- 您現在的位置：買賣IC網 > PDF目錄1912 > DLP-245SY-G (DLP Design Inc)MODULE USB-MCU FT245RL W/SX48 PDF資料下載
參數資料
| 型號： | DLP-245SY-G |
| 廠商： | DLP Design Inc |
| 文件頁數： | 3/14頁 |
| 文件大?。?/td> | 0K |
| 描述： | MODULE USB-MCU FT245RL W/SX48 |
| 產品目錄繪圖： | DLP-245SY-G |
| 標準包裝： | 1 |
| 系列： | USB |
| 模塊/板類型： | 開發板 |
| 適用于相關產品： | USB |
| 其它名稱： | 813-1006 |
第1頁第2頁當前第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁
11
7
C6 (I/O) Port Pin C6 connected to the SX48 microcontroller.
8
C7 (I/O) Port Pin C7 connected to the SX48 microcontroller.
9
MCLR* (In) Can be used by an external device to reset the SX48. Can be left disconnected if not
used.
10
RTCC (In) Input to the SX48’s Real-Time Clock/Counter
11
RESET# (In) Can be used by an external device to reset the FT245RL. Can be left disconnected if
not used.
12
GROUND
Note: This pin was RESETO# in the original DLP-245SY
13
GROUND
14
3V3OUT (Out) Output from the integrated L.D.O. regulator. Its primary purpose is to provide the
internal 3.3v supply to the USB transceiver cell and the RSTOUT# pin. A small amount of current
(<=5mA) can be drawn from this pin to power external 3.3v logic if required.
15
GROUND
16
SWVCC (Out) Power from EXTVCC (Pin 19) controlled via Pin 10 (POWERN#) of the FT245RL
and Q1 MOSFET power switch. R5 and C3 control the power-up rate to help limit inrush current.
17
GROUND
18
VCC-IO (In) 3.0 volt to +5.25 volt VCC to the FT245RL’s interface pins 10-12, 14-16, and 18-25.
When interfacing with 3.3v external logic, connect VCC-IO to the 3.3v supply of the external logic;
otherwise, connect to the VCC to drive out at 5v CMOS level. This pin must be connected to VCC
from the target electronics or EXTVCC.
19
EXTVCC (In) Use for applying main power (4.4 to 5.25 volts) to the module. Connect to
PORTVCC if the module is to be powered by the USB port (typical configuration).
20
PORTVCC (Out) Power from USB port. Connect to EXTVCC if module is to be powered by the
USB port (typical configuration). 500mA is the maximum current available to the DLP-245SY-G
and target electronics if the USB device is configured for high power.
21
DB7 (I/O) Line 7 of the data bus between the SX48 and the FT245RL USB-FIFO.
22
DB6 (I/O) Line 6 of the data bus between the SX48 and the FT245RL USB-FIFO.
23
DB5 (I/O) Line 5 of the data bus between the SX48 and the FT245RL USB-FIFO.
24
DB4 (I/O) Line 4 of the data bus between the SX48 and the FT245RL USB-FIFO.
25
DB3 (I/O) Line 3 of the data bus between the SX48 and the FT245RL USB-FIFO.
26
DB2 (I/O) Line 2 of the data bus between the SX48 and the FT245RL USB-FIFO.
27
DB1 (I/O) Line 1 of the data bus between the SX48 and the FT245RL USB-FIFO.
28
DB0 (I/O) Line 0 of the data bus between the SX48 and the FT245RL USB-FIFO.
29
E0 (I/O) Port Pin E0 connected to the SX48 microcontroller.
30
E1 (I/O) Port Pin E1 connected to the SX48 microcontroller.
31
E2 (I/O) Port Pin E2 connected to the SX48 microcontroller.
相關PDF資料 |
PDF描述 |
|---|---|
| DLP-FPGA | MODULE USB-TO-FPGA TRAINING TOOL |
| DLP-HS-FPGA3 | MODULE USB-TO-FPGA SPARTAN 3A |
| DP83848CVVX/NOPB | TXRX ETHERNET PHYTER 48LQFP |
| DP83848HSQ/NOPB | IC TXRX ETHERNET PHYTER 40-LLP |
| DP83848YB/NOPB | IC TXRX ETHERNET PHYTERA 48-LQFP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DLP-245SY-G-C | 功能描述:界面模塊 USB/Micro Dev Board W/GRICH C COMPILER RoHS:否 制造商:4D Systems 產品:Serial Converters 通道/端口數量: 數據速率: 接口類型:USB, UART 工作電源電壓:3.3 V, 5 V 最大工作溫度: |
| DLP2AD | 制造商:MURATA 制造商全稱:Murata Manufacturing Co., Ltd. 功能描述:SMD/BLOCK Type EMI Suppression Filters |
| DLP2ADA350HL4 | 制造商:MURATA 制造商全稱:Murata Manufacturing Co., Ltd. 功能描述:SMD/BLOCK Type EMI Suppression Filters |
| DLP2ADA350HL4B | 制造商:Murata Manufacturing Co Ltd 功能描述:CHOKE COMMON ARRAY 35OHM +/-20% 制造商:Murata Manufacturing Co Ltd 功能描述:CHOKE, COMMON ARRAY, 35OHM, +/-20% 制造商:Murata Manufacturing Co Ltd 功能描述:CHOKE, COMMON ARRAY, 35OHM, +/-20% , ROHS COMPLIANT: YES |
| DLP2ADA350HL4L | 功能描述:共模濾波器/扼流器 35ohm 150mA DCR 0.8ohm RoHS:否 制造商:TDK 電感: 阻抗:35 Ohms 容差: 最大直流電流:0.1 A 最大直流電阻:1.5 Ohms 自諧振頻率: Q 最小值: 工作溫度范圍:- 25 C to + 85 C 端接類型:SMD/SMT 封裝 / 箱體:0302 (0806 metric) 系列:TCE |
發布緊急采購，3分鐘左右您將得到回復。