參數資料
型號: AT32UC3A0128-ALUT
廠商: Atmel
文件頁數: 87/97頁
文件大?。?/td> 0K
描述: IC MCU AVR32 128KB FLASH 144LQFP
產品培訓模塊: AVR UC3 Audio Application
MCU Product Line Introduction
AVR EVK1105 Digital Audio Gateway Kit
AVR® UC3 Introduction
標準包裝: 300
系列: AVR®32 UC3 A0
核心處理器: AVR
芯體尺寸: 32-位
速度: 66MHz
連通性: EBI/EMI,以太網,I²C,SPI,SSC,UART/USART,USB OTG
外圍設備: 欠壓檢測/復位,POR,PWM,WDT
輸入/輸出數: 109
程序存儲器容量: 128KB(128K x 8)
程序存儲器類型: 閃存
RAM 容量: 32K x 8
電壓 - 電源 (Vcc/Vdd): 1.65 V ~ 1.95 V
數據轉換器: A/D 8x10b
振蕩器型: 內部
工作溫度: -40°C ~ 85°C
封裝/外殼: 144-LQFP
包裝: 托盤
配用: ATSTK600-RC33-ND - STK600 ROUTING CARD AVR
ATEVK1105-ND - KIT EVAL FOR AT32UC3A0
ATAVRONEKIT-ND - KIT AVR/AVR32 DEBUGGER/PROGRMMR
ATEVK1100-ND - KIT DEV/EVAL FOR AVR32 AT32UC3A
2006 Microchip Technology Inc.
DS70119E-page 87
dsPIC30F6010
15.1
PWM Time Base
The PWM time base is provided by a 15-bit timer with
a prescaler and postscaler. The time base is accessible
via the PTMR SFR. PTMR<15> is a Read Only Status
bit, PTDIR, that indicates the present count direction of
the PWM time base. If PTDIR is cleared, PTMR is
counting upwards. If PTDIR is set, PTMR is counting
downwards. The PWM time base is configured via the
PTCON SFR. The time base is enabled/disabled by
setting/clearing the PTEN bit in the PTCON SFR.
PTMR is not cleared when the PTEN bit is cleared in
software.
The PTPER SFR sets the counting period for PTMR.
The user must write a 15-bit value to PTPER<14:0>.
When the value in PTMR<14:0> matches the value in
PTPER<14:0>, the time base will either Reset to ‘0’, or
reverse the count direction on the next occurring clock
cycle. The action taken depends on the operating
mode of the time base.
The PWM time base can be configured for four different
modes of operation:
Free Running mode
Single Shot mode
Continuous Up/Down Count mode
Continuous Up/Down Count mode with interrupts
for double updates
These four modes are selected by the PTMOD<1:0>
bits in the PTCON SFR. The Up/Down Counting modes
support center-aligned PWM generation. The Single
Shot mode allows the PWM module to support pulse
control of certain Electronically Commutative Motors
(ECMs).
The interrupt signals generated by the PWM time base
depend on the mode selection bits (PTMOD<1:0>) and
the postscaler bits (PTOPS<3:0>) in the PTCON SFR.
15.1.1
FREE RUNNING MODE
In the Free Running mode, the PWM time base counts
upwards until the value in the Time Base Period regis-
ter (PTPER) is matched. The PTMR register is reset on
the following input clock edge and the time base will
continue to count upwards as long as the PTEN bit
remains set.
When the PWM time base is in the Free Running mode
(PTMOD<1:0> = 00), an interrupt event is generated
each time a match with the PTPER register occurs and
the PTMR register is reset to zero. The postscaler
selection bits may be used in this mode of the timer to
reduce the frequency of the interrupt events.
15.1.2
SINGLE SHOT MODE
In the Single Shot Counting mode, the PWM time base
begins counting upwards when the PTEN bit is set.
When the value in the PTMR register matches the
PTPER register, the PTMR register will be reset on the
following input clock edge and the PTEN bit will be
cleared by the hardware to halt the time base.
When the PWM time base is in the Single Shot mode
(PTMOD<1:0> = 01), an interrupt event is generated
when a match with the PTPER register occurs, the
PTMR register is reset to zero on the following input
clock edge, and the PTEN bit is cleared. The postscaler
selection bits have no effect in this mode of the timer.
15.1.3
CONTINUOUS UP/DOWN
COUNTING MODES
In the Continuous Up/Down Counting modes, the PWM
time base counts upwards until the value in the PTPER
register is matched. The timer will begin counting
downwards on the following input clock edge. The
PTDIR bit in the PTMR SFR is read only and indicates
the counting direction The PTDIR bit is set when the
timer counts downwards.
In the Up/Down Counting mode (PTMOD<1:0> = 10),
an interrupt event is generated each time the value of
the PTMR register becomes zero and the PWM time
base begins to count upwards. The postscaler selec-
tion bits may be used in this mode of the timer to reduce
the frequency of the interrupt events.
Note:
If the period register is set to 0x0000, the
timer will stop counting, and the interrupt
and the special event trigger will not be
generated, even if the special event value
is also 0x0000. The module will not update
the period register, if it is already at
0x0000; therefore, the user must disable
the module in order to update the period
register.
相關PDF資料
PDF描述
VJ2225A122KBBAT4X CAP CER 1200PF 100V 10% NP0 2225
VJ2225A122KBCAT4X CAP CER 1200PF 200V 10% NP0 2225
VJ2225A182JBAAT4X CAP CER 1800PF 50V 5% NP0 2225
VJ2225A182JBBAT4X CAP CER 1800PF 100V 5% NP0 2225
ZX10-B-SLDA SHIELD PLATE TOP FOR ZX10 PLUG
相關代理商/技術參數
參數描述
AT32UC3A0128AU-ALUT 功能描述:32位微控制器 - MCU 128KB Flash Audio 85Deg RoHS:否 制造商:Texas Instruments 核心:C28x 處理器系列:TMS320F28x 數據總線寬度:32 bit 最大時鐘頻率:90 MHz 程序存儲器大小:64 KB 數據 RAM 大小:26 KB 片上 ADC:Yes 工作電源電壓:2.97 V to 3.63 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:LQFP-80 安裝風格:SMD/SMT
AT32UC3A0128-CTUR 功能描述:32位微控制器 - MCU 128KB, 144FBGA Ind, w/AES Mod. RoHS:否 制造商:Texas Instruments 核心:C28x 處理器系列:TMS320F28x 數據總線寬度:32 bit 最大時鐘頻率:90 MHz 程序存儲器大小:64 KB 數據 RAM 大小:26 KB 片上 ADC:Yes 工作電源電壓:2.97 V to 3.63 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:LQFP-80 安裝風格:SMD/SMT
AT32UC3A0128-CTUT 功能描述:32位微控制器 - MCU 128KB, 144FBGA Ind, w/AES Mod. RoHS:否 制造商:Texas Instruments 核心:C28x 處理器系列:TMS320F28x 數據總線寬度:32 bit 最大時鐘頻率:90 MHz 程序存儲器大小:64 KB 數據 RAM 大小:26 KB 片上 ADC:Yes 工作電源電壓:2.97 V to 3.63 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:LQFP-80 安裝風格:SMD/SMT
AT32UC3A0256 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:AVR32 32-Bit Microcontroller
AT32UC3A0256-ALUR 功能描述:32位微控制器 - MCU 256KB, 144LQFP 85deg. Green RoHS:否 制造商:Texas Instruments 核心:C28x 處理器系列:TMS320F28x 數據總線寬度:32 bit 最大時鐘頻率:90 MHz 程序存儲器大小:64 KB 數據 RAM 大小:26 KB 片上 ADC:Yes 工作電源電壓:2.97 V to 3.63 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:LQFP-80 安裝風格:SMD/SMT