參數資料
型號: AT89C5131A-PUTIM
廠商: Atmel
文件頁數: 20/176頁
文件大?。?/td> 0K
描述: IC 8051 MCU FLASH 32K USB 32QFN
標準包裝: 260
系列: AT89C513x
核心處理器: C52X2
芯體尺寸: 8-位
速度: 48MHz
連通性: I²C,SPI,UART/USART,USB
外圍設備: LED,POR,PWM,WDT
輸入/輸出數: 18
程序存儲器容量: 32KB(32K x 8)
程序存儲器類型: 閃存
EEPROM 大?。?/td> 4K x 8
RAM 容量: 1.25K x 8
電壓 - 電源 (Vcc/Vdd): 2.7 V ~ 5.5 V
振蕩器型: 內部
工作溫度: -40°C ~ 85°C
封裝/外殼: 32-VQFN 裸露焊盤
包裝: 托盤
配用: AT89STK-10-ND - KIT EVAL APPL MASS STORAGE
AT89STK-05-ND - KIT STARTER FOR AT89C5131
114
AT89C5131
4136C–USB–04/05
USB Controller
Introduction
The AT89C5131 implements a USB device controller supporting full speed data transfer
in accordance with the USB 1.1 and 2.0 Specifications. In addition to the default control
endpoint 0, it provides 6 other endpoints, which can be configured in control, bulk, inter-
rupt or isochronous modes:
Endpoint 0:32-byte FIFO, default control endpoint
Endpoint 1, 2, 3: 32-byte FIFO
Endpoint 4, 5: 2 x 64-byte Ping-pong FIFO
Endpoint 6: 2 x 512-byte Ping-pong FIFO
This allows the firmware to be developed conforming to most USB device classes, for
example:
USB Mass Storage Class Control/Bulk/Interrupt (CBI) Transport, Revision 1.0 -
December 14, 1998
USB Mass Storage Class Bulk-only Transport, Revision 1.0 - September 31, 1999
USB Human Interface Device Class, Version 1.1 - April 7, 1999
USB Device Firmware Upgrade Class, Revision 1.0 - May 13, 1999
USB Mass Storage Classes
USB Mass Storage Class CBI
Transport
Within the CBI framework, the control endpoint is used to transport command blocks as
well as to transport standard USB requests. One Bulk-out endpoint is used to transport
data from the host to the device. One Bulk-in endpoint is used to transport data from the
device to the host. And one interrupt endpoint may also be used to signal command
completion (protocol 0) but it is optional and may not be used (protocol 1).
The following configuration adheres to these requirements:
Endpoint 0: 8 bytes, Control In-Out
Endpoint 4: 64 bytes, Bulk-out
Endpoint 5: 64 bytes, Bulk-in
Endpoint 3: 8 bytes, Interrupt In
USB Mass Storage Class Bulk-
only Transport
Within the Bulk-only framework, the Control endpoint is only used to transport class-
specific and standard USB requests for device set-up and configuration. One Bulk-out
endpoint is used to transport commands and data from the host to the device. One Bulk-
in endpoint is used to transport status and data from the device to the host. No interrupt
endpoint is needed.
The following configuration adheres to these requirements:
Endpoint 0: 8 bytes, Control In-Out
Endpoint 4: 64 bytes, Bulk-out
Endpoint 5: 64 bytes, Bulk-in
Endpoint 3: not used
相關PDF資料
PDF描述
AT89C5131A-TISIL IC 8051 MCU FLASH 32K USB 28SOIC
AT89C5132-RORUL MCU 8051 FLASH USB 80TQFP
AT89C51AC3-SLSIM IC 8051 MCU FLASH 64K 44PLCC
AT89C51CC03C-RLRIM IC 8051 MCU FLASH 64K 44VQFP
AT89C51ED2-SMRUM IC MCU FLASH 8051 64K 5V 68PLCC
相關代理商/技術參數
參數描述
AT89C5131A-PUTUM 功能描述:8位微控制器 -MCU C5130A 32K Flash USB RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
AT89C5131A-RDTIL 功能描述:IC 8051 MCU FLASH 32K USB 64VQFP RoHS:否 類別:集成電路 (IC) >> 嵌入式 - 微控制器, 系列:AT89C513x 標準包裝:9 系列:87C 核心處理器:8051 芯體尺寸:8-位 速度:40/20MHz 連通性:UART/USART 外圍設備:POR,WDT 輸入/輸出數:32 程序存儲器容量:32KB(32K x 8) 程序存儲器類型:OTP EEPROM 大小:- RAM 容量:256 x 8 電壓 - 電源 (Vcc/Vdd):4.5 V ~ 5.5 V 數據轉換器:- 振蕩器型:內部 工作溫度:0°C ~ 70°C 封裝/外殼:40-DIP(0.600",15.24mm) 包裝:管件
AT89C5131A-RDTIM 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:8-bit Flash Microcontroller with Full Speed USB Device
AT89C5131A-RDTUL 功能描述:8位微控制器 -MCU 32K Flash 3V USB RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
AT89C5131A-RDTUM 功能描述:8位微控制器 -MCU C5130A 32K Flash RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT