- 您現在的位置：買賣IC網 > PDF目錄9090 > ADF4193BCPZ-RL (Analog Devices Inc)IC PLL FREQ SYNTHESIZER 32LFCSP PDF資料下載
參數資料
| 型號： | ADF4193BCPZ-RL |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 17/32頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC PLL FREQ SYNTHESIZER 32LFCSP |
| 標準包裝： | 5,000 |
| 類型： | 時鐘/頻率合成器，RF |
| PLL： | 是 |
| 輸入： | CMOS，TTL |
| 輸出： | 時鐘 |
| 電路數： | 1 |
| 比率 - 輸入:輸出： | 2:1 |
| 差分 - 輸入:輸出： | 是/無 |
| 頻率 - 最大： | 3.5GHz |
| 除法器/乘法器： | 是/是 |
| 電源電壓： | 2.7 V ~ 3.3 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 32-VFQFN 裸露焊盤，CSP |
| 供應商設備封裝： | 32-LFCSP-VQ（5x5） |
| 包裝： | 帶卷 (TR) |
| 配用： | EVAL-ADF4193EBZ2-ND - BOARD EVALUATION EB2 FOR ADF4193 EVAL-ADF4193EBZ1-ND - BOARD EVALUATION EB1 FOR ADF4193 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁當前第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁
ADF4193
Data Sheet
Rev. F | Page 24 of 32
switches opened, and thus the phase swing that occurs when the
BW is reduced can be minimized.
With dither off, the fractional spur pattern due to the SDM’s
quantization noise also depends on the phase word the modulator
is seeded with. Tables of optimized FRAC and phase values for
popular SW1/SW2 and ICP timer settings can be down-loaded
from the ADF4193 product page. If making use of a phase table,
first write phase to double buffered Register R2, then write the
INT and FRAC to R0.
Avoiding Integer Boundary Channels
A further option when programming a new frequency involves
a write to Register R1 to avoid integer boundary spurs. If it is
found that the integer boundary spur level is too high, an
option is to move the integer boundary away from the desired
channel by reprogramming the R divider to select a different
PFD frequency. For example, if REFIN = 104 MHz and R = 4 for
a 26 MHz PFD frequency and MOD = 130 for 200 kHz steps,
the frequency channel at 910.2 MHz has a 200 kHz integer
boundary spur because it is 200 kHz offset from 35 × 26 MHz.
An alternative way to synthesize this channel is to set R = 5 for a
20.8 MHz PFD reference and MOD = 104 for 200 kHz steps.
The 910.2 MHz channel is now 5 MHz offset from the nearest
integer multiple of 20.8 MHz and the 5 MHz beat note spurs are
well attenuated by the loop. Setting double buffered Bit R1 [23] = 1
(CP ADJ bit) increases the charge pump current by 25%, which
compensates for the 25% increase in N with the change to the
20.8 MHz PFD frequency. This maintains constant loop dynamics
and settling time performance for jumps between the two PFD
frequencies. The CP ADJ bit should be cleared again when jumping
back to 26 MHz-based channels.
The Register R1 settings necessary for integer boundary spur
avoidance are all double buffered and do not become active on
the chip until the next write to Register R0. Register R0 should
always be the last register written to when programming a new
frequency.
Serial Interface Activity
The serial interface activity when programming the R2 or R1
registers causes no noticeable disturbance to the synthesizers
settled phase or degradation in its frequency spectrum. Therefore,
in a GSM application, it can be performed during the active
part of the data burst. Because it takes just 10.2 s to program
the three registers, R2, R1, and R0, with the 6.5 MHz serial
interface clock rate typically used, this programming can also be
performed during the previous guard period with the LE edge
to latch in the R0 data delayed until it’s time to switch
frequency.
相關PDF資料 |
PDF描述 |
|---|---|
| M83723/74R2255N | CONN RCPT 55POS JAM NUT W/PINS |
| V110A5H200BL3 | CONVERTER MOD DC/DC 5V 200W |
| CS2000P-DZZ | IC CLK GEN/MULT OTP 10-MSOP |
| V110A5H200BG2 | CONVERTER MOD DC/DC 5V 200W |
| X9410WV24Z-2.7 | IC XDCP DUAL 64-TAP 10K 24-TSSOP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADF4193BCPZ-RL7 | 功能描述:IC PLL FREQ SYNTHESIZER 32LFCSP RoHS:是 類別:集成電路 (IC) >> 時鐘/計時 - 時鐘發生器，PLL，頻率合成器 系列:- 標準包裝:2,000 系列:- 類型:PLL 時鐘發生器 PLL:帶旁路 輸入:LVCMOS，LVPECL 輸出:LVCMOS 電路數:1 比率 - 輸入:輸出:2:11 差分 - 輸入:輸出:是/無 頻率 - 最大:240MHz 除法器/乘法器:是/無 電源電壓:3.135 V ~ 3.465 V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:32-LQFP 供應商設備封裝:32-TQFP（7x7） 包裝:帶卷 (TR) |
| ADF4193SP1BCPZ | 制造商:Analog Devices 功能描述: |
| ADF4193SP1BCPZ-RL7 | 制造商:Analog Devices 功能描述: |
| ADF4193SP2BCPZ-RL7 | 制造商:Analog Devices 功能描述: |
| ADF4193WCCPZ-RL7 | 功能描述:IC PLL FREQ SYNTHESIZER 32LFCSP RoHS:是 類別:集成電路 (IC) >> 時鐘/計時 - 時鐘發生器，PLL，頻率合成器 系列:- 標準包裝:2,000 系列:- 類型:PLL 時鐘發生器 PLL:帶旁路 輸入:LVCMOS，LVPECL 輸出:LVCMOS 電路數:1 比率 - 輸入:輸出:2:11 差分 - 輸入:輸出:是/無 頻率 - 最大:240MHz 除法器/乘法器:是/無 電源電壓:3.135 V ~ 3.465 V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:32-LQFP 供應商設備封裝:32-TQFP（7x7） 包裝:帶卷 (TR) |
發布緊急采購，3分鐘左右您將得到回復。