參數資料
型號: AD7691BCPZRL
廠商: Analog Devices Inc
文件頁數: 13/28頁
文件大?。?/td> 0K
描述: IC ADC 18BIT SAR 250KSPS 10LFCSP
標準包裝: 5,000
系列: PulSAR®
位數: 18
采樣率(每秒): 250k
數據接口: DSP,MICROWIRE?,QSPI?,串行,SPI?
轉換器數目: 1
功率耗散(最大): 12.5mW
電壓電源: 模擬和數字
工作溫度: -40°C ~ 85°C
安裝類型: 表面貼裝
封裝/外殼: 10-WFDFN 裸露焊盤,CSP
供應商設備封裝: 10-LFCSP-WD(3x3)
包裝: 帶卷 (TR)
輸入數目和類型: 1 個差分,雙極
配用: EVAL-AD7691CBZ-ND - BOARD EVALUATION FOR AD7691CBZ
AD7691
Data Sheet
Rev. C | Page 20 of 28
CS MODE, 4-WIRE WITHOUT BUSY INDICATOR
This mode is usually used when multiple AD7691s are
connected to an SPI-compatible digital host.
A connection diagram example using two AD7691s is shown in
Figure 39, and the corresponding timing is given in Figure 40.
With SDI high, a rising edge on CNV initiates a conversion,
selects the CS mode, and forces SDO to high impedance. In this
mode, CNV must be held high during the conversion phase and
the subsequent data readback. (If SDI and CNV are low, SDO is
driven low.) Prior to the minimum conversion time, SDI can be
used to select other SPI devices, such as analog multiplexers,
but SDI must be returned high before the minimum conversion
time elapses and then held high for the maximum possible
conversion time to avoid the generation of the busy signal
indicator. When the conversion is complete, the AD7691 enters
the acquisition phase and powers down. Each ADC result can
be read by bringing its SDI input low, which consequently
outputs the MSB onto SDO. The remaining data bits are clocked
by subsequent SCK falling edges. The data is valid on both SCK
edges. Although the rising edge can be used to capture the data,
a digital host using the SCK falling edge allows a faster reading
rate, provided it has an acceptable hold time. After the 18th SCK
falling edge, or when SDI goes high, whichever occurs first, SDO
returns to high impedance and another AD7691 can be read.
DATA IN
CLK
CS1
CONVERT
CS2
DIGITAL HOST
CNV
SCK
SDO
SDI
CNV
SCK
SDO
SDI
AD7691
06
14
6-
0
1
5
Figure 39. 4-Wire CS Mode Without Busy Indicator Connection Diagram
SDO
D17
D16
D15
D1
D0
tDIS
SCK
12
3
34
35
36
tHSDO
tDSDO
tEN
CONVERSION
ACQUISITION
tCONV
tCYC
tACQ
ACQUISITION
SDI (CS1)
CNV
tSSDICNV
tHSDICNV
D1
16
17
tSCK
tSCKL
tSCKH
D0
D17
D16
19
20
18
SDI (CS2)
06
14
6-
0
16
Figure 40. 4-Wire CS Mode Without Busy Indicator Serial Interface Timing
相關PDF資料
PDF描述
ADM3307EACPZ-REEL IC TXRX RS-232 5:3 2.7V 32LFCSP
PX0749/S CONN RCPT 4POS W/SOCKET
LTC2850CMS8#TRPBF IC TXRX RS485 20MBPS 8-MSOP
D7FBX CONN RCPT FEMALE 7PIN BLK/SILVER
ADM3312EARUZ-REEL7 IC TXRX RS-232 3:3 2.7V 24TSSOP
相關代理商/技術參數
參數描述
AD7691BCPZRL7 功能描述:IC ADC 18BIT SAR 250KSPS 10LFCSP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:PulSAR® 標準包裝:1,000 系列:- 位數:12 采樣率(每秒):300k 數據接口:并聯 轉換器數目:1 功率耗散(最大):75mW 電壓電源:單電源 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:24-SOIC(0.295",7.50mm 寬) 供應商設備封裝:24-SOIC 包裝:帶卷 (TR) 輸入數目和類型:1 個單端,單極;1 個單端,雙極
AD7691BRMZ 功能描述:IC ADC 18BIT SAR 250KSPS 10-MSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:PulSAR® 標準包裝:1 系列:microPOWER™ 位數:8 采樣率(每秒):1M 數據接口:串行,SPI? 轉換器數目:1 功率耗散(最大):- 電壓電源:模擬和數字 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-VQFN 裸露焊盤(4x4) 包裝:Digi-Reel® 輸入數目和類型:8 個單端,單極 產品目錄頁面:892 (CN2011-ZH PDF) 其它名稱:296-25851-6
AD7691BRMZ-RL7 功能描述:IC ADC 18BIT SAR 250KSPS 10-MSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:PulSAR® 標準包裝:1,000 系列:- 位數:12 采樣率(每秒):300k 數據接口:并聯 轉換器數目:1 功率耗散(最大):75mW 電壓電源:單電源 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:24-SOIC(0.295",7.50mm 寬) 供應商設備封裝:24-SOIC 包裝:帶卷 (TR) 輸入數目和類型:1 個單端,單極;1 個單端,雙極
AD7693 制造商:AD 制造商全稱:Analog Devices 功能描述:16-Bit Lower Power
AD76931 制造商:AD 制造商全稱:Analog Devices 功能描述:18-Bit, 2 MSPS PulSAR 15 mW ADC in LFCSP (QFN)