- 您現在的位置：買賣IC網 > PDF目錄17062 > CDB4352 (Cirrus Logic Inc)BOARD EVAL FOR CS4352 DAC PDF資料下載
參數資料
| 型號： | CDB4352 |
| 廠商： | Cirrus Logic Inc |
| 文件頁數： | 6/20頁 |
| 文件大?。?/td> | 0K |
| 描述： | BOARD EVAL FOR CS4352 DAC |
| 標準包裝： | 1 |
| 系列： | Popguard® |
| DAC 的數量： | 2 |
| 位數： | 24 |
| 采樣率（每秒）： | 192k |
| 數據接口： | 串行 |
| DAC 型： | 電壓 |
| 工作溫度： | -40°C ~ 85°C |
| 已供物品： | 板 |
| 已用 IC / 零件： | CS4352 |
| 產品目錄頁面： | 757 (CN2011-ZH PDF) |
| 相關產品： | CS4352-DZZR-ND - IC DAC STER 102DB 192KHZ 20TSSOP CS4352-DZZ-ND - IC DAC STER 102DB 192KHZ 20TSSOP CS4352-CZZR-ND - IC DAC STER 102DB 192KHZ 20TSSOP 598-1186-5-ND - IC DAC STER 102DB 192KHZ 20TSSOP |
| 其它名稱： | 598-1518 |
14
DS684F2
CS4352
4.7
Popguard Transient Control
The CS4352 uses a novel technique to minimize the effects of output transients during power-up and power-
down. This technology, when used with external DC-blocking capacitors in series with the audio outputs,
minimizes the audio transients commonly produced by single-ended, single-supply converters. It is activat-
ed inside the DAC when the RST pin is toggled and requires no other external control, aside from choosing
the appropriate DC-blocking capacitors.
4.7.1
Power-Up
When the device is initially powered-up, the audio outputs, AOUTA and AOUTB, are clamped to GND.
Following a delay of approximately 1000 sample periods, each output begins to ramp toward the quies-
cent voltage. Approximately 10,000 LRCK cycles later, the outputs reach VQ and audio output begins.
This gradual voltage ramping allows time for the external DC-blocking capacitors to charge to the quies-
cent voltage, minimizing audible power-up transients.
4.7.2
Power-Down
To prevent audible transients at power-down, the device must first enter its power-down state. When this
occurs, audio output ceases, and the internal output buffers are disconnected from AOUTA and AOUTB.
In their place, a soft-start current sink is substituted that allows the DC-blocking capacitors to slowly dis-
charge. Once this charge is dissipated, the power to the device may be turned off, and the system is ready
for the next power-on.
4.7.3
Discharge Time
To prevent an audio transient at the next power-on, the DC-blocking capacitors must fully discharge be-
fore turning on the power or exiting the power-down state. If full discharge does not occur, a transient will
occur when the audio outputs are initially clamped to GND. The time that the device must remain in the
power-down state is related to the value of the DC-blocking capacitance and the output load. For example,
with a 3.3 F capacitor, the minimum power-down time will be approximately 0.4 seconds.
4.8
Mute Control
The Mute Control pins go active during power-up initialization, reset, muting, or if the MCLK to LRCK ratio
is incorrect. These pins are intended to be used as control for external mute circuits to prevent the clicks
and pops that can occur in any single-ended, single-supply system.
Use of the Mute Control function is not mandatory but recommended for designs requiring the absolute min-
imum in extraneous clicks and pops. Also, use of the Mute Control function can enable the system designer
to achieve idle channel noise/signal-to-noise ratios which are only limited by the external mute circuit.
Please see the CDB4352 data sheet for a suggested mute circuit for dual-supply systems. Alternately, the
FET muting circuit from the CS4351 data sheet may be used as well. This FET circuit must be placed in
series after the RC filter; otherwise noise may occur during muting conditions. Further ESD protection will
need to be taken into consideration for the FET used.
相關PDF資料 |
PDF描述 |
|---|---|
| VI-B1J-EY | CONVERTER MOD DC/DC 36V 50W |
| RCM12DTKI | CONN EDGECARD 24POS DIP .156 SLD |
| GBM22DCCS-S189 | CONN EDGECARD 44POS R/A .156 SLD |
| MIC2013-1.2YML TR | IC DISTRIBUTION SW 1.2A 6-MLF |
| GSA10DRMD-S288 | CONN EDGECARD 20POS .125 EXTEND |
相關代理商/技術參數 |
參數描述 |
|---|---|
| CDB4353 | 功能描述:音頻 IC 開發工具 3.3V Str DAC w/2Vrms line out Eval Bd RoHS:否 制造商:Texas Instruments 產品:Evaluation Kits 類型:Audio Amplifiers 工具用于評估:TAS5614L 工作電源電壓:12 V to 38 V |
| CDB4354 | 功能描述:音頻 IC 開發工具 Eval Board 5V DAC w/ 2Vrms line driver RoHS:否 制造商:Texas Instruments 產品:Evaluation Kits 類型:Audio Amplifiers 工具用于評估:TAS5614L 工作電源電壓:12 V to 38 V |
| CDB4360 | 功能描述:音頻 IC 開發工具 Eval Bd 102dB 192kHz 6-Ch DAC RoHS:否 制造商:Texas Instruments 產品:Evaluation Kits 類型:Audio Amplifiers 工具用于評估:TAS5614L 工作電源電壓:12 V to 38 V |
| CDB4361 | 功能描述:音頻 IC 開發工具 Eval Bd 105dB 192kHz 6-Ch DAC RoHS:否 制造商:Texas Instruments 產品:Evaluation Kits 類型:Audio Amplifiers 工具用于評估:TAS5614L 工作電源電壓:12 V to 38 V |
| CDB4362 | 制造商:Cirrus Logic 功能描述:Tools Development kit Kit Con |
發布緊急采購，3分鐘左右您將得到回復。