- 您現在的位置：買賣IC網 > PDF目錄223461 > BU-61703G4-152Y (DATA DEVICE CORP) 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, MQFP72 PDF資料下載
參數資料
| 型號： | BU-61703G4-152Y |
| 廠商： | DATA DEVICE CORP |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, MQFP72 |
| 封裝： | 1 X 1 INCH, GULL WING, PACKAGE-72 |
| 文件頁數： | 52/52頁 |
| 文件大小： | 367K |
| 代理商： | BU-61703G4-152Y |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁當前第52頁
9
MIL-STD-1553A*/B
(-B is logic "1", or the
default).
POWER-UP SELF-
TEST ENABLE
BURST MODE
SUBADDRESS 30
WRAPAROUND
RTFAIL-to-TERMINAL
FLAG AUTO-WRAP
RT GOES ONLINE IF
SELF-TEST FAILS
FUNCTION
In MIL-STD-1553B mode, subaddress
31 is a mode code subaddress, and
mode codes are implemented in full
accordance with MIL-STD-1553B. In
MIL-STD-1553A mode, subaddress 31
is a non-mode code subaddress, and no
data words are transmitted or anticipat-
ed to be received for mode code mes-
sages.
If enabled, the SSRT will perform self-
test following the rising edge of MST-
CLR*.
0
Enables burst mode (using the internal
FIFO) for received data words. In burst
mode, for a receive message, all data
words are transferred to the external
system in a contiguous burst following
reception of the last data word.
1
Subaddress 30 wraparound is enabled.
That is, the data words for a receive
message to subaddress 30 are stored in
the internal FIFO, and not transferred to
the external system. For a subsequent
transmit message to subaddress 30, the
transmitted data words are read from
the internal FIFO, rather than from the
external system.
2
If the loop test fails for a particular mes-
sage, the Terminal flag bit will be set in
the SSRT's status response for the sub-
sequent non-broadcast message.
4
If logic "0", the RT will become enabled
only if the self-test passes. If auto-config
is not used, or if this bit is logic "1", or if
the power-up self-test passes, then the
RT will go online following self-test.
5
DESCRIPTION
BIT
3
TABLE 2. AUTO-CONFIGURATION PARAMETERS
0
1
0
CLK_SEL_0
12 MHz
16 MHz
1
20 MHz
0
10 MHz
0
CLOCK FREQUENCY
CLK_SEL_1
1
TABLE 3. CLOCK FREQUENCY SELECTION
CLOCK INPUT
The SSRT may be operated from one of four clock frequencies:
10, 12, 16, or 20 MHz. The selected clock frequency must be des-
ignated by means of the input signals CLK_SEL_1 and
CLK_SEL_0, as shown in Table 3.
AUTO-CONFIGURATION
The SSRT includes an auto-configuration feature, which allows
various optional features to be enabled or disabled. Auto-configu-
ration may be enabled or disabled by means of the input signal
. If
is connected to logic "1", then the
auto-configure option is disabled, and the six configuration para-
meters revert to their default values.
Note that the default condition for each configuration para-
meter is enabled (for the MIL-STD-1553A/B protocol selection, -
1553B is the default).
If
is connected to logic "0", then the configuration
parameters are transferred over D5-D0 by means of a DMA read
data transfer. The transfer occurs during the time that the
RTACTIVE
and
outputs are logic "0", following
transitioning from logic "0" to logic "1" and a successful
-to-
handshake.
Note that if
is hardwired to logic "0", the handshake
process is not necessary (i.e.,
and RTACTIVE will both
be asserted to logic "0" one clock cycle following
).
Each of the configuration parameters is enabled if the SSRT
reads a value of logic "1" for the respective data bit.
The auto-configuration parameters are defined by Table 2.
The timing signals pertaining to Auto-Configuration mode are
illustrated in FIGURE 12.
REQ
_
DT
DTACK
DTGRT
REQ
_
DT
MSTCLR
DTACK
CFG
_
AUTO
CFG
_
AUTO
CFG
_
AUTO
相關PDF資料 |
PDF描述 |
|---|---|
| BU-61703G4-152 | 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, MQFP72 |
| BU-61703G4-162Q | 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, MQFP72 |
| BU-61703G4-162S | 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, MQFP72 |
| BU-61703G4-172K | 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, MQFP72 |
| BU-61703G4-172Q | 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, MQFP72 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| BU-61705 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:MIL-STD-1553 Components |Simple System RT |
| BU-61740B3NEW | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:MIL-STD-1553 Components |μ-ACE (Micro-ACE?) |
| BU-61743 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:MIL-STD-1553 Components |Enhanced Mini-ACE? |
| BU-61743F3-100 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Telecommunication IC |
| BU-61743F3-110 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Telecommunication IC |
發布緊急采購，3分鐘左右您將得到回復。