
Shutter_Max_Bound_Lower
Address: 0x1D
Access: Read/Write
Reset Value: 0x8C (before SROM download)
0x00 (after SROM download)
Data Type: 16-bit unsigned integer.
USAGE: This value sets the maximum allowable shutter value when operating in automatic mode.
Units are clock cycles. Since the automatic frame rate function is based on shutter value, the
value in these registers can limit the range of the frame rate control. To read from the registers,
read Upper first followed by Lower. To write to the registers, write Lower first, followed by
Upper, then execute a write to the Frame_Period_Max_Bound_Upper and Lower registers. To set
the shutter manually, disable the AGC via the Extended_Config register and write the desired
value to these registers.
Reading this register will return the most recent value that was written to it. However, the value
will take effect only after a write to the Frame_Period_Max_Bound_Upper and Lower registers.
After writing to Frame_Period_Max_Bound_Upper, wait at least two frame times before writing to
Shutter_Max_Bound_Upper or Lower again. The “Busy” bit in the Extended_Config register may be
used in lieu of a timer to determine when it is safe to write. See the Extended_Config register
for more details.
In addition, the three bound registers must also follow this rule when set to non-default values:
Frame_Period_Max_Bound
≥
Frame_Period_Min_Bound + Shutter_Max_Bound.
Shutter_Max_Bound_Upper
Address: 0x1E
Access: Read/Write
Bit
Reset Value: 0x20
5
SROM_ID
Address: 0x1F
Access: Read
Reset Value: 0x00
Bit
7
6
5
4
3
2
1
0
Field
SR
7
SR
6
SR
5
SR
4
SR
3
SR
2
SR
1
SR
0
Bit
7
6
5
4
3
2
1
0
Field
SB
7
SB
6
SB
5
SB
4
SB
3
SB
2
SB
1
SB
0
7
6
4
3
2
1
0
Field
SB
15
SB
14
SB
13
SB
12
SB
11
SB
10
SB
9
SB
8
Data Type:8-Bit unsigned integer.
USAGE: Contains the revision of the downloaded Shadow ROM firmware. If the firmware has been
successfully downloaded and the chip is operating out of SROM, this register will contain the
SROM firmware revision, otherwise it will contain 0x00.
Note: The IC hardware revision is available by reading the Revision_ID register (register 0x01).
Reserved
Address: 0x20 – 0x3C