- 您現在的位置：買賣IC網 > PDF目錄223322 > AFCT-701SDDZ FIBER OPTIC TRANSCEIVER, 1260-1355nm, 10000Mbps(Tx), 10000Mbps(Rx), SURFACE MOUNT, LC CONNECTOR PDF資料下載
參數資料
| 型號： | AFCT-701SDDZ |
| 元件分類： | 光收發 |
| 英文描述： | FIBER OPTIC TRANSCEIVER, 1260-1355nm, 10000Mbps(Tx), 10000Mbps(Rx), SURFACE MOUNT, LC CONNECTOR |
| 封裝： | HALOGEN FREE AND ROHS COMPLIANT PACKAGE |
| 文件頁數： | 14/20頁 |
| 文件大?。?/td> | 212K |
| 代理商： | AFCT-701SDDZ |
3
Figure 1. Transceiver functional diagram
Transmit Fault (TX_FAULT)
A catastrophic laser fault will activate the transmitter
signal, TX_FAULT, and disable the laser. This signal is
an open collector output (pull-up required on the host
board). A low signal indicates normal laser operation and
a high signal indicates a fault. A fault is dened as laser
power below or above the specied IEEE 802.3ae speci-
ed min/max range. The TX_FAULT will be latched high
when a laser fault occurs and is cleared by toggling the
TX_DISABLE input or power cycling the transceiver. The
transmitter fault condition can also be monitored via the
two-wire serial interface (address A2, byte 110, bit 2).
Transmitter Section
The transmitter section includes the Transmitter Optical
Sub-Assembly (TOSA) and laser driver circuitry. The
TOSA, containing an Avago designed and manufactured
1310 nm DFB light source, is located at the optical inter-
face and mates with the LC optical connector. The TOSA
is driven by an IC which uses the incoming dierential
high speed logic signal to modulate the laser diode
driver current. This Tx laser driver circuit regulates the
optical power at a level within the specied range.
Transmit Disable (TX_DISABLE)
The AFCT-701SDDZ accepts an LVTTL compatible trans-
mit disable control signal input which shuts down the
transmitter optical output. A high signal implements
this function while a low signal allows normal transceiver
operation. In the event of a fault (e.g. eye safety circuit
activated), cycling this control signal resets the module
as depicted in Figure 5. An internal pull up resistor dis-
ables the transceiver transmitter until the host pulls the
input low. TX_DISABLE can also be asserted via the two-
wire interface (address A2h, byte 110, bit 6) and moni-
tored (address A2h, byte 110, bit 7).
The contents of A2h, byte 110, bit 6 are logic OR’d with
hardware TX_DISABLE (contact 3) to control transmitter
operation. The normal behavior of this feature is to reset
a TX disabled transceiver to TX enabled when it is power
cycled or hot-plugged.
LIGHT FROM FIBER
LIGHT TO FIBER
PHOTO-DETECTOR
RECEIVER
AMPLIFICATION
& QUANTIZATION
RD+ (RECEIVE DATA)
RD– (RECEIVE DATA)
RX_LOS
VCSEL
TRANSMITTER
LASER
DRIVER &
SAFETY
CIRCUITRY
TX_DISABLE
TD+ (TRANSMIT DATA)
TD– (TRANSMIT DATA)
TX_FAULT
ELECTRICAL INTERFACE
SDA
SCL
MOD-ABS
CONTROLLER & MEMORY
OPTICAL INTERFACE
RS0
RS1
相關PDF資料 |
PDF描述 |
|---|---|
| AFL12005DZ/HBPBF | 2-OUTPUT 80 W DC-DC REG PWR SUPPLY MODULE |
| AFL5005DY | 2-OUTPUT 66 W DC-DC REG PWR SUPPLY MODULE |
| AFL5005SZ/HB | 1-OUTPUT 66 W DC-DC REG PWR SUPPLY MODULE |
| AFL5012SW | 1-OUTPUT 66 W DC-DC REG PWR SUPPLY MODULE |
| AFL5015DX | 2-OUTPUT 66 W DC-DC REG PWR SUPPLY MODULE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AFCT-701SDZ | 功能描述:光纖發射器、接收器、收發器 Transceiver RoHS:否 制造商:Omron Electronics 產品:Transmitters 數據速率:3.5 Gbps 波長:850 nm 最大工作溫度: 最小工作溫度: 封裝 / 箱體: 封裝: |
| AFCT-701SDZ-AN1 | 制造商:Avago Technologies 功能描述:10GBE SFP+LR, ANUE - Bulk |
| AFCT-701SDZ-MX1 | 制造商:Avago Technologies 功能描述: |
| AFCT-701SGDZ | 功能描述:光纖發射器、接收器、收發器 Transceiver RoHS:否 制造商:Omron Electronics 產品:Transmitters 數據速率:3.5 Gbps 波長:850 nm 最大工作溫度: 最小工作溫度: 封裝 / 箱體: 封裝: |
| AFCT-707SDZ | 制造商:Avago Technologies 功能描述:10G SFP+ 220M 10GBASE-LRM - Trays |
發布緊急采購，3分鐘左右您將得到回復。