTED FOR CLARITY
Figure 8. AD5516 to PIC16C6x/7x Interface
AD5516 to 8051
A serial interface between the AD5516 and the 80C51/80L51
microcontroller is shown in Figure 9. The AD5516 requires a
clock synchronized to the serial data. The 8051 serial interface
must therefore be operated in Mode 0. TxD of the microcon-
troller drives the SCLK of the AD5516, while RxD drives the
serial data line. P1.1 is a bit programmable pin on the serial port
that is used to drive
SYNC. The 80C51/80L51 provides the
LSB first, while the AD5516 expects MSB of the 18-bit word
first. Care should be taken to ensure the transmit routine takes
this into account.
AD5516*
8051*
SCLK
DIN
SYNC
TxD
RxD
P1.1
*ADDITIONAL PINS OMITTED FOR CLARITY
Figure 9. AD5516 to 8051 Interface
When data is to be transmitted to the DAC, P1.1 is taken low.
Data on RxD is valid on the falling edge of TxD, so the clock
must be inverted as the AD5516 clocks data into the input shift
register on the rising edge of the serial clock. The 80C51/80L51
transmits its data in 8-bit bytes with only eight falling clock edges
occurring in the transmit cycle. As the DAC requires an 18-bit
word, P1.1 must be left low after the first eight bits are transferred
and brought high after the complete 18 bits have been transferred.
DOUT may be tied to RxD for data verification purposes when
the device is in Daisy-Chain Mode.
相關PDF資料 |
PDF描述 |
|---|---|
| VE-B52-MU-S | CONVERTER MOD DC/DC 15V 200W |
| VE-JW4-MZ-B1 | CONVERTER MOD DC/DC 48V 25W |
| VE-J2Z-MZ-B1 | CONVERTER MOD DC/DC 2V 10W |
| VE-B51-MU-S | CONVERTER MOD DC/DC 12V 200W |
| DAC8412EP | IC DAC 12BIT QUAD V-OUT 28-DIP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD5516ABCZ-2 | 功能描述:IC DAC 12BIT VOUT 16CH 74-CSPBGA RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1,000 系列:- 設置時間:1µs 位數:8 數據接口:串行 轉換器數目:8 電壓電源:雙 ± 功率耗散（最大）:941mW 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:24-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:24-SOIC W 包裝:帶卷 (TR) 輸出數目和類型:8 電壓，單極 采樣率（每秒）:* |
| AD5516ABCZ-3 | 功能描述:IC DAC 12BIT 16CH BIPO 74-CSPBGA RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 標準包裝:1 系列:- 設置時間:4.5µs 位數:12 數據接口:串行，SPI? 轉換器數目:1 電壓電源:單電源 功率耗散（最大）:- 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:8-SOICN 包裝:剪切帶 (CT) 輸出數目和類型:1 電壓，單極；1 電壓，雙極 采樣率（每秒）:* 其它名稱:MCP4921T-E/SNCTMCP4921T-E/SNRCTMCP4921T-E/SNRCT-ND |
| AD5520 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Per Pin Parametric Measurement Unit/Source Measure Unit |
| AD5520JST | 制造商:Analog Devices 功能描述:Parametric Measurement Unit 64-Pin LQFP 制造商:Rochester Electronics LLC 功能描述:CHANNEL PARAMETRIC MEASUREMENT UNIT IC - Tape and Reel 制造商:Analog Devices 功能描述:PARAMETRMEASUREMENT UNIT SMD 5520 |
| AD5520JST-REEL | 制造商:Analog Devices 功能描述:Parametric Measurement Unit 64-Pin LQFP T/R |
發布緊急采購，3分鐘左右您將得到回復。