- 您現在的位置：買賣IC網 > PDF目錄166081 > AFCT-5942AGZ FIBER OPTIC TRANSCEIVER, 1260-1570nm, 2488Mbps(Tx), 2488Mbps(Rx), BOARD/PANEL MOUNT, DIP, LC CONNECTOR PDF資料下載
參數資料
| 型號： | AFCT-5942AGZ |
| 元件分類： | 光收發 |
| 英文描述： | FIBER OPTIC TRANSCEIVER, 1260-1570nm, 2488Mbps(Tx), 2488Mbps(Rx), BOARD/PANEL MOUNT, DIP, LC CONNECTOR |
| 封裝： | ROHS COMPLIANT, DIP-20 |
| 文件頁數： | 11/18頁 |
| 文件大小： | 557K |
| 代理商： | AFCT-5942AGZ |
2
Functional Description
Receiver Section
Design
The receiver section for the AFCT-5942xxxZ contains an
InGaAs/InP photo detector and a preamplifier mounted
in an optical subassembly. This optical subassembly is
coupled to a postamp/decision circuit on a circuit board.
The design of the optical assembly is such that it pro-
vides better than 27 dB Optical Return Loss (ORL).
The postamplifier is ac coupled to the preamplifier as il-
lustrated in Figure 1. The coupling capacitors are large
enough to pass the SONET/SDH test pattern at 2488 Mb/s
without significant distortion or performance penalty.
For codes which have a significantly lower frequency
content, jitter and pulse distortion could be degraded.
The receiver outputs are squelched at Signal Detect
deasserts. That is, when the light input decreases to typi-
cal -27 dBm or less, the Signal Detect deasserts i.e. the
SD Output goes to a TTL low state. This forces the DATA
OUT and DATA OUT Bar to go PECL levels high and low
respectively.
Figure 1 also shows a filter function which limits the
bandwidth of the preamp output signal. The filter is de-
signed to bandlimit the preamp output noise and thus
improve the receiver sensitivity.
These components will reduce the sensitivity of the re-
ceiver as the signal bit rate is increased above 2.7 Gb/s.
As an optional feature the device also incorporates a
photodetector bias circuit. The circuit works by providing
a mirrored output of the bias current within the photo-
diode. This output must be connected to V
CC and can be
monitored by connecting through a series resistor (see
Application Section).
Noise Immunity
The receiver includes internal circuit components to filter
power supply noise. However under some conditions of
EMI and power supply noise, external power supply filter-
ing may be necessary (see Application Section).
The Signal Detect Circuit
The signal detect circuit works by sensing the peak level
of the received signal and comparing this level to a refer-
ence. The SD output is low voltage TTL.
Figure 1. Receiver Block Diagram
TRANS-
IMPEDANCE
PRE-
AMPLIFIER
FILTER
GND
AMPLIFIER
PECL
OUTPUT
BUFFER
TTL
OUTPUT
BUFFER
DATA OUT
SIGNAL
DETECT
CIRCUIT
SD
DATA OUT
PHOTODETECTOR
BIAS
相關PDF資料 |
PDF描述 |
|---|---|
| AFD50 | FEMALE; MALE, MIL SERIES CONNECTOR, SOLDER, RECEPTACLE |
| AFF-L160BB113 | FIBER OPTIC FIXED ATTENUATOR, 1570-1605nm, PANEL MOUNT, FC/APC CONNECTOR |
| AFF-CR50BB109 | FIBER OPTIC FIXED ATTENUATOR, 1528-1563nm, PANEL MOUNT, FC/UPC CONNECTOR |
| AFF-CR50BB10B | FIBER OPTIC FIXED ATTENUATOR, 1528-1563nm, PANEL MOUNT, LC CONNECTOR |
| AFF-CR50BB110 | FIBER OPTIC FIXED ATTENUATOR, 1528-1563nm, PANEL MOUNT |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AFCT-5942ALZ | 功能描述:光纖發射器、接收器、收發器 Transceiver RoHS:否 制造商:Omron Electronics 產品:Transmitters 數據速率:3.5 Gbps 波長:850 nm 最大工作溫度: 最小工作溫度: 封裝 / 箱體: 封裝: |
| AFCT-5942ATGZ | 功能描述:光纖發射器、接收器、收發器 OC48 IR SFF RoHS -20/85 RoHS:否 制造商:Omron Electronics 產品:Transmitters 數據速率:3.5 Gbps 波長:850 nm 最大工作溫度: 最小工作溫度: 封裝 / 箱體: 封裝: |
| AFCT-5942ATLZ | 功能描述:光纖發射器、接收器、收發器 Transceiver RoHS:否 制造商:Omron Electronics 產品:Transmitters 數據速率:3.5 Gbps 波長:850 nm 最大工作溫度: 最小工作溫度: 封裝 / 箱體: 封裝: |
| AFCT-5942GZ | 功能描述:光纖發射器、接收器、收發器 Transceiver RoHS:否 制造商:Omron Electronics 產品:Transmitters 數據速率:3.5 Gbps 波長:850 nm 最大工作溫度: 最小工作溫度: 封裝 / 箱體: 封裝: |
| AFCT-5942LZ | 功能描述:光纖發射器、接收器、收發器 Transceiver RoHS:否 制造商:Omron Electronics 產品:Transmitters 數據速率:3.5 Gbps 波長:850 nm 最大工作溫度: 最小工作溫度: 封裝 / 箱體: 封裝: |
發布緊急采購，3分鐘左右您將得到回復。