參數資料
型號: AD7691BCPZRL7
廠商: Analog Devices Inc
文件頁數: 10/28頁
文件大小: 0K
描述: IC ADC 18BIT SAR 250KSPS 10LFCSP
標準包裝: 1
系列: PulSAR®
位數: 18
采樣率(每秒): 250k
數據接口: DSP,MICROWIRE?,QSPI?,串行,SPI?
轉換器數目: 1
功率耗散(最大): 12.5mW
電壓電源: 模擬和數字
工作溫度: -40°C ~ 85°C
安裝類型: 表面貼裝
封裝/外殼: 10-WFDFN 裸露焊盤,CSP
供應商設備封裝: 10-LFCSP-WD(3x3)
包裝: 標準包裝
輸入數目和類型: 1 個差分,雙極
其它名稱: AD7691BCPZRL7DKR
AD7691
Data Sheet
Rev. C | Page 18 of 28
CS MODE, 3-WIRE WITHOUT BUSY INDICATOR
This mode is usually used when a single AD7691 is connected
to an SPI-compatible digital host. The connection diagram is
shown in Figure 35, and the corresponding timing is given in
With SDI tied to VIO, a rising edge on CNV initiates a
conversion, selects the CS mode, and forces SDO to high
impedance. Once a conversion is initiated, it continues until
completion irrespective of the state of CNV. This can be useful,
for instance, to bring CNV low to select other SPI devices, such
as analog multiplexers, but CNV must be returned high before
the minimum conversion time elapses and then held high for
the maximum possible conversion time to avoid the generation
of the busy signal indicator. When the conversion is complete,
the AD7691 enters the acquisition phase and powers down.
When CNV goes low, the MSB is output onto SDO. The
remaining data bits are clocked by subsequent SCK falling
edges. The data is valid on both SCK edges. Although the rising
edge can be used to capture the data, a digital host using the
SCK falling edge can allow a faster reading rate, provided it has
an acceptable hold time. After the 18th SCK falling edge, or
when CNV goes high, whichever occurs first, SDO returns to
high impedance.
CNV
SCK
SDO
SDI
DATA IN
CLK
CONVERT
VIO
DIGITAL HOST
AD7691
06
14
6-
0
11
Figure 35. 3-Wire CS Mode Without Busy Indicator
Connection Diagram (SDI High)
SDO
D17
D16
D15
D1
D0
tDIS
SCK
123
16
17
18
tSCK
tSCKL
tSCKH
tHSDO
tDSDO
CNV
CONVERSION
ACQUISITION
tCONV
tCYC
ACQUISITION
SDI = 1
tCNVH
tACQ
tEN
06
14
6-
0
12
Figure 36. 3-Wire CS Mode Without Busy Indicator Serial Interface Timing (SDI High)
相關PDF資料
PDF描述
AD7693BRMZRL7 IC ADC 16BIT 500KSPS 10-MSOP
AD7694ARMZ IC ADC 16BIT SAR 250KSPS 8MSOP
AD7699BCPZRL7 IC ADC 8CH 16BIT 500KSPS 20LFCSP
AD7701BN IC ADC 16BIT LC2MOS MONO 20-DIP
AD7703BN IC ADC 20BIT LC2MOS 20-DIP
相關代理商/技術參數
參數描述
AD7691BRMZ 功能描述:IC ADC 18BIT SAR 250KSPS 10-MSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:PulSAR® 標準包裝:1 系列:microPOWER™ 位數:8 采樣率(每秒):1M 數據接口:串行,SPI? 轉換器數目:1 功率耗散(最大):- 電壓電源:模擬和數字 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-VQFN 裸露焊盤(4x4) 包裝:Digi-Reel® 輸入數目和類型:8 個單端,單極 產品目錄頁面:892 (CN2011-ZH PDF) 其它名稱:296-25851-6
AD7691BRMZ-RL7 功能描述:IC ADC 18BIT SAR 250KSPS 10-MSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:PulSAR® 標準包裝:1,000 系列:- 位數:12 采樣率(每秒):300k 數據接口:并聯 轉換器數目:1 功率耗散(最大):75mW 電壓電源:單電源 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:24-SOIC(0.295",7.50mm 寬) 供應商設備封裝:24-SOIC 包裝:帶卷 (TR) 輸入數目和類型:1 個單端,單極;1 個單端,雙極
AD7693 制造商:AD 制造商全稱:Analog Devices 功能描述:16-Bit Lower Power
AD76931 制造商:AD 制造商全稱:Analog Devices 功能描述:18-Bit, 2 MSPS PulSAR 15 mW ADC in LFCSP (QFN)
AD7693BCPZ 制造商:Analog Devices 功能描述:ADC SGL SAR 500KSPS 16BIT SERL 10LFCSP - Rail/Tube