- 您現在的位置：買賣IC網 > PDF目錄17106 > DC1684A-B (Linear Technology)BOARD DAC LTC2752 PDF資料下載
參數資料
| 型號： | DC1684A-B |
| 廠商： | Linear Technology |
| 文件頁數： | 5/24頁 |
| 文件大?。?/td> | 0K |
| 描述： | BOARD DAC LTC2752 |
| 軟件下載： | QuikEval System |
| 設計資源： | DC1684A Design File DC1684A Schematic |
| 標準包裝： | 1 |
| 系列： | QuikEval™, SoftSpan™ |
| DAC 的數量： | 2 |
| 位數： | 16 |
| 數據接口： | 串行，SPI? |
| 設置時間： | 2µs |
| DAC 型： | 電流 |
| 工作溫度： | 0°C ~ 70°C |
| 已供物品： | 板 |
| 已用 IC / 零件： | LTC2752 |
| 相關產品： | DC590B-ND - BOARD DEMO USB SERIAL CONTROLLER LTC2752BILX#PBF-ND - IC DAC 16BIT DUAL CUR OUT 48LQFP LTC2752AILX#PBF-ND - IC DAC 16BIT DUAL CUR OUT 48LQFP LTC2752BCLX#PBF-ND - IC DAC 16BIT DUAL CUR OUT 48LQFP LTC2752ACLX#PBF-ND - IC DAC 16BIT DUAL CUR OUT 48LQFP |
第1頁第2頁第3頁第4頁當前第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁
LTC2752
2752f
Output Ranges
TheLTC2752isadual,current-output,serial-inputprecision
multiplying DAC with selectable output ranges. Ranges
can either be programmed in software for maximum flex-
ibility—each of the DACs can be programmed to any one
ofsixoutputranges—orhardwiredthroughpin-strapping.
Two unipolar ranges are available (0V to 5V and 0V to 10V),
and four bipolar ranges (±2.5V, ±5V, ±10V and –2.5V to
7.5V). These ranges are obtained when an external pre-
cision 5V reference is used. The output ranges for other
reference voltages are easy to calculate by observing that
each range is a multiple of the external reference voltage.
Therangescanthenbeexpressed:0 to 1
×,0 to 2×,±0.5×,
±1
×, ±2×, and –0.5× to 1.5×.
Manual Span Configuration
Multiple output ranges are not needed in some applica-
tions. To configure the LTC2752 to operate in a single span
without additional operational overhead, tie the M-SPAN
pin directly to VDD. The active output range for all DACs is
then set via hardware pin strapping of pins S2, S1 and S0
(rather than through the SPI port); and Write and Update
commands have no effect on the active output span. See
Figure 1 and Table 3.
Figure 1. Using M-SPAN to Configure the LTC2752
for Single-Span Operation (±10V Range Shown)
LTC2752
M-SPAN
S2
S1
S0
2752 F01
CS/LD SDI SCK
VDD
DAC A
±10V
DAC B
–
+
–
+
operaTion
Tie the M-SPAN pin to ground for normal SoftSpan
operation.
Input and DAC Registers
The LTC2752 has 5 internal registers for each DAC, a total
of 10 registers (see Block Diagram). Each DAC channel
has two sets of double-buffered registers—one set for the
code data, and one for the output range of the DAC—plus
one readback register. Double buffering provides the ca-
pability to simultaneously update the span (output range)
and code, which allows smooth voltage transitions when
changing output ranges. It also permits the simultaneous
updating of multiple DACs.
Each set of double-buffered registers comprises an Input
register and a DAC register.
Input register: The Write operation shifts data from the
SDI pin into a chosen Input register. The Input registers
are holding buffers; Write operations do not affect the
DAC outputs.
DAC register: The Update operation copies the contents
of an Input register to its associated DAC register. The
contents of a DAC register directly updates the associated
DAC output voltage or output range.
Note that updates always include both Code and Span
register sets; but the values held in the DAC registers will
only change if the associated Input register values have
previously been changed via a Write operation.
Serial Interface
When the CS/LD pin is taken low, the data on the SDI
pin is loaded into the shift register on the rising edge of
the clock (SCK pin). The minimum (24-bit wide) loading
sequence required for the LTC2752 is a 4-bit command
word (C3 C2 C1 C0), followed by a 4-bit address word
(A3 A2 A1 A0) and 16 data (span or code) bits, MSB first.
Figure 2 shows the SDI input word syntax to use when
相關PDF資料 |
PDF描述 |
|---|---|
| 0210390927 | CABLE JUMPER 1MM .102M 23 POS |
| REC3-2412DRWZ/H6/A | CONV DC/DC 3W 9-36VIN +/-12VOUT |
| GBM18DSAH | CONN EDGECARD 36POS R/A .156 SLD |
| SCRH5D28-180 | INDUCTOR SMD 18UH 0.95A 10KHZ |
| 0210390942 | CABLE JUMPER 1MM .030M 25POS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DC1687A | 制造商:Linear Technology 功能描述:EVAL BOARD, LTC3115 BUCK-BOOST CONVERTER, Silicon Manufacturer:Linear Technology, Silicon Core Number:LTC3115, Kit Application Type:Power Management - Voltage Regulator, Application Sub Type:Synchronous Buck-Boost Converter , RoHS Compliant: NA |
| DC1691A01XY_D4X WAF | 制造商:Fairchild Semiconductor Corporation 功能描述: |
| DC1691A01XY-D4X WAF | 制造商:Fairchild Semiconductor Corporation 功能描述: |
| DC1692C17XX_D4X WAF | 制造商:Fairchild Semiconductor Corporation 功能描述: |
| DC1692C18AX-D4X WAF | 制造商:Fairchild Semiconductor Corporation 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。