- 您現在的位置：買賣IC網 > PDF目錄17059 > AD9743-DPG2-EBZ (Analog Devices Inc)IC DAC DUAL 10BIT 72LFCSP PDF資料下載
參數資料
| 型號： | AD9743-DPG2-EBZ |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 16/28頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC DAC DUAL 10BIT 72LFCSP |
| 設計資源： | AD9747/6/5/3/1 DPG2 Eval Brd Schematic |
| 標準包裝： | 1 |
| DAC 的數量： | 2 |
| 位數： | 10 |
| 采樣率（每秒）： | 250M |
| 數據接口： | 并聯 |
| DAC 型： | 電流 |
| 工作溫度： | -40°C ~ 85°C |
| 已供物品： | 板 |
| 已用 IC / 零件： | AD9743 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁當前第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
Data Sheet
AD9741/AD9743/AD9745/AD9746/AD9747
Rev. A | Page 23 of 28
In pin mode, all register bits are reset to their default values
with the exception of those that are controlled by the SPI pins.
Note also that the RESET pin should be allowed to float and
must be pulled low. Connect an external 10 kΩ resistor to
DVSS. This avoids unexpected behavior in noisy environments.
DRIVING THE DAC CLOCK INPUT
The DAC clock input requires a low jitter drive signal. It is a
PMOS differential pair powered from the CVDD18 supply.
Each pin can safely swing up to 800 mV p-p at a common-
mode voltage of about 400 mV. Though these levels are not
directly LVDS-compatible, CLKP and CLKN can be driven by
an ac-coupled, dc-offset LVDS signal, as shown in Figure 29.
LVDS_P_IN
CLKP
50
0.1F
LVDS_N_IN
CLKN
VCM = 400mV
06569-
021
Figure 29. LVDS DAC Clock Drive Circuit
Using a CMOS or TTL clock is also acceptable for lower sample
rates. It can be routed through an LVDS translator and then
ac-coupled as described previously, or alternatively, it can be
transformer-coupled and clamped, as shown in Figure 30.
50
TTL OR CMOS
CLK INPUT
CLKP
CLKN
VCM = 400mV
BAV99ZXCT
HIGH SPEED
DUAL DIODE
0.1F
06569-
022
Figure 30. TTL or CMOS DAC Clock Drive Circuit
If a sine wave signal is available, it can be transformer-coupled
directly to the DAC clock inputs, as shown in Figure 31.
50
SINE WAVE
INPUT
CLKP
CLKN
VCM = 400mV
06569-
034
Figure 31. Sine Wave DAC Clock Drive Circuit
The 400 mV common-mode bias voltage can be derived from
the CVDD18 supply through a simple divider network, as
shown in Figure 32.
0.1F
1nF
VCM = 400mV
CVDD18
CVSS
1k
287
06569-
023
Figure 32. DAC Clock VCM Circuit
It is important to use CVDD18 and CVSS for any clock bias
circuit as noise that is coupled onto the clock from another
power supply is multiplied by the DAC input signal and
degrades performance.
FULL-SCALE CURRENT GENERATION
The full-scale currents on DAC1 and DAC2 are functions of
the current drawn through an external resistor connected to
the FSADJ pin (Pin 54). The required value for this resistor is
10 kΩ. An internal amplifier sets the current through the
resistor to force a voltage equal to the band gap voltage of 1.2 V.
This develops a reference current in the resistor of 120 μA.
CURRENT
SCALING
1.2V BANDGAP
DAC1 GAIN
DAC2 GAIN
AD9747
DAC1
DAC2
DAC FULL SCALE
REFERENCE CURRENT
REFIO
FSADJ
0.1F
10k
06569-
024
Figure 33. Reference Circuitry
REFIO (Pin 55) should be bypassed to ground with a 0.1 μF
capacitor. The band gap voltage is present on this pin and can
be buffered for use in external circuitry. The typical output
impedance is near 5 kΩ. If desired, an external reference can
be connected to REFIO to overdrive the internal reference.
Internal current mirrors provide a means for adjusting the
DAC full-scale currents. The gain for DAC1 and DAC2 can be
adjusted independently by writing to the DAC1FSC<9:0> and
DAC2FSC<9:0> register bits. The default value of 0x01F9 for
the DAC gain registers gives an IFS of 20 mA, where IFS equals
×
+
×
=
FSC
DAC
IFS
n
16
3
72
10,000
V
1.2
The full-scale output current range is 8.6 mA to 31.7 mA for
register values 0x000 to 0x3FF.
06569-
025
35
30
25
20
15
10
5
I FS
(
mA)
0
256
512
768
1024
DAC GAIN CODE
Figure 34. IFS vs. DAC Gain Code
相關PDF資料 |
PDF描述 |
|---|---|
| AD9116-DPG2-EBZ | IC DAC DUAL 12BIT LO PWR 40LFCSP |
| VE-B4X-EY | CONVERTER MOD DC/DC 5.2V 50W |
| AD9117-DPG2-EBZ | IC DAC DUAL 14BIT LO PWR 40LFCSP |
| AD9114-DPG2-EBZ | IC DAC DUAL 8BIT LO PWR 40LFCSP |
| AD9115-DPG2-EBZ | IC DAC DUAL 10BIT LO PWR 40LFCSP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD9743-EBZ | 制造商:Analog Devices 功能描述:Evaluation Board For Dual 8-/10-/12-/14-/16-Bit 250 MSPS Digital-To-Analog Converters 制造商:Analog Devices 功能描述:DUAL 10BIT, 200 MSPS D-A CONVERTER - Bulk |
| AD9744 | 制造商:AD 制造商全稱:Analog Devices 功能描述:14-Bit, 210 MSPS TxDAC㈢ D/A Converter |
| AD9744ACP | 制造商:Analog Devices 功能描述:DAC 1-CH 14-bit 32-Pin LFCSP EP 制造商:Rochester Electronics LLC 功能描述:14-BIT 165 MSPS TXDAC D/A CONVERTER - Bulk 制造商:Analog Devices 功能描述:IC 14-BIT DAC |
| AD9744ACP-PCB | 制造商:Analog Devices 功能描述:Evaluation Board For AD9744 ,14-Bit, 165MSPS TxDAC D/A Converter 制造商:Analog Devices 功能描述:EVAL BD FOR AD9744 ,14BIT, 165MSPS TXDAC D/A CNVRTR - Bulk |
| AD9744ACP-PCBZ | 功能描述:BOARD EVAL FOR AD9744ACP RoHS:是 類別:編程器，開發系統 >> 評估板 - 數模轉換器 (DAC) 系列:TxDAC® 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1 系列:- DAC 的數量:4 位數:12 采樣率（每秒）:- 數據接口:串行，SPI? 設置時間:3µs DAC 型:電流/電壓 工作溫度:-40°C ~ 85°C 已供物品:板 已用 IC / 零件:MAX5581 |
發布緊急采購，3分鐘左右您將得到回復。