- 您現在的位置：買賣IC網 > PDF目錄5854 > AD8042AN (Analog Devices Inc)IC OPAMP VF R-R DUAL LP 8DIP PDF資料下載
參數資料
| 型號： | AD8042AN |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 6/17頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC OPAMP VF R-R DUAL LP 8DIP |
| 設計資源： | Single-Ended-to-Differential Converters for Voltage Output and Current Output DACs Using AD8042 (CN0143) |
| 標準包裝： | 50 |
| 放大器類型： | 電壓反饋 |
| 電路數： | 2 |
| 輸出類型： | 滿擺幅 |
| 轉換速率： | 225 V/µs |
| -3db帶寬： | 170MHz |
| 電流 - 輸入偏壓： | 1.2µA |
| 電壓 - 輸入偏移： | 3000µV |
| 電流 - 電源： | 6mA |
| 電流 - 輸出 / 通道： | 50mA |
| 電壓 - 電源，單路/雙路(±)： | 3 V ~ 12 V，±1.5 V ~ 6 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 通孔 |
| 封裝/外殼： | 8-DIP（0.300"，7.62mm） |
| 供應商設備封裝： | 8-PDIP |
| 包裝： | 管件 |
AD8042
Rev. E | Page 13 of 16
Single-Supply Composite Video Line Driver
The two op amps of an AD8042 can be configured as a single-
supply dual line driver for composite video. The wide signal
swing of the AD8042 enables this function to be performed
without using any type of clamping or dc restore circuit, which
can cause signal distortion.
Figure 38 shows a schematic for a circuit that is driven by a
single composite video source that is ac-coupled, level-shifted
and applied to both noninverting inputs of the two amplifiers.
Each op amp provides a separate 75 Ω composite video output.
To obtain single-supply operation, ac coupling is used throughout.
The large capacitor values are required to ensure that there is
minimal tilting of the video signals due to their low frequency
(30 Hz) signal content. The circuit shown was measured to have
a differential gain of 0.06% and a differential phase of 0.06°.
The input is terminated in 75 Ω and ac-coupled via CIN to a
voltage divider that provides the dc bias point to the input.
Setting the optimal bias point requires some understanding
of the nature of composite video signals and the video
performance of the AD8042.
+5V
0.1F
8
3
2
VOUT
4
6
5
1
7
10F
4.99k
75
10k
RG
1k
RG
1k
RF
1k
RF
1k
RT
75
RT
75
RL
75
COAX
VOUT
RL
75
220F
1000F
0.1F
10F
1000F
0.1F
COMPOSITE
VIDEO IN
01
05
9-
03
8
Figure 38. Single-Supply Composite Video Line Driver Using AD8042
Signals of bounded peak-to-peak amplitude that vary in duty
cycle require larger dynamic swing capability than their peak-
to-peak amplitude after ac coupling. As a worst case, the dynamic
signal swing required approaches twice the peak-to-peak value.
The two bounding cases are for a duty cycle that is mostly low,
but occasionally goes high at a fraction of a percent duty cycle,
and vice versa.
Composite video is not quite this demanding. One bounding
extreme is for a signal that is mostly black for an entire frame
but has a white (full intensity), minimum width spike at least
once per frame.
The other extreme is for a video signal that is full white
everywhere. The blanking intervals and sync tips of such a
signal have negative going excursions in compliance with
composite video specifications. The combination of horizontal
and vertical blanking intervals limit such a signal to being at its
highest level (white) for only about 75% of the time.
As a result of the duty cycle variations between the two extremes
presented, a 1 V p-p composite video signal that is multiplied by
a gain of 2 requires about 3.2 V p-p of dynamic voltage swing at
the output for an op amp to pass a composite video signal of
arbitrary duty cycle without distortion.
Some circuits use a sync tip clamp along with ac coupling to
hold the sync tips at a relatively constant level, which lowers the
amount of dynamic signal swing required. However, these
circuits can have artifacts, such as sync tip compression, unless
they are driven by sources with very low output impedance.
The AD8042 not only has ample signal swing capability to handle
the dynamic range required without using a sync tip clamp but
also has good video specifications such as differential gain and
differential phase when buffering these signals in an ac-coupled
configuration.
To test the dynamic range, the differential gain and differential
phase were measured for the AD8042 while the supplies were
varied. As the lower supply is raised to approach the video
signal, the first effect observed is that the sync tips become
compressed before the differential gain and differential phase are
adversely affected. Therefore, there must be adequate swing in
the negative direction to pass the sync tips without compression.
As the upper supply is lowered to approach the video, the
differential gain and differential phase was not significantly
affected until the difference between the peak video output
and the supply reached 0.6 V. Therefore, the highest video level
should be kept at least 0.6 V below the positive supply rail.
Therefore, it was found that the optimal point to bias the
noninverting input is at 2.2 V dc. Operating at this point, the
worst-case differential gain is measured at 0.06% and the worst-
case differential phase is 0.06°.
The ac-coupling capacitors used in the circuit at first glance
appear quite large. A composite video signal has a lower frequency
band edge of 30 Hz. The resistances at the various ac coupling
points, especially at the output, are quite small. To minimize
phase shifts and baseline tilt, the large value capacitors are required.
For video system performance that is not to be of the highest
quality, the value of these capacitors can be reduced by a factor
of up to five with only a slightly observable change in the picture
quality.
相關PDF資料 |
PDF描述 |
|---|---|
| Y16361K00000T9W | RES 1K OHM .1W .01% FOIL 0603 |
| Y16070R50000F9W | RES .5 OHM .5W 1% FOIL SMD |
| TMM-144-01-S-S-SM | CONN HEADER 44POS SNGL 2MM SMD |
| LT1228CS8 | IC CURRNT FEEDBK AMP 100MHZ8SOIC |
| 170M3415 | FUSE 200A 690V 1BN/50 AR UC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD8042AR | 功能描述:IC OPAMP VF R-R DUAL LP 8SOIC RoHS:否 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:50 系列:- 放大器類型:J-FET 電路數:2 輸出類型:- 轉換速率:13 V/µs 增益帶寬積:3MHz -3db帶寬:- 電流 - 輸入偏壓:65pA 電壓 - 輸入偏移:3000µV 電流 - 電源:1.4mA 電流 - 輸出 / 通道:- 電壓 - 電源，單路/雙路(±):7 V ~ 36 V，±3.5 V ~ 18 V 工作溫度:-40°C ~ 85°C 安裝類型:通孔 封裝/外殼:8-DIP（0.300"，7.62mm） 供應商設備封裝:8-PDIP 包裝:管件 |
| AD8042AR-EBZ | 功能描述:BOARD EVAL FOR AD8042AR RoHS:是 類別:編程器，開發系統 >> 評估板 - 運算放大器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1 系列:- |
| AD8042AR-REEL | 功能描述:IC OPAMP VF R-R DUAL LP 8SOIC RoHS:否 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:1 系列:- 放大器類型:通用 電路數:2 輸出類型:滿擺幅 轉換速率:2.1 V/µs 增益帶寬積:3MHz -3db帶寬:- 電流 - 輸入偏壓:1pA 電壓 - 輸入偏移:2000µV 電流 - 電源:750µA 電流 - 輸出 / 通道:16mA 電壓 - 電源，單路/雙路(±):2.7 V ~ 16 V，±1.35 V ~ 8 V 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:14-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:14-SOIC 包裝:剪切帶 (CT) 其它名稱:296-10529-1 |
| AD8042AR-REEL7 | 功能描述:IC OPAMP VF R-R DUAL LP 8SOIC RoHS:否 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:50 系列:- 放大器類型:J-FET 電路數:2 輸出類型:- 轉換速率:3.5 V/µs 增益帶寬積:1MHz -3db帶寬:- 電流 - 輸入偏壓:30pA 電壓 - 輸入偏移:2000µV 電流 - 電源:200µA 電流 - 輸出 / 通道:- 電壓 - 電源，單路/雙路(±):7 V ~ 36 V，±3.5 V ~ 18 V 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:8-DIP（0.300"，7.62mm） 供應商設備封裝:8-PDIP 包裝:管件 |
| AD8042ARZ | 功能描述:IC OPAMP VF R-R DUAL LP 8SOIC RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:2,500 系列:- 放大器類型:通用 電路數:4 輸出類型:- 轉換速率:0.6 V/µs 增益帶寬積:1MHz -3db帶寬:- 電流 - 輸入偏壓:45nA 電壓 - 輸入偏移:2000µV 電流 - 電源:1.4mA 電流 - 輸出 / 通道:40mA 電壓 - 電源，單路/雙路(±):3 V ~ 32 V，±1.5 V ~ 16 V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:14-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:14-TSSOP 包裝:帶卷 (TR) 其它名稱:LM324ADTBR2G-NDLM324ADTBR2GOSTR |
發布緊急采購，3分鐘左右您將得到回復。