- 您現在的位置：買賣IC網 > PDF目錄17069 > DC1190A-E (Linear Technology)BOARD SAR ADC LTC2360 PDF資料下載
參數資料
| 型號： | DC1190A-E |
| 廠商： | Linear Technology |
| 文件頁數： | 6/20頁 |
| 文件大?。?/td> | 0K |
| 描述： | BOARD SAR ADC LTC2360 |
| 軟件下載： | QuikEval System |
| 設計資源： | DC1190A Design Files DC1190A Schematic |
| 標準包裝： | 1 |
| 系列： | QuikEval™ |
| ADC 的數量： | 1 |
| 位數： | 12 |
| 采樣率（每秒）： | 100k |
| 數據接口： | MICROWIRE?，串行，SPI? |
| 已用 IC / 零件： | LTC2360 |
| 已供物品： | 板 |
| 相關產品： | LTC2360HTS8#TRPBF-ND - IC ADC SERIAL 12BIT TSOT23-8 LTC2360ITS8#TRPBF-ND - IC ADC 12BIT 100KSPS TSOT23-8 LTC2360ITS8#TRMPBFTR-ND - IC ADC 12BIT 100KSPS TSOT23-8 LTC2360IS6#TRPBF-ND - IC ADC 12BIT 100KSPS TSOT23-6 LTC2360IS6#TRMPBFTR-ND - IC ADC 12BIT 100KSPS TSOT23-6 LTC2360HTS8#TRMPBFTR-ND - IC ADC 12BIT 100KSPS TSOT23-8 LTC2360HS6#TRPBF-ND - IC ADC 12BIT 100KSPS TSOT23-6 LTC2360HS6#TRMPBFTR-ND - IC ADC 12BIT 100KSPS TSOT23-6 LTC2360CTS8#TRPBF-ND - IC ADC 12BIT 100KSPS TSOT23-8 LTC2360CTS8#TRMPBF-ND - IC ADC 12BIT 100KSPS TSOT23-8 更多... |
LTC2360/LTC2361/LTC2362
14
236012fa
APPLICATIONS INFORMATION
OVERVIEW
The LTC2360/LTC2361/LTC2362 use a successive ap-
proximation algorithm and internal sample-and-hold circuit
to convert an analog signal to a 12-bit serial output. All
devices operate from a single 2.35V to 3.6V supply. The
conversion time of the devices is controlled by an internal
oscillator, which allows the LTC2360/LTC2361/LTC2362
to sample at a rate of 100ksps, 250ksps and 500ksps
respectively.
The LTC2360/LTC2361/LTC2362 contain a 12-bit, switched-
capacitor ADC, a sample-and-hold, a serial interface (see
Block Diagram) and are available in tiny 6- or 8-lead
TSOT-23 packages.
The S6 package of the LTC2360/LTC2361/LTC2362 uses
VDD as the reference and has an analog input range of 0V
to VDD. The ADC samples the analog input with respect to
GND and outputs the result through the serial interface.
The TS8 package provides two additional pins: a reference
pin, VREF, and an output supply pin, OVDD. The ADC can
operate with reduced spans down to 1.4V and achieve
342μV resolution. OVDD controls the output swing of the
digital output pin, SDO, and allows the device to com-
municate with 1.8V, 2.5V or 3V digital systems.
SERIAL INTERFACE
The LTC2360/LTC2361/LTC2362 communicate with micro-
controllers, DSPs and other external circuitry via a 3-wire
interface. Figure 10 shows the operating sequence of the
serial interface.
Data Transfer
A rising CONV edge starts a conversion and disables SDO.
After the conversion, the ADC automatically goes into sleep
mode, drawing only leakage current.
CONV going low enables SDO and clocks out the MSB bit,
B11. SCK then synchronizes the data transfer with each
bit being transmitted on the falling SCK edge and can be
captured on the rising SCK edge. After completing the
data transfer, if further SCK clocks are applied with CONV
low, SDO will output zeros indenitely (see Figure 10). For
example, 16-clocks at SCK will produce the 12-bit data
and four trailing zeros on SDO.
SLEEP MODE
The LTC2360/LTC2361/LTC2362 enter sleep mode to save
power after each conversion if CONV remains high. In sleep
mode, all bias currents are shut down and only leakage
currents remain (about 0.1μA). The sample-and-hold is
in hold mode while the ADC is in sleep mode. The ADC
returns to sample mode after the falling edge of CONV
during power-up (see Figure 10).
Exiting Sleep Mode and Power-Up Time
By taking CONV low, the ADC powers up and acquires an
input signal completely after the aquisition time (tACQ).
After tACQ, the ADC can perform a conversion as described
in the Serial Interface section (see Figure 10).
1
RECOMMENDED HIGH OR LOW
Hi-Z STATE
234
t6
t5
t4
t7
t8
236012 F10
t3
910
11
12
B11
(MSB)
*AFTER COMPLETING THE DATA TRANSFER, IF FURTHER SCK CLOCKS ARE
APPLIED WITH CONV LOW, THE ADC WILL OUTPUT ZEROS INDEFINITELY
BY TAKING CONV LOW, THE DEVICE POWERS UP
AND ACQUIRES AN INPUT ACCURATELY AFTER tACQ
SLEEP MODE
tCONV
CONV
SCK
SDO
t1
tACQ
tTHROUGHPUT
t2
B10
B9
B3
B2
B1
B0*
Figure 10. LTC2360/LTC2361/LTC2362 Serial Interface Timing Diagram
相關PDF資料 |
PDF描述 |
|---|---|
| EVAL-AD5405EB | BOARD EVAL FOR AD5405 |
| 0210490288 | CABLE JUMPER 1.25MM .152M 22POS |
| GSM06DSAS | CONN EDGECARD 12POS R/A .156 SLD |
| RBA10DTMI | CONN EDGECARD 20POS R/A .125 SLD |
| DC1190A-D | BOARD SAR ADC LTC2361 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DC1192A | 制造商:Linear Technology 功能描述:BOARD EVAL LT6105 |
| DC1194A | 功能描述:BOARD EVAL LTM8020 RoHS:否 類別:編程器，開發系統 >> 評估板 - DC/DC 與 AC/DC（離線）SMPS 系列:µModule® 標準包裝:1 系列:- 主要目的:DC/DC，步降 輸出及類型:1，非隔離 功率 - 輸出:- 輸出電壓:3.3V 電流 - 輸出:3A 輸入電壓:4.5 V ~ 28 V 穩壓器拓撲結構:降壓 頻率 - 開關:250kHz 板類型:完全填充 已供物品:板 已用 IC / 零件:L7981 其它名稱:497-12113STEVAL-ISA094V1-ND |
| DC1195A | 功能描述:BOARD DEMO LTM8023 RoHS:否 類別:編程器，開發系統 >> 評估板 - DC/DC 與 AC/DC（離線）SMPS 系列:µModule® 標準包裝:1 系列:- 主要目的:DC/DC，步降 輸出及類型:1，非隔離 功率 - 輸出:- 輸出電壓:3.3V 電流 - 輸出:3A 輸入電壓:4.5 V ~ 28 V 穩壓器拓撲結構:降壓 頻率 - 開關:250kHz 板類型:完全填充 已供物品:板 已用 IC / 零件:L7981 其它名稱:497-12113STEVAL-ISA094V1-ND |
| DC1198A-A | 功能描述:BOARD EVAL LTM4605 RoHS:否 類別:編程器，開發系統 >> 評估板 - DC/DC 與 AC/DC（離線）SMPS 系列:µModule® 標準包裝:1 系列:- 主要目的:DC/DC，步降 輸出及類型:1，非隔離 功率 - 輸出:- 輸出電壓:3.3V 電流 - 輸出:3A 輸入電壓:4.5 V ~ 28 V 穩壓器拓撲結構:降壓 頻率 - 開關:250kHz 板類型:完全填充 已供物品:板 已用 IC / 零件:L7981 其它名稱:497-12113STEVAL-ISA094V1-ND |
| DC1198A-B | 功能描述:BOARD DEMO LTM4607 RoHS:否 類別:編程器，開發系統 >> 評估板 - DC/DC 與 AC/DC（離線）SMPS 系列:LTM®, uModule® 標準包裝:1 系列:- 主要目的:DC/DC，步降 輸出及類型:1，非隔離 功率 - 輸出:- 輸出電壓:3.3V 電流 - 輸出:3A 輸入電壓:4.5 V ~ 28 V 穩壓器拓撲結構:降壓 頻率 - 開關:250kHz 板類型:完全填充 已供物品:板 已用 IC / 零件:L7981 其它名稱:497-12113STEVAL-ISA094V1-ND |
發布緊急采購，3分鐘左右您將得到回復。