參數資料
型號: AD7801BRZ
廠商: Analog Devices Inc
文件頁數: 15/16頁
文件大?。?/td> 0K
描述: IC DAC 8BIT PARALLEL INP 20-SOIC
產品培訓模塊: Data Converter Fundamentals
DAC Architectures
標準包裝: 37
設置時間: 1.2µs
位數: 8
數據接口: 并聯
轉換器數目: 1
電壓電源: 單電源
功率耗散(最大): 12.9mW
工作溫度: -40°C ~ 105°C
安裝類型: 表面貼裝
封裝/外殼: 20-SOIC(0.295",7.50mm 寬)
供應商設備封裝: 20-SOIC W
包裝: 管件
輸出數目和類型: 1 電壓,單極;1 電壓,雙極
采樣率(每秒): 833k
產品目錄頁面: 785 (CN2011-ZH PDF)
AD7801
–8–
REV. 0
Reference
The AD7801 has the ability to use either an external reference
applied through the REFIN pin or an internal reference generated
from VDD. Figure 20 shows the reference input arrangement
where either the internal VDD/2 or the externally applied reference
can be selected.
The internal reference is selected by tying the REFIN pin to
VDD. If an external reference is to be used, this can be directly
applied to the REFIN pin and if this is 1 V below VDD, the
internal circuitry will select this externally applied reference as
the reference source for the DAC.
Digital Interface
The AD7801 contains a fast parallel interface allowing this
DAC to interface to industry standard microprocessors,
microcontrollers and DSP machines. There are two modes in
which this parallel interface can be configured to update the
DAC output. The synchronous update mode allows synchro-
nous updating of the DAC output; the automatic update mode
allows the DAC to be updated individually following a write
cycle. Figure 21 shows the internal logic associated with the
digital interface. The PON STRB signal is internally generated
from the power-on reset circuitry and is low during the power-
on reset phase of the power up procedure.
CLEAR
SET SLE
LDAC
ENABLE
DAC CONTROL
LOGIC
MLE
SLE
CLR
PON STRB
CLR
LDAC
CS
WR
Figure 21. Logic Interface
The AD7801 has a double buffered interface, which allows for
synchronous updating of the DAC output. Figure 22 shows a
block diagram of the register arrangement within the AD7801.
MLE
SLE
CONTROL LOGIC
CS
WR
LDAC
CLR
4
15
30
8
INPUT
REGISTER
4
TO
15
DECODER
DAC
REGISTER
4
15
30
4
TO
15
DECODER
DAC
REGISTER
DRIVERS
LOWER
NIBBLE
UPPER
NIBBLE
DB7-DB0
DRIVERS
Figure 22. Register Arrangement
Automatic Update Mode
In this mode of operation the
LDAC signal is permanently tied
low. The state of the
LDAC is sampled on the rising edge of
WR. LDAC being low allows the DAC register to be automati-
cally updated on the rising edge of
WR. The output update
occurs on the rising edge of
WR. Figure 23 shows the timing
associated with the automatic update mode of operation and
also the status of the various registers during this frame.
HOLD
TRACK
D7-D0
WR
CS
LDAC = 0
I/P REG (MLE)
DAC REG (SLE)
VOUT
TRACK
HOLD
Figure 23. Timing and Register Arrangement for Auto-
matic Update Mode
Synchronous Update Mode
In this mode of operation the
LDAC signal is used to update the
DAC output to synchronize with other updates in the system.
The state of the
LDAC is sampled on the rising edge of WR. If
LDAC is high, the automatic update mode is disabled and the
DAC latch is updated at any time after the write by taking
LDAC low. The output update occurs on the falling edge of
LDAC. LDAC must be taken back high again before the next
data transfer takes place. Figure 24 shows the timing associated
with the synchronous update mode of operation and also the
status of the various registers during this frame.
HOLD
D7-D0
WR
CS
LDAC
I/P REG (MLE)
DAC REG (SLE)
VOUT
HOLD
TRACK
Figure 24. Timing and Register Arrangement for Synchro-
nous Update Mode
相關PDF資料
PDF描述
VI-J5X-MZ-F3 CONVERTER MOD DC/DC 5.2V 25W
AD5305ARMZ IC DAC 8BIT 2WIRE I2C 10-MSOP
AD5428YRUZ IC DAC 8BIT DUAL MULT 20TSSOP
VI-J5X-MZ-F2 CONVERTER MOD DC/DC 5.2V 25W
MS3102R28-13P CONN RCPT 26POS BOX MNT W/PINS
相關代理商/技術參數
參數描述
AD7801BRZ-REEL 功能描述:IC DAC 8BIT PARALLEL INP 20-SOIC RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 產品培訓模塊:Data Converter Fundamentals DAC Architectures 設計資源:Unipolar, Precision DC Digital-to-Analog Conversion using AD5450/1/2/3 8-14-Bit DACs (CN0052) Precision, Bipolar, Configuration for AD5450/1/2/3 8-14bit Multiplying DACs (CN0053) AC Signal Processing Using AD5450/1/2/3 Current Output DACs (CN0054) Programmable Gain Element Using AD5450/1/2/3 Current Output DAC Family (CN0055) Single Supply Low Noise LED Current Source Driver Using a Current Output DAC in the Reverse Mode (CN0139) 標準包裝:10,000 系列:- 設置時間:- 位數:12 數據接口:DSP,MICROWIRE?,QSPI?,串行,SPI? 轉換器數目:1 電壓電源:單電源 功率耗散(最大):- 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-8 薄型,TSOT-23-8 供應商設備封裝:TSOT-23-8 包裝:帶卷 (TR) 輸出數目和類型:1 電流,單極;1 電流,雙極 采樣率(每秒):2.7M
AD7801BRZ-REEL7 功能描述:IC DAC 8BIT PARALLEL INP 20-SOIC RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 產品培訓模塊:LTC263x 12-, 10-, and 8-Bit VOUT DAC Family 特色產品:LTC2636 - Octal 12-/10-/8-Bit SPI VOUT DACs with 10ppm/°C Reference 標準包裝:91 系列:- 設置時間:4µs 位數:10 數據接口:MICROWIRE?,串行,SPI? 轉換器數目:8 電壓電源:單電源 功率耗散(最大):2.7mW 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-WFDFN 裸露焊盤 供應商設備封裝:14-DFN-EP(4x3) 包裝:管件 輸出數目和類型:8 電壓,單極 采樣率(每秒):*
AD7804 制造商:AD 制造商全稱:Analog Devices 功能描述:+3.3 V to +5 V Quad/Octal 10-Bit DACs
AD7804BN 制造商:Analog Devices 功能描述:DAC 4-CH 10-bit 16-Pin PDIP Tube 制造商:Rochester Electronics LLC 功能描述:QUAD 10-BIT SERIAL DAC - Bulk
AD7804BNZ 功能描述:IC DAC 10BIT QUAD SERIAL 16DIP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 產品培訓模塊:Data Converter Fundamentals DAC Architectures 標準包裝:750 系列:- 設置時間:7µs 位數:16 數據接口:并聯 轉換器數目:1 電壓電源:雙 ± 功率耗散(最大):100mW 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-LCC(J 形引線) 供應商設備封裝:28-PLCC(11.51x11.51) 包裝:帶卷 (TR) 輸出數目和類型:1 電壓,單極;1 電壓,雙極 采樣率(每秒):143k