- 您現在的位置：買賣IC網 > PDF目錄1908 > CPC5712U (IXYS Integrated Circuits Division)PHONE LINE MON W/DETECTOR 16QSOP PDF資料下載
參數資料
| 型號： | CPC5712U |
| 廠商： | IXYS Integrated Circuits Division |
| 文件頁數： | 10/11頁 |
| 文件大小： | 0K |
| 描述： | PHONE LINE MON W/DETECTOR 16QSOP |
| 標準包裝： | 100 |
| 功能： | 電話線監控器，帶檢測器（PLMD） |
| 電路數： | 1 |
| 電源電壓： | 3 V ~ 5.5 V |
| 電流 - 電源： | 1.72mA |
| 功率（瓦特）： | 50mW |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 16-SSOP（0.154"，3.90mm 寬） |
| 供應商設備封裝： | 16-SOP |
| 包裝： | 管件 |
| 包括： | 固定電平極性檢測器，電平檢測器 |
INTEGRATED CIRCUITS DIVISION
CPC5712
8
www.ixysic.com
R02
3.1 Line Interface
Between the CPC5712 and the TIP/RING line is a
high impedance resistive divider network that provides
sufficient impedance to meet the barrier insulation
specifications in safety regulations and comply with
the on-hook DC leakage to ground requirements from
the various network compatibility specifications.
To ensure regulatory compliance, a 20M
or greater
resistance is required from the individual TIP and
RING leads to the IN+ and IN- inputs. For most
applications where the tip and ring interface does not
have a ground referenced surge protector, Clare
recommends using two 1206-size 10M
resistors in
series to provide the minimum impedance and to meet
surge requirements. Resistors having a smaller
physical footprint may be used when ground
referenced surge protection is available.
In practice, each 1206-size resistor is capable of
withstanding the 2000V peak waveforms typical of
lightning surges on the phone line. Hence, two 1206
resistors can withstand 4000V lightning pulses.
3.2 Differential Input Resistor
The differential input resistor placed across the IN+
and IN- inputs provides two functions.
From the application perspective, this component
provides a scaled down representation of the tip and
ring line voltage to the CPC5712 inputs. The voltage
applied to the inputs is easily calculated because it is
derived from a simple resistive divider comprising the
tip and ring input resistors and the differential input
resistor.
For improved performance, the CPC5712 signal path
is trimmed at the factory to reduce comparator
detection errors caused by offset currents and
voltages. The CPC5712’s input offset effects are
reduced by trimming the device with an 806k
input
resistor. Using any other value resistor at the inputs
negates the trim and introduces offset errors.
3.3 Voltage Detector Design
From the application requirements given above, the
desired LIU detector threshold voltages are therefore:
V
H2 = 15V
V
L2 = 12V
and the detector thresholds for the LOOP detector are:
V
H1 = 5V
V
L1 = 3V
3.3.1 Calculate Resistor Values
From the design equations provided in
page 6 this gives:
R1=R1
R2=0.666667 R1
R3=2.333333 R1
R4=R1
R5=5.125558 R1
Summing these equations provides the following
result:
R1+R2+R3+R4+R5 = 10.12556 R1
and since this sum is bound by:
20k
< (R1 + R2 + R3 + R4 + R5) < 1M
this reduces to: 20k
< (10.12556 R1) < 1M
Taking into account the additional constraint of resistor
tolerance, 1% in this example, the range of allowable
values for R1 is further reduced and becomes:
1.995k
< R1 < 97.782k permitting a value
for R1 to be chosen.
Selecting a standard value from the E96, 1% table for
R1 of 26.7k
the calculated values for the remaining
resistors becomes:
R2=17.8k
R3=62.3k
R4=26.7k
R5=136.85k
Since the calculated values of R3 and R5 are not
standard values, a reasonable compromise for these
resistors is: R3=61.9k
, R5=137k. See Figure 1.
相關PDF資料 |
PDF描述 |
|---|---|
| CPC7220W | IC ANALOG SWITCH 8CH HV 28-PLCC |
| CPC7232W | IC ANALOG SWITCH 8CH HV 28-PLCC |
| CPC7514Z | IC LINE CARD ACCESS SWITC 20SOIC |
| CS4121ENF16G | IC TACH/SPEEDO DRIVER 16-DIP |
| CS4122XDWF24G | IC DRIVER AIR CORE TRPL 24-SOIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| CPC5712UTR | 功能描述:固態繼電器-PCB安裝 Phone Line Monitor,T/R RoHS:否 制造商:Omron Electronics 控制電壓范圍: 負載電壓額定值:40 V 負載電流額定值:120 mA 觸點形式:1 Form A (SPST-NO) 輸出設備:MOSFET 封裝 / 箱體:USOP-4 安裝風格:SMD/SMT |
| CPC5750U | 功能描述:Telecom IC CODEC 24-SSOP 制造商:ixys integrated circuits division 系列:- 包裝:管件 零件狀態:有效 功能:CODEC 接口:SPI 電路數:1 電壓 - 電源:3 V ~ 3.6 V 電流 - 電源:7.5mA 功率（W）:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:24-SSOP（0.154"，3.90mm 寬） 供應商器件封裝:24-SSOP 包括:- 標準包裝:50 |
| CPC5750UTR | 功能描述:IC VOICE BAND CODEC 24SSOP 制造商:ixys integrated circuits division 系列:- 包裝:帶卷（TR） 零件狀態:在售 功能:CODEC 接口:SPI 電路數:1 電壓 - 電源:3 V ~ 3.6 V 電流 - 電源:7.5mA 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:24-SSOP（0.154"，3.90mm 寬） 供應商器件封裝:24-SSOP 包括:- 標準包裝:2,000 |
| CPC5902G | 功能描述:ISOLAT 3.75KVRMS 2CH BIDIR 8DIP RoHS:是 類別:隔離器 >> 光隔離器 - 邏輯輸出 系列:- 標準包裝:1,000 系列:- 電壓 - 隔離:3750Vrms 通道數:1，單向 電流 - 輸出 / 通道:50mA 數據速率:15MBd 傳輸延遲高 - 低 @ 如果:50ns @ 7.5mA 電流 - DC 正向(If):20mA 輸入類型:DC 輸出類型:開路集電極 安裝類型:表面貼裝 封裝/外殼:8-SMD，鷗翼型 供應商設備封裝:8-DIP 鷗翼型 包裝:帶卷 (TR) |
| CPC5902G_5903G-EVAL | 功能描述:CPC5902, CPC5903 - Interface, Buffer/Repeater Evaluation Board 制造商:ixys integrated circuits division 系列:- 零件狀態:有效 主要用途:接口，緩沖器/中繼器 嵌入式:- 使用的 IC/零件:CPC5902，CPC5903 主要屬性:隔離 輔助屬性:- 所含物品:板 標準包裝:1 |
發布緊急采購，3分鐘左右您將得到回復。