參數資料
型號: C8051F011
廠商: Silicon Laboratories Inc
文件頁數: 43/171頁
文件大小: 0K
描述: IC 8051 MCU 32K FLASH 48TQFP
標準包裝: 250
系列: C8051F01x
核心處理器: 8051
芯體尺寸: 8-位
速度: 20MHz
連通性: SMBus(2 線/I²C),SPI,UART/USART
外圍設備: 欠壓檢測/復位,POR,PWM,溫度傳感器,WDT
輸入/輸出數: 16
程序存儲器容量: 32KB(32K x 8)
程序存儲器類型: 閃存
RAM 容量: 256 x 8
電壓 - 電源 (Vcc/Vdd): 2.7 V ~ 3.6 V
數據轉換器: A/D 8x10b; D/A 2x12b
振蕩器型: 內部
工作溫度: -40°C ~ 85°C
封裝/外殼: 48-TQFP
包裝: 托盤
C8051F000/1/2/5/6/7
C8051F010/1/2/5/6/7
Figure 18.9. SCON: Serial Port Control Register
R/W
Reset Value
SM0
SM1
SM2
REN
TB8
RB8
TI
RI
00000000
Bit7
Bit6
Bit5
Bit4
Bit3
Bit2
Bit1
Bit0
SFR Address:
(bit addressable)
0x98
Bits7-6: SM0-SM1: Serial Port Operation Mode.
These bits select the Serial Port Operation Mode.
SM0
SM1
Mode
0
Mode 0: Synchronous Mode
0
1
Mode 1: 8-Bit UART, Variable Baud Rate
1
0
Mode 2: 9-Bit UART, Fixed Baud Rate
1
Mode 3: 9-Bit UART, Variable Baud Rate
Bit5:
SM2: Multiprocessor Communication Enable.
The function of this bit is dependent on the Serial Port Operation Mode.
Mode 0: No effect
Mode 1: Checks for valid stop bit.
0: Logic level of stop bit is ignored.
1: RI will only be activated if stop bit is logic level 1.
Mode 2 and 3: Multiprocessor Communications Enable.
0: Logic level of ninth bit is ignored.
1: RI is set and an interrupt is generated only when the ninth bit is logic 1.
Bit4:
REN: Receive Enable.
This bit enables/disables the UART receiver.
0: UART reception disabled.
1: UART reception enabled.
Bit3:
TB8: Ninth Transmission Bit.
The logic level of this bit will be assigned to the ninth transmission bit in Modes 2 and 3. It
is not used in Modes 0 and 1. Set or cleared by software as required.
Bit2:
RB8: Ninth Receive Bit.
The bit is assigned the logic level of the ninth bit received in Modes 2 and 3. In Mode 1, if
SM2 is logic 0, RB8 is assigned the logic level of the received stop bit. RB8 is not used in
Mode 0.
Bit1:
TI: Transmit Interrupt Flag.
Set by hardware when a byte of data has been transmitted by the UART (after the 8
th bit in
Mode 0, or at the beginning of the stop bit in other modes). When the UART interrupt is
enabled, setting this bit causes the CPU to vector to the UART interrupt service routine.
This bit must be cleared manually by software
Bit0:
RI: Receive Interrupt Flag.
Set by hardware when a byte of data has been received by the UART (after the 8
th bit in
Mode 0, or after the stop bit in other modes – see SM2 bit for exception). When the
UART interrupt is enabled, setting this bit causes the CPU to vector to the UART interrupt
service routine. This bit must be cleared manually by software.
137
Rev. 1.7
相關PDF資料
PDF描述
C8051F010 IC 8051 MCU 32K FLASH 64TQFP
PIC32MX675F256L-80V/PF IC MCU 32BIT 256KB FLASH 100TQFP
C8051F006 IC 8051 MCU 32K FLASH 48TQFP
C8051F005 IC 8051 MCU 32K FLASH 64TQFP
C8051F002 IC 8051 MCU 32K FLASH 32LQFP
相關代理商/技術參數
參數描述
C8051F011-GQ 功能描述:8位微控制器 -MCU 32KB 10ADC 48P MCU RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
C8051F011-GQR 功能描述:8位微控制器 -MCU 32KB 10ADC 48Pin MCU Tape and Reel RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
C8051F011R 功能描述:8位微控制器 -MCU C 10Bit 48Pin RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
C8051F012 功能描述:8位微控制器 -MCU 32KB 10ADC RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
C8051F012/005 制造商:Silicon Laboratories Inc 功能描述: