376
6175H–ATARM–03-Dec-07
AT91SAM7S Series Preliminary
31.6.7
AT91SAM7S512/256/128/64/321/161 Modem Mode
The USART features modem mode, which enables control of the signals: DTR (Data Terminal
Ready), DSR (Data Set Ready), RTS (Request to Send), CTS (Clear to Send), DCD (Data Car-
rier Detect) and RI (Ring Indicator). While operating in modem mode, the USART behaves as a
DTE (Data Terminal Equipment) as it drives DTR and RTS and can detect level change on DSR,
DCD, CTS and RI.
Setting the USART in modem mode is performed by writing the USART_MODE field in the Mode
Register (US_MR) to the value 0x3. While operating in modem mode the USART behaves as
though in asynchronous mode and all the parameter configurations are available.
Table 31-11 gives the correspondence of the USART signals with modem connection standards.
The control of the DTR output pin is performed by writing the Control Register (US_CR) with the
DTRDIS and DTREN bits respectively at 1. The disable command forces the corresponding pin
to its inactive level, i.e. high. The enable command forces the corresponding pin to its active
level, i.e. low. RTS output pin is automatically controlled in this mode
The level changes are detected on the RI, DSR, DCD and CTS pins. If an input change is
detected, the RIIC, DSRIC, DCDIC and CTSIC bits in the Channel Status Register (US_CSR)
are set respectively and can trigger an interrupt. The status is automatically cleared when
US_CSR is read. Furthermore, the CTS automatically disables the transmitter when it is
detected at its inactive state. If a character is being transmitted when the CTS rises, the charac-
ter transmission is completed before the transmitter is actually disabled.
31.6.8
Test Modes
The USART can be programmed to operate in three different test modes. The internal loopback
capability allows on-board diagnostics. In the loopback mode the USART interface pins are dis-
connected or not and reconfigured for loopback internally or externally.
31.6.8.1
Normal Mode
Normal mode connects the RXD pin on the receiver input and the transmitter output on the TXD
pin.
Table 31-11. Circuit References
USART Pin
V24
CCITT
Direction
TXD
2
103
From terminal to modem
RTS
4
105
From terminal to modem
DTR
20
108.2
From terminal to modem
RXD
3
104
From modem to terminal
CTS
5
106
From terminal to modem
DSR
6
107
From terminal to modem
DCD
8
109
From terminal to modem
RI
22
125
From terminal to modem