- 您現在的位置：買賣IC網 > PDF目錄10545 > AD7265BSUZ (Analog Devices Inc)IC ADC 12BIT 3CHAN 1MSPS 32TQFP PDF資料下載
參數資料
| 型號： | AD7265BSUZ |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 16/29頁 |
| 文件大小： | 0K |
| 描述： | IC ADC 12BIT 3CHAN 1MSPS 32TQFP |
| 設計資源： | AD7265 in Differential and Single-Ended Configurations Using AD8022 (CN0048) |
| 標準包裝： | 1 |
| 位數： | 12 |
| 采樣率（每秒）： | 1M |
| 數據接口： | DSP，MICROWIRE?，QSPI?，串行，SPI? |
| 轉換器數目： | 2 |
| 功率耗散（最大）： | 21mW |
| 電壓電源： | 模擬和數字 |
| 工作溫度： | -40°C ~ 125°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 32-TQFP |
| 供應商設備封裝： | 32-TQFP（7x7） |
| 包裝： | 托盤 |
| 輸入數目和類型： | 12 個單端，單極；6 個差分，單極；6 個偽差分，單極 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁當前第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁
AD7265
Rev. A | Page 22 of 28
SERIAL INTERFACE
A minimum of 14 serial clock cycles are required to perform
the conversion process and to access data from one conversion
on either data line of the AD7265.
Figure 41 shows the detailed timing diagram for serial inter-
facing to the AD7265. The serial clock provides the conversion
clock and controls the transfer of information from the AD7265
during conversion.
CS going low provides the
leading zero to be read in by the microcontroller or DSP. The
remaining data is then clocked out by subsequent SCLK falling
edges, beginning with a second leading zero. Therefore, the first
falling clock edge on the serial clock has the leading zero pro-
vided and also clocks out the second leading zero. The 12-bit
result then follows with the final bit in the data transfer valid on
the 14
CS
The
signal initiates the data transfer and conversion process.
The falling edge of CS puts the track-and-hold into hold mode,
at which point the analog input is sampled and the bus is taken
out of three-state. The conversion is also initiated at this point
and requires a minimum of 14 SCLKs to complete. Once 13
SCLK falling edges have elapsed, the track-and-hold goes back
into track on the next SCLK rising edge, as shown in
th falling edge, having being clocked out on the previous
(13th) falling edge. It may also be possible to read in data on
each SCLK rising edge depending on the SCLK frequency or
the supply voltage. The first rising edge of SCLK after the
at Point B. If a 16-SCLK transfer is used, then two trailing zeros
will appear after the final LSB. On the rising edge of
CS
falling edge would have the second leading zero provided, and
the 13
CS, the
conversion is terminated and DOUTA and DOUTB go back into
three-state. If
th rising SCLK edge would have DB0 provided.
CS is not brought high but is instead held low for
a further 14 (or 16) SCLK cycles on D
Note that with fast SCLK values, and thus short SCLK periods,
in order to allow adequately for t
OUT
A, the data from Con-
version B is output on DOUTA (followed by 2 trailing zeros).
2
, an SCLK rising edge may
occur before the first SCLK falling edge. This rising edge of
SCLK can be ignored for the purposes of the timing descriptions in
this section. If a falling edge of SCLK is coincident with the
falling edge of
CS
Likewise, if
is held low for a further 14 (or 16) SCLK cycles
on D
B, the data from Conversion A is output on D
OUT
B. This
this case, the D
CS, then this falling edge of SCLK is not
acknowledged by the AD7265, and the next falling edge of
SCLK will be the first registered after the falling edge of
OUT
line in use goes back into three-state on the
32nd SCLK falling edge or the rising edge of CS, whichever
occurs first.
CS.
CS
SCLK
1
5
13
DOUTA
DOUTB
2 LEADING ZEROS
THREE-
STATE
t4
2
34
t5
t3
tQUIET
t2
THREE-STATE
DB11
DB10
DB2
DB0
t6
t7
t8
0
DB1
B
DB9
DB8
t9
04674-034
Figure 41. Serial Interface Timing Diagram
CS
SCLK
1
5
15
DOUTA
THREE-
STATE
t4
2
34
16
t5
t3
t2
THREE-
STATE
t6
t7
14
ZERO
0
ZERO
DB11B
17
2 LEADING ZEROS
t10
32
DB11A
2 LEADING
ZEROS
DB10A
DB9A
ZERO
2 TRAILING ZEROS
ZERO
2 TRAILING ZEROS
04674-035
Figure 42. Reading Data from Both ADCs on One D
Line with 32 SCLKs
OUT
相關PDF資料 |
PDF描述 |
|---|---|
| VE-J13-MY-F2 | CONVERTER MOD DC/DC 24V 50W |
| IDT82P2282PFG | IC TXRX T1/J1/E1 2CH 100TQFP |
| IDT82P2281PFG | TXRX T1/E1/J1 LONG/SHORT 80-TQFP |
| VE-J12-MY-F2 | CONVERTER MOD DC/DC 15V 50W |
| LTC2498CUHF#PBF | IC ADC 24BIT 16CH 38-QFN |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD7265BSUZ-REEL | 功能描述:IC ADC 12BIT 3CHAN 1MSPS 32TQFP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:2,500 系列:- 位數:16 采樣率（每秒）:15 數據接口:MICROWIRE?，串行，SPI? 轉換器數目:1 功率耗散（最大）:480µW 電壓電源:單電源 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:38-WFQFN 裸露焊盤 供應商設備封裝:38-QFN（5x7） 包裝:帶卷 (TR) 輸入數目和類型:16 個單端，雙極；8 個差分，雙極 配用:DC1011A-C-ND - BOARD DELTA SIGMA ADC LTC2494 |
| AD7265BSUZ-REEL7 | 功能描述:IC ADC 12BIT 3CHAN 1MSPS 32TQFP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
| AD7266 | 制造商:Analog Devices 功能描述:- Bulk |
| AD7266ACP | 制造商:Analog Devices 功能描述:ADC DUAL SAR 2MSPS 12-BIT SERL 32LFCSP - Bulk |
| AD7266ASU | 制造商:Analog Devices 功能描述:ADC DUAL SAR 2MSPS 12-BIT SERL 32TQFP - Bulk |
發布緊急采購，3分鐘左右您將得到回復。