- 您現在的位置：買賣IC網 > PDF目錄9625 > CY28442ZXC-2T (Silicon Laboratories Inc)IC CLOCK ALVISO PENTM 56TSSOP PDF資料下載
參數資料
| 型號： | CY28442ZXC-2T |
| 廠商： | Silicon Laboratories Inc |
| 文件頁數： | 13/19頁 |
| 文件大小： | 0K |
| 描述： | IC CLOCK ALVISO PENTM 56TSSOP |
| 標準包裝： | 2,000 |
| 類型： | 時鐘/頻率發生器 |
| PLL： | 是 |
| 主要目的： | Intel CPU 服務器 |
| 輸入： | LVTTL，晶體 |
| 輸出： | HCSL，LVCMOS |
| 電路數： | 1 |
| 比率 - 輸入:輸出： | 3:20 |
| 差分 - 輸入:輸出： | 無/是 |
| 頻率 - 最大： | 200MHz |
| 電源電壓： | 3.135 V ~ 3.465 V |
| 工作溫度： | 0°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 56-TFSOP（0.240"，6.10mm 寬） |
| 供應商設備封裝： | 56-TSSOP |
| 包裝： | 帶卷 (TR) |
| 其它名稱： | SLCY28442ZXC-2T |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁當前第13頁第14頁第15頁第16頁第17頁第18頁第19頁
CY28442-2
....................... Document #: 38-07691 Rev. *B Page 3 of 19
Frequency Select Pins (FS_A, FS_B, and FS_C)
Host clock frequency selection is achieved by applying the
appropriate logic levels to FS_A, FS_B, FS_C inputs prior to
VTT_PWRGD# assertion (as seen by the clock synthesizer).
Upon VTT_PWRGD# being sampled LOW by the clock chip
(indicating processor VTT voltage is stable), the clock chip
samples the FS_A, FS_B, and FS_C input values. For all logic
levels of FS_A, FS_B, and FS_C, VTT_PWRGD# employs a
one-shot functionality in that once a valid LOW on
VTT_PWRGD# has been sampled, all further VTT_PWRGD#,
FS_A, FS_B, and FS_C transitions will be ignored, except in
test mode.
Serial Data Interface
To enhance the flexibility and function of the clock synthesizer,
a two-signal serial interface is provided. Through the Serial
Data Interface, various device functions, such as individual
clock output buffers, can be individually enabled or disabled.
The registers associated with the Serial Data Interface
initialize to their default setting upon power-up, and therefore
use of this interface is optional. Clock device register changes
are normally made upon system initialization, if any are
required. The interface cannot be used during system
operation for power management functions.
Data Protocol
The clock driver serial protocol accepts byte write, byte read,
block write, and block read operations from the controller. For
block write/read operation, the bytes must be accessed in
sequential order from lowest to highest byte (most significant
bit first) with the ability to stop after any complete byte has
been transferred. For byte write and byte read operations, the
system controller can access individually indexed bytes. The
offset of the indexed byte is encoded in the command code,
as described in Table 2.
The block write and block read protocol is outlined in Table 3
while Table 4 outlines the corresponding byte write and byte
read protocol. The slave receiver address is 11010010 (D2h).
48
VDDA2
PWR
3.3V power supply for PLL2
49
XOUT
O, SE 14.318 MHz crystal output.
50
XIN
I
14.318 MHz crystal input.
51
VSSA2
GND
Ground for PLL2.
52
REF1
O
Fixed 14.318 MHz clock output.
53
FS_C_TEST_SEL/
REF0
I/O
3.3V-tolerant input for CPU frequency selection/fixed 14.318 clock output.
Selects test mode if pulled to greater than 1.8V when VTT_PWRGD# is asserted
LOW.
Refer to DC Electrical Specifications table for VIL_FS,VIH_FS specifications.
54
CPU_STP#
I, PU
3.3V LVTTL input for CPU_STP# active LOW.
55
PCI_STP#
I, PU
3.3V LVTTL input for PCI_STP# active LOW.
56
PCI2/SEL_CLKREQ I/O, PD 3.3V-tolerant input for CLKREQ pin selection/fixed 33-MHz clock output.
(sampled on the VTT_PWRGD# assertion).
1= pins 32,33 function as clk request pins, 0= pins 32,33 function as SRC outputs.
Pin Definitions (continued)
Pin No.
Name
Type
Description
Table 1. Frequency Select Table FS_A, FS_B, and FS_C
FS_C
FS_B
FS_A
CPU
SRC
PCIF/PCI
REF0
DOT96
USB
1
0
1
100 MHz
33 MHz
14.318 MHz
96 MHz
48 MHz
0
1
133 MHz
100 MHz
33 MHz
14.318 MHz
96 MHz
48 MHz
0
1
166 MHz
100 MHz
33 MHz
14.318 MHz
96 MHz
48 MHz
0
1
0
200 MHz
100 MHz
33 MHz
14.318 MHz
96 MHz
48 MHz
Table 2. Command Code Definition
Bit
Description
7
0 = Block read or block write operation, 1 = Byte read or byte write operation
(6:0)
Byte offset for byte read or byte write operation. For block read or block write operations, these bits should be
'0000000'
相關PDF資料 |
PDF描述 |
|---|---|
| IDTQS3244QG8 | IC BUS SWITCH 16:8 20-QSOP |
| EL1511CLZ | IC LINE DRIVER ADSL/VDSL 16-QFN |
| EL1508CLZ-T13 | IC LINE DRIVER ADSL 24-QFN |
| EL1508CLZ | IC LINE DRIVER ADSL 24-QFN |
| EL1508CL-T7 | IC LINE DRIVER ADSL 24-QFN |
相關代理商/技術參數 |
參數描述 |
|---|---|
| CY28442ZXCT | 功能描述:IC CLOCK GEN ALVISO 56-TSSOP RoHS:是 類別:集成電路 (IC) >> 時鐘/計時 - 時鐘發生器，PLL，頻率合成器 系列:- 產品變化通告:Product Discontinuation 04/May/2011 標準包裝:96 系列:- 類型:時鐘倍頻器，零延遲緩沖器 PLL:帶旁路 輸入:LVTTL 輸出:LVTTL 電路數:1 比率 - 輸入:輸出:1:8 差分 - 輸入:輸出:無/無 頻率 - 最大:133.3MHz 除法器/乘法器:是/無 電源電壓:3 V ~ 3.6 V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:16-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:16-TSSOP 包裝:管件 其它名稱:23S08-5HPGG |
| CY28443 | 制造商:CYPRESS 制造商全稱:Cypress Semiconductor 功能描述:Clock Generator for Intel㈢ Calistoga Chipset |
| CY28443-2 | 制造商:CYPRESS 制造商全稱:Cypress Semiconductor 功能描述:Clock Generator for Intel㈢ Calistoga Chipset |
| CY28443-3 | 制造商:SPECTRALINEAR 制造商全稱:SPECTRALINEAR 功能描述:Clock Generator for Intel㈢ Calistoga Chipset |
| CY28443OXC | 制造商:CYPRESS 制造商全稱:Cypress Semiconductor 功能描述:Clock Generator for Intel㈢ Calistoga Chipset |
發布緊急采購，3分鐘左右您將得到回復。