參數資料
型號： AT89S8253-24JI
廠商： Atmel
文件頁數： 2/60頁
文件大?。?/td> 0K
描述： IC 8051 MCU FLASH 12K 44PLCC
標準包裝： 27
系列： 89S
核心處理器： 8051
芯體尺寸： 8-位
速度： 24MHz
連通性： SPI，UART/USART
外圍設備： POR，WDT
輸入/輸出數： 32
程序存儲器容量： 12KB（12K x 8）
程序存儲器類型： 閃存
EEPROM 大?。?/td> 2K x 8
RAM 容量： 256 x 8
電壓 - 電源 (Vcc/Vdd)： 2.7 V ~ 5.5 V
振蕩器型： 內部
工作溫度： -40°C ~ 85°C
封裝/外殼： 44-LCC（J 形引線）
包裝： 管件
10
3286P–MICRO–3/10
AT89S8253
In addition, during EEPROM programming, an attempted read from the EEPROM will fetch the
byte being written with the MSB complemented. Once the write cycle is completed, true data are
valid at all bit locations.
6.1
Memory Control Register
The EECON register contains control bits for the 2K bytes of on-chip data EEPROM. It also con-
tains the control bit for the dual data pointer.
Figure 6-1.
Data EEPROM Write Sequence
Table 6-1.
EECON – Data EEPROM Control Register
EECON Address = 96H
Reset Value = XX00 0011B
Not Bit Addressable
Bit
–
EELD
EEMWE
EEMEN
DPS
RDY/BSY
WRTINH
7
654
32
1
0
Symbol
Function
EELD
EEPROM data memory load enable bit. Used to implement Page Mode Write. A MOVX instruction writing into the data
EEPROM will not initiate the programming cycle if this bit is set, rather it will just load data into the volatile data buffer of
the data EEPROM memory. Before the last MOVX, reset this bit and the data EEPROM will program all the bytes
previously loaded on the same page of the address given by the last MOVX instruction.
EEMWE
EEPROM data memory write enable bit. Set this bit to 1 before initiating byte write to on-chip EEPROM with the MOVX
instruction. User software should set this bit to 0 after EEPROM write is completed.
EEMEN
Internal EEPROM access enable. When EEMEN = 1, the MOVX instruction with DPTR will access on-chip EEPROM
instead of external data memory if the address used is less than 2K. When EEMEN = 0 or the address used is
≥ 2K,
MOVX with DPTR accesses external data memory.
DPS
Data pointer register select. DPS = 0 selects the first bank of data pointer register, DP0, and DPS = 1 selects the
second bank, DP1.
RDY/BSY
RDY/BSY (Ready/Busy) flag for the data EEPROM memory. This is a read-only bit which is cleared by hardware during
the programming cycle of the on-chip EEPROM. It is also set by hardware when the programming is completed. Note
that RDY/BSY will be cleared long after the completion of the MOVX instruction which has initiated the programming
cycle.
WRTINH
WRTINH (Write Inhibit) is a READ-ONLY bit which is cleared by hardware when V
cc is too low for the programming cycle
of the on-chip EEPROM to be executed. When this bit is cleared, an ongoing programming cycle will be aborted or a
new programming cycle will not start.
01
2
330
31
EEMWE
EEMEN
EELD
MOVX DATA
RDY/BSY
4 ms
~
相關PDF資料
PDF描述
AT89S8253-24JC IC 8051 MCU FLASH 12K 44PLCC
213931-2 CONN RCPT 34POS W/CABLE HARDWARE
213932-3 M-SERIES KIT,V.35,34P,UNASSM
AT89S8253-24AI IC 8051 MCU FLASH 12K 44TQFP
AT89S8253-24AC IC 8051 MCU FLASH 12K 44TQFP
相關代理商/技術參數
參數描述
AT89S8253-24JU 功能描述:8位微控制器 -MCU 12kB Flash 256B RAM 2.7V-5.5V RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
AT89S8253-24JU SL383 制造商:Atmel Corporation 功能描述:MCU 8-bit AT89 80C51 CISC 12KB Flash 3.3V/5V 44-Pin PLCC T/R
AT89S8253-24JU SL928 制造商:Atmel Corporation 功能描述:PLCC REVIS 'R' - Rail/Tube
AT89S8253-24JU@SL383 制造商:Adesto Technologies Corporation 功能描述:
AT89S8253-24PC 功能描述:8位微控制器 -MCU Microcontroller RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*