參數資料
型號: DAC1208D750HN
廠商: NXP Semiconductors N.V.
元件分類: 外設及接口
英文描述: Dual 12-bit DAC; up to 750 Msps; 2×, 4× or 8× interpolating
封裝: DAC1208D750HN/C1<SOT804-3|<<<1<Always Pb-free,;DAC1208D750HN/C1<SOT804-3|<<<1<Always Pb-free,;
文件頁數: 27/98頁
文件大?。?/td> 554K
代理商: DAC1208D750HN
DAC1208D750
All information provided in this document is subject to legal disclaimers.
NXP B.V. 2010. All rights reserved.
Product data sheet
Rev. 2 — 6 December 2010
27 of 98
NXP Semiconductors
DAC1208D750
2
×
, 4
×
or 8
×
interpolating DAC with JESD204A
10.6 Quadrature modulator and Numerically Controlled Oscillator (NCO)
The quadrature modulator allows the 12-bit I and Q data to be mixed with the carrier
signal generated by the NCO.
The frequency of the NCO is programmed over 32 bits and the sign of the sine component
can be inverted in order to operate positive or negative, lower or upper single sideband
up-conversion.
10.6.1
NCO in 32-bit
When using the NCO, the frequency can be set by the four registers FREQNCO_LSB,
FREQNCO_LISB, FREQNCO_UISB and FREQNCO_MSB over 32 bits.
The frequency for the NCO in 32-bit is calculated as follows:
(1)
where M is the decimal representation of FREQ_NCO[31:0].
The phase of the NCO can be set from 0
°
to 360
°
by both registers PHINCO_LSB and
PHINCO_MSB over 16 bits.
The default setting is f
NCO
= 96 MHz when f
s
= 640 Msps and the default phase is 0
°
.
10.6.2
Low-power NCO
When using the low-power NCO, the frequency can be set by the five MSBs of register
FREQNCO_MSB.
The frequency for the low-power NCO is calculated as follows:
(2)
where M is the decimal representation of FREQ_NCO[31:27].
The phase of the low-power NCO can be set by the five MSBs of the register
PHINCO_MSB.
10.6.3
Minus_3dB
During normal use, a full-scale pattern will also be full-scale at the output of the DAC.
Nevertheless, when the I and Q data are simultaneously close to full-scale, some clipping
can occur and the minus_3dB function can be used to reduce the gain in the modulator by
3 dB. This is to keep a full-scale range at the output of the DAC without added interferers.
10.7 x / (sin x)
The roll-off effect of the DAC causes a selectable FIR filter to be inserted to compensate
for the (sin x) / x effect. This filter introduces a DC loss of 3.4 dB. The coefficients are
represented in
Table 11
.
f
NCO
M
--------------
f
s
×
2
32
=
f
NCO
M
--------------
f
s
×
2
=
相關PDF資料
PDF描述
DL-5538S-C550-SB 1270 nm ~ 1610 nm DFB LD MODULES 2.5 Gbps CWDM MQW-DFB LD RECEPTACLE
DL-5538S-C450-FB 1270 nm ~ 1610 nm DFB LD MODULES 2.5 Gbps CWDM MQW-DFB LD RECEPTACLE
DL-5538S-C450-S 1270 nm ~ 1610 nm DFB LD MODULES 2.5 Gbps CWDM MQW-DFB LD RECEPTACLE
DL-5538S-C450-SB 1270 nm ~ 1610 nm DFB LD MODULES 2.5 Gbps CWDM MQW-DFB LD RECEPTACLE
DL-5538S-C450-T 1270 nm ~ 1610 nm DFB LD MODULES 2.5 Gbps CWDM MQW-DFB LD RECEPTACLE
相關代理商/技術參數
參數描述
DAC1208D750HN/C1,5 功能描述:數模轉換器- DAC DL 12BIT DAC 750MSPS 2X 4X OR 8X INT RoHS:否 制造商:Texas Instruments 轉換器數量:1 DAC 輸出端數量:1 轉換速率:2 MSPs 分辨率:16 bit 接口類型:QSPI, SPI, Serial (3-Wire, Microwire) 穩定時間:1 us 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-14 封裝:Tube
DAC1208D750HN-C1 功能描述:數模轉換器- DAC RoHS:否 制造商:Texas Instruments 轉換器數量:1 DAC 輸出端數量:1 轉換速率:2 MSPs 分辨率:16 bit 接口類型:QSPI, SPI, Serial (3-Wire, Microwire) 穩定時間:1 us 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-14 封裝:Tube
DAC1208D750HN-C18 功能描述:數模轉換器- DAC RoHS:否 制造商:Texas Instruments 轉換器數量:1 DAC 輸出端數量:1 轉換速率:2 MSPs 分辨率:16 bit 接口類型:QSPI, SPI, Serial (3-Wire, Microwire) 穩定時間:1 us 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-14 封裝:Tube
DAC1208LCD 制造商:未知廠家 制造商全稱:未知廠家 功能描述:12-Bit Digital-to-Analog Converter