- 您現在的位置：買賣IC網 > PDF目錄10904 > AMIS49587C5871RG (ON Semiconductor)IC MODEM PLC 50/60MHZ 28PLCC PDF資料下載
參數資料
| 型號： | AMIS49587C5871RG |
| 廠商： | ON Semiconductor |
| 文件頁數： | 55/55頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC MODEM PLC 50/60MHZ 28PLCC |
| 標準包裝： | 750 |
| 波特率： | 可選 |
| 電源電壓： | 3 V ~ 3.6 V |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 28-LCC（J 形引線） |
| 供應商設備封裝： | 28-PLCC（11.51x11.51） |
| 包裝： | 帶卷 (TR) |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁當前第55頁
AMIS49587
http://onsemi.com
9
TDO, TDI, TCK, TMS, and TRSTB
All these pins are part of the JTAG bus interface. The JTAG interface is used during production test of the IC and will not be
described here. Input pins (TDI, TCK, TMS, and TRSTB) contain internal pulldown resistance. TDO is an output. When not
used, the JTAG interface pins may be left floating.
TX_DATA/PRE_SLOT
TX_DATA/PRE_SLOT is the output for either the transmitting data (TX_DATA) or a synchronization signal with the
timeslots (PRE_SLOT). More information can be found in paragraph Local Port.
XIN
XIN is the analog input pin of the oscillator. It is connected to the interval oscillator inverter gain stage. The clock signal can
be created either internally with the external crystal and two capacitors or by connecting an external clock signal to XIN. For
the internal generation case, the two external capacitors and crystal are placed as shown in Figure 6. For the external clock
connection, the signal is connected to XIN and XOUT is left unused.
XTAL _IN
XTAL_ OUT
C X
V SSA
C X
R X
24 MHz
Figure 6. Placement of the Capacitors and Crystal with Clock Signal Generated Internally
The crystal is a classical parallel resonance crystal of 24 MHz. The values of the capacitors CX are given by the manufacturer
of the crystal. A typical value is 30 pF. The crystal has to fulfill impedance characteristics specified in the AMIS49587 data
sheet. As an oscillator is sensitive and precise, it is advised to put the crystal as close as possible on the board and to ground
the case.
XOUT
XOUT is the analog output pin of the oscillator. When the clock signal is provided from an external generator, this output must
be floating. When working with a crystal, this pin cannot be used directly as clock output because no additional loading is
allowed on the pin (limited voltage swing).
TXD
TXD is the digital output of the asynchronous serial communication (SCI) unit. Only halfduplex transmission is supported.
It is used to realize the communication between the AMIS49587 and the application microcontroller. The TXD is an open
drain IO (5 V safe). External pullup resistances (typically 10 k
W) are necessary to generate the 5 V level. See Figure 5 for
the circuit schematic.
RXD
This is the digital input of the asynchronous SCI unit.
Only halfduplex transmission is supported. This pin supports a 5 V level. It is used to realize the communication between the
AMIS49587 and the application microcontroller. RXD is a 5 V safe input.
T_REQ
T_REQ is the transmission request input of the Serial Communication Interface. When pulled low its initiate a local
communication from the application micro controller to AMIS49587. T_REQ is a 5 V safe input.
BR1, BR0
BR0 and BR1 are digital input pins. They are used to select the baud rate (bits/second) of the Serial Communication Interface
unit. The rate is defined according to Table 28: BR1, BR0 Baud Rates. The values are taken into account after a reset, hardware
or software. Modification of the baud rate during function is not possible. BR0 and BR1 are 5 V safe.
相關PDF資料 |
PDF描述 |
|---|---|
| AMIS49587C5872RG | IC MODEM PLC 50/60MHZ 52QFN |
| VI-J6B-IY-B1 | CONVERTER MOD DC/DC 95V 50W |
| NCN5192MNG | IC HART MODEM CMOS SGL 32QFN |
| VI-2N4-IX-F2 | CONVERTER MOD DC/DC 48V 75W |
| VI-26D-CV | CONVERTER MOD DC/DC 85V 150W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AMIS49587C5872G | 功能描述:電信線路管理 IC PLC MODEM 2400BAUD RoHS:否 制造商:STMicroelectronics 產品:PHY 接口類型:UART 電源電壓-最大:18 V 電源電壓-最小:8 V 電源電流:30 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:VFQFPN-48 封裝:Tray |
| AMIS49587C5872RG | 功能描述:電信線路管理 IC PLC MODEM 2400BAUD RoHS:否 制造商:STMicroelectronics 產品:PHY 接口類型:UART 電源電壓-最大:18 V 電源電壓-最小:8 V 電源電流:30 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:VFQFPN-48 封裝:Tray |
| AMIS49587GEVK | 功能描述:KIT EVALUATION AMIS49587 RoHS:是 類別:編程器，開發系統 >> 評估演示板和套件 系列:- 產品培訓模塊:Obsolescence Mitigation Program 標準包裝:1 系列:- 主要目的:電源管理，電池充電器 嵌入式:否 已用 IC / 零件:MAX8903A 主要屬性:1 芯鋰離子電池 次要屬性:狀態 LED 已供物品:板 |
| AMIS-50050 | 制造商:ON Semiconductor 功能描述:SPREAD SPECTRUM BASEBAND CNTRLR - Trays 制造商:ON Semiconductor 功能描述:SPREAD SPECTRUM BASEBAND CNTRLR - Tape and Reel |
| AMIS-50051 | 制造商:ON Semiconductor 功能描述:DMOD 32LQFP / - Trays 制造商:ON Semiconductor 功能描述:DMOD - Tape and Reel |
發布緊急采購，3分鐘左右您將得到回復。