- 您現在的位置：買賣IC網 > PDF目錄8962 > AD9751ASTZ (Analog Devices Inc)IC DAC 10BIT 300MSPS 48-LQFP PDF資料下載
參數資料
| 型號： | AD9751ASTZ |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 11/28頁 |
| 文件大小： | 0K |
| 描述： | IC DAC 10BIT 300MSPS 48-LQFP |
| 產品培訓模塊： | Data Converter Fundamentals DAC Architectures |
| 標準包裝： | 1 |
| 系列： | TxDAC+® |
| 設置時間： | 11ns |
| 位數： | 10 |
| 數據接口： | 并聯 |
| 轉換器數目： | 1 |
| 電壓電源： | 模擬和數字 |
| 功率耗散（最大）： | 165mW |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 48-LQFP |
| 供應商設備封裝： | 48-LQFP（7x7） |
| 包裝： | 托盤 |
| 輸出數目和類型： | 2 電流，單極；2 電流，雙極 |
| 采樣率（每秒）： | 300M |
| 產品目錄頁面： | 785 (CN2011-ZH PDF) |
| 配用： | AD9751-EB-ND - BOARD EVAL FOR AD9751 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁當前第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
REV. C
AD9751
–19–
APPLICATIONS
QAM/PSK Synthesis
Quadrature modulation (QAM or PSK) consists of two baseband
PAM (Pulse Amplitude Modulated) data channels. Both chan-
nels are modulated by a common frequency carrier. However,
the carriers for each channel are phase-shifted 90
° from each
other. This orthogonality allows twice the spectral efficiency
(data for a given bandwidth) of digital data transmitted via AM.
Receivers can be designed to selectively choose the “in phase”
and “quadrature” carriers, and then recombine the data.
The recombination of the QAM data can be mapped as points
representing digital words in a two-dimensional constellation, as
shown in Figure 27. Each point, or symbol, represents the trans-
mission of multiple bits in one symbol period.
0100
0101
0001
0000
0110
0111
0011
0010
1110
1111
1011
1010
1100
1101
1001
1000
Figure 27. 16 QAM Constellation, Gray Coded (Two 4-Level
PAM Signals with Orthogonal Carriers)
Typically, the I and Q data channels are quadrature-modulated
in the digital domain. The high data rate of the AD9751 allows
extremely wideband (>10 MHz) quadrature carriers to be syn-
thesized. Figure 28 shows an example of a 25 MSymbol/S
QAM signal, oversampled by 8 at a data rate of 200 MSPS
modulated onto a 25 MHz carrier and reconstructed using the
AD9751. The power in the reconstructed signal is measured
to be –12.08 dBm. In the first adjacent band, the power is
–73.67 dBm, while in the second adjacent band the power is
–76.91 dBm.
–30
START 100kHz
–40
–50
–60
–70
–80
–90
–100
–110
–120
–130
12.49MHz/
STOP 125MHz
REF
LV1
(dBm)
1RM
–74.49bBM,
+9.71442886MHz
–73.67dBm
–76.91dBm
–12.08dBm
1 [T1]
CH PWR
ACP UP
ACP LOW
C11
C0
Cu1
C11
C0
Cu1
MARKER 1 [T1]
RBW
5kHz
RF ATT
0dB
–74.49dBm
VBW
50kHz
9.71442886MHz
SWT
12.5 s
UNIT
dBm
COMMENT A: 25 MSYMBOL, 64 QAM, CARRIER = 25MHz
1
Figure 28. Reconstructing Raised Cosine Signal
at 120 MHz IF
A figure of merit for wideband signal synthesis is the ratio of signal
power in the transmitted band to the power in an adjacent chan-
nel. In Figure 29, the adjacent channel power ratio (ACPR) at
the output of the AD9751 is measured to be 62 dB. The limita-
tion on making a measurement of this type is often not the DAC
but the noise inherent in creating the digital data record using
computer tools. To find how much this is limiting the perceived
DAC performance, the signal amplitude can be reduced, as
shown in Figure 29. The noise contributed by the DAC will
remain constant as the signal amplitude is reduced. When the
signal amplitude is reduced to the level where the noise floor
drops below that of the spectrum analyzer, ACPR will fall off at
the same rate that the signal level is being reduced. Under the
conditions measured in Figure 28, this point occurs in Figure 29
at –4 dBFS. This shows that the data record is actually degrad-
ing the measured ACPR by up to 4 dB.
AMPLITUDE (dBFS)
80
60
40
0
–10
–20
ACPR
(dB)
70
50
–15
–5
Figure 29. ACPR vs. Amplitude for QAM Carrier
A single-channel active mixer such as the Analog Devices AD8343
can then be used for the hop to the transmit frequency. Figure 30
shows an applications circuit using the AD9751 and the AD8343.
The AD8343 is capable of mixing carriers from dc to 2.5 GHz.
Figure 31 shows the result of mixing the signal in Figure 28 up
to a carrier frequency of 800 MHz. ACPR measured at the
output of the AD8343 is shown in Figure 31 to be 58 dB.
相關PDF資料 |
PDF描述 |
|---|---|
| VE-27X-MY-F4 | CONVERTER MOD DC/DC 5.2V 50W |
| VE-J0Z-MZ-F3 | CONVERTER MOD DC/DC 2V 10W |
| VE-27W-MY-F3 | CONVERTER MOD DC/DC 5.5V 50W |
| VE-27T-MY-F3 | CONVERTER MOD DC/DC 6.5V 50W |
| VE-J0Y-MZ-F1 | CONVERTER MOD DC/DC 3.3V 16.5W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD9751ASTZKL1 | 制造商:Rochester Electronics LLC 功能描述: 制造商:Analog Devices 功能描述: |
| AD9751ASTZRL | 功能描述:IC DAC 10BIT 300MSPS 48LQFP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:TxDAC+® 產品培訓模塊:Data Converter Fundamentals DAC Architectures 標準包裝:750 系列:- 設置時間:7µs 位數:16 數據接口:并聯 轉換器數目:1 電壓電源:雙 ± 功率耗散（最大）:100mW 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-LCC（J 形引線） 供應商設備封裝:28-PLCC（11.51x11.51） 包裝:帶卷 (TR) 輸出數目和類型:1 電壓，單極；1 電壓，雙極 采樣率（每秒）:143k |
| AD9751-EB | 功能描述:BOARD EVAL FOR AD9751 RoHS:否 類別:編程器，開發系統 >> 評估板 - 數模轉換器 (DAC) 系列:TxDAC® 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1 系列:- DAC 的數量:4 位數:12 采樣率（每秒）:- 數據接口:串行，SPI? 設置時間:3µs DAC 型:電流/電壓 工作溫度:-40°C ~ 85°C 已供物品:板 已用 IC / 零件:MAX5581 |
| AD9752 | 制造商:AD 制造商全稱:Analog Devices 功能描述:12-Bit, 125 MSPS High Performance TxDAC D/A Converter |
發布緊急采購，3分鐘左右您將得到回復。