參數資料
型號: AD5624BRMZ
廠商: Analog Devices Inc
文件頁數: 7/24頁
文件大?。?/td> 0K
描述: IC DAC NANO 12BIT QUAD 10-MSOP
產品培訓模塊: Data Converter Fundamentals
DAC Architectures
標準包裝: 50
系列: nanoDAC™
設置時間: 3µs
位數: 12
數據接口: DSP,MICROWIRE?,QSPI?,串行,SPI?
轉換器數目: 4
電壓電源: 單電源
工作溫度: -40°C ~ 105°C
安裝類型: 表面貼裝
封裝/外殼: 10-TFSOP,10-MSOP(0.118",3.00mm 寬)
供應商設備封裝: 10-MSOP
包裝: 管件
輸出數目和類型: 4 電壓,單極;4 電壓,雙極
采樣率(每秒): 287k
產品目錄頁面: 783 (CN2011-ZH PDF)
AD5624/AD5664
Rev. 0 | Page 15 of 24
THEORY OF OPERATION
D/A SECTION
The AD5624/AD5664 DACs are fabricated on a CMOS process.
The architecture consists of a string DAC followed by an output
buffer amplifier. Figure 29 shows a block diagram of the DAC
architecture.
DAC
REGISTER
RESISTOR
STRING
REF (+)
VDD
GND
REF (–)
VOUT
OUTPUT
AMPLIFIER
(GAIN = +2)
0
594
3-
0
32
Figure 29. DAC Architecture
Since the input coding to the DAC is straight binary, the ideal
output voltage is given by
×
=
N
REFIN
OUT
D
V
2
where:
D is the decimal equivalent of the binary code that is loaded to
the DAC register:
0 to 4095 for AD5624 (12 bit).
0 to 65535 for AD5664 (16 bit).
N is the DAC resolution.
RESISTOR STRING
The resistor string is shown in Figure 30. It is simply a string of
resistors, each of value R. The code loaded to the DAC register
determines at which node on the string the voltage is tapped off
to be fed into the output amplifier. The voltage is tapped off by
closing one of the switches connecting the string to the
amplifier. Because it is a string of resistors, it is guaranteed
monotonic.
OUTPUT AMPLIFIER
The output buffer amplifier can generate rail-to-rail voltages on
its output, which gives an output range of 0 V to VDD. It can drive
a load of 2 kΩ in parallel with 1000 pF to GND. The source and
sink capabilities of the output amplifier can be seen in Figure 17.
The slew rate is 1.8 V/μs with a to full-scale settling time of
7 μs.
R
TO OUTPUT
AMPLIFIER
0
59
43
-0
33
Figure 30. Resistor String
SERIAL INTERFACE
The AD5624/AD5664 have a 3-wire serial interface (SYNC,
SCLK, and DIN) that is compatible with SPI, QSPI, and
MICROWIRE interface standards as well as with most DSPs.
See Figure 2 for a timing diagram of a typical write sequence.
The write sequence begins by bringing the SYNC line low. Data
from the DIN line is clocked into the 24-bit shift register on the
falling edge of SCLK. The serial clock frequency can be as high
as 50 MHz, making the AD5624/AD5664 compatible with high
speed DSPs. On the 24th falling clock edge, the last data bit is
clocked in and the programmed function is executed, that is, a
change in DAC register contents and/or a change in the mode
of operation. At this stage, the SYNC line can be kept low or be
brought high. In either case, it must be brought high for a
minimum of 15 ns before the next write sequence so that a
falling edge of SYNC can initiate the next write sequence. Since
the SYNC buffer draws more current when VIN = 2.0 V than it
does when VIN = 0.8 V, SYNC should be idled low between
write sequences for even lower power operation. It must,
however, be brought high again just before the next write
sequence.
相關PDF資料
PDF描述
ICS87004AGLFT IC CLOCK GEN ZD 1:4 24-TSSOP
VI-J4J-MZ-F2 CONVERTER MOD DC/DC 36V 25W
VI-BNP-MV-F4 CONVERTER MOD DC/DC 13.8V 150W
VI-BNP-MV-F3 CONVERTER MOD DC/DC 13.8V 150W
AD5318ARUZ IC DAC 10BIT OCTAL W/BUF 16TSSOP
相關代理商/技術參數
參數描述
AD5624BRMZ 制造商:Analog Devices 功能描述:12BIT DAC NANO QUAD SMD MSOP10
AD5624BRMZ 制造商:Analog Devices 功能描述:D/A Converter (D-A) IC
AD5624BRMZ-REEL7 功能描述:IC DAC 12BIT QUAD 10 MSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:nanoDAC™ 產品培訓模塊:LTC263x 12-, 10-, and 8-Bit VOUT DAC Family 特色產品:LTC2636 - Octal 12-/10-/8-Bit SPI VOUT DACs with 10ppm/°C Reference 標準包裝:91 系列:- 設置時間:4µs 位數:10 數據接口:MICROWIRE?,串行,SPI? 轉換器數目:8 電壓電源:單電源 功率耗散(最大):2.7mW 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-WFDFN 裸露焊盤 供應商設備封裝:14-DFN-EP(4x3) 包裝:管件 輸出數目和類型:8 電壓,單極 采樣率(每秒):*
AD5624R 制造商:AD 制造商全稱:Analog Devices 功能描述:Quad, 12-/14-/16-Bit nanoDACs with 5 ppm/C On-Chip Reference
AD5624RBCPZ-3R2 功能描述:IC DAC NANO 12BIT 1.25V 10-LFCSP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:nanoDAC™ 標準包裝:47 系列:- 設置時間:2µs 位數:14 數據接口:并聯 轉換器數目:1 電壓電源:單電源 功率耗散(最大):55µW 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:28-SSOP(0.209",5.30mm 寬) 供應商設備封裝:28-SSOP 包裝:管件 輸出數目和類型:1 電流,單極;1 電流,雙極 采樣率(每秒):*