3-4 Revision 13 Table 3-1 shows the Flash*Freeze pin location on the available packages. The Flash*Freeze pin locat" />
參數資料
型號： AGLE3000V2-FGG896
廠商： Microsemi SoC
文件頁數： 33/166頁
文件大?。?/td> 0K
描述： IC FPGA 1KB FLASH 3M 896-FBGA
標準包裝： 27
系列： IGLOOe
邏輯元件/單元數： 75264
RAM 位總計： 516096
輸入/輸出數： 620
門數： 3000000
電源電壓： 1.14 V ~ 1.575 V
安裝類型： 表面貼裝
工作溫度： 0°C ~ 70°C
封裝/外殼： 896-BGA
供應商設備封裝： 896-FBGA（31x31）
Pin Descriptions and Packaging
3-4
Revision 13
Table 3-1 shows the Flash*Freeze pin location on the available packages. The Flash*Freeze pin location
is independent of device (except for a PQ208 package), allowing migration to larger or smaller IGLOO
devices while maintaining the same pin location on the board. Refer to the "Flash*Freeze Technology
and Low Power Modes" chapter of the IGLOOe FPGA Fabric User’s Guide for more information on I/O
states during Flash*Freeze mode.
JTAG Pins
Low power flash devices have a separate bank for the dedicated JTAG pins. The JTAG pins can be run
at any voltage from 1.5 V to 3.3 V (nominal). VCC must also be powered for the JTAG state machine to
operate, even if the device is in bypass mode; VJTAG alone is insufficient. Both VJTAG and VCC to the
part must be supplied to allow JTAG signals to transition the device. Isolating the JTAG power supply in a
separate I/O bank gives greater flexibility in supply selection and simplifies power supply and PCB
design. If the JTAG interface is neither used nor planned for use, the VJTAG pin together with the TRST
pin could be tied to GND.
TCK
Test Clock
Test clock input for JTAG boundary scan, ISP, and UJTAG. The TCK pin does not have an internal pull-
up/-down resistor. If JTAG is not used, Microsemi recommends tying off TCK to GND through a resistor
placed close to the FPGA pin. This prevents JTAG operation in case TMS enters an undesired state.
Note that to operate at all VJTAG voltages, 500
to 1 k will satisfy the requirements. Refer to Table 3-2
for more information.
Table 3-1 Flash*Freeze Pin Locations for IGLOOe Devices
Package
Flash*Freeze Pin
FG256
T3
FG484
W6
FG896
AH4
Table 3-2 Recommended Tie-Off Values for the TCK and TRST Pins
VJTAG
Tie-Off Resistance 1,2
VJTAG at 3.3 V
200
to 1 k
VJTAG at 2.5 V
200
to 1 k
VJTAG at 1.8 V
500
to 1 k
VJTAG at 1.5 V
500
to 1 k
Notes:
1. The TCK pin can be pulled-up or pulled-down.
2. The TRST pin is pulled-down.
3. Equivalent parallel resistance if more than one device is on the JTAG chain
相關PDF資料
PDF描述
ACB85DHFT CONN EDGECARD 170POS .050 SMD
AGLE3000V2-FG896 IC FPGA 1KB FLASH 3M 896-FBGA
M1AGLE3000V2-FGG896 IC FPGA 1KB FLASH 3M 896-FBGA
M1AGLE3000V2-FG896 IC FPGA 1KB FLASH 3M 896-FBGA
ABB85DHFT CONN EDGECARD 170POS .050 SMD
相關代理商/技術參數
參數描述
AGLE3000V2-FGG896ES 制造商:ACTEL 制造商全稱:Actel Corporation 功能描述:IGLOOe Low-Power Flash FPGAs with Flash Freeze Technology
AGLE3000V2-FGG896I 功能描述:IC FPGA 1KB FLASH 3M 896-FBGA RoHS:是 類別:集成電路 (IC) >> 嵌入式 - FPGA（現場可編程門陣列） 系列:IGLOOe 標準包裝:1 系列:ProASICPLUS LAB/CLB數:- 邏輯元件/單元數:- RAM 位總計:129024 輸入/輸出數:248 門數:600000 電源電壓:2.3 V ~ 2.7 V 安裝類型:表面貼裝 工作溫度:- 封裝/外殼:352-BFCQFP，帶拉桿 供應商設備封裝:352-CQFP（75x75）
AGLE3000V2-FGG896PP 制造商:ACTEL 制造商全稱:Actel Corporation 功能描述:IGLOOe Low-Power Flash FPGAs with Flash Freeze Technology
AGLE3000V5-FFG484 制造商:Microsemi Corporation 功能描述:FPGA IGLOOE 3M GATES 130NM 1.5V 484FBGA - Trays
AGLE3000V5-FFG896 制造商:Microsemi Corporation 功能描述:FPGA IGLOOE 3M GATES 130NM 1.5V 896FBGA - Trays
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*