- 您現在的位置：買賣IC網 > PDF目錄9320 > DS1557WP-120IND (Maxim Integrated Products)IC RTC RAM Y2K 3.3V 120NS 34PCM PDF資料下載
參數資料
| 型號： | DS1557WP-120IND |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 15/17頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC RTC RAM Y2K 3.3V 120NS 34PCM |
| 標準包裝： | 40 |
| 類型： | 時鐘/日歷 |
| 特點： | 警報器，閏年，NVSRAM，監視計時器，Y2K |
| 存儲容量： | 512KB |
| 時間格式： | HH:MM:SS（24 小時） |
| 數據格式： | YY-MM-DD-dd |
| 接口： | 并聯 |
| 電源電壓： | 2.97 V ~ 3.63 V |
| 電壓 - 電源，電池： | 3V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 34-PowerCap? 模塊 |
| 供應商設備封裝： | 34-PowerCap 模塊 |
| 包裝： | 管件 |
DS1557 4Meg, Nonvolatile, Y2K-Compliant Timekeeping RAM
7 of 17
USING THE CLOCK ALARM
The alarm settings and control for the DS1557 reside within Registers 7FFF2h-7FFF5h. Register 7FFF6h
contains two alarm enable bits: Alarm Enable (AE) and Alarm in Backup Enable (ABE). The AE and
ABE bits must be set as described below for the
IRQ/FT output to be activated for a matched alarm
condition.
The alarm can be programmed to activate on a specific day of the month or repeat every day, hour,
minute, or second. It can also be programmed to go off while the DS1557 is in the battery-backed state of
operation to serve as a system wakeup. Alarm mask bits AM1 to AM4 control the alarm mode. Table 3
shows the possible settings. Configurations not listed in the table default to the once per second mode to
notify the user of an incorrect alarm setting.
Table 3. Alarm Mask Bits
AM4
AM3
AM2
AM1
ALARM RATE
1
Once per second
1
0
When seconds match
1
0
When minutes and seconds match
1
0
When hours, minutes, and seconds match
0
When date, hours, minutes, and seconds match
When the RTC Register values match Alarm Register settings, the Alarm Flag bit (AF) is set to a 1. If
Alarm Flag Enable (AE) is also set to a 1, the alarm condition activates the
IRQ/FT pin. The IRQ/FT
signal is cleared by a read or write to the Flags Register (Address 7FFF0h) as shown in Figure 2 and 3.
When
CE is active, the IRQ/FT signal may be cleared by having the address stable for as short as 15 ns
and either
OE or WE active, but is not guaranteed to be cleared unless t
RC is fulfilled. The alarm flag is
also cleared by a read or write to the Flags Register but the flag will not change states until the end of the
read/write cycle and the
IRQ/FT signal has been cleared.
Figure 2. Clearing
IRQ Waveforms
C
CE
E,,
相關PDF資料 |
PDF描述 |
|---|---|
| MCP4342T-503E/ST | IC DGTL POT QUAD 50K 14TSSOP |
| VI-BNV-MY-F4 | CONVERTER MOD DC/DC 5.8V 50W |
| VE-B1D-MV | CONVERTER MOD DC/DC 85V 150W |
| VI-BNV-MY-F3 | CONVERTER MOD DC/DC 5.8V 50W |
| MCP4342T-502E/ST | IC DGTL POT QUAD 5K 14TSSOP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DS1557WP-120IND+ | 功能描述:實時時鐘 4M NV RAM Timekeeper RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 總線接口:I2C 日期格式:DW:DM:M:Y 時間格式:HH:MM:SS RTC 存儲容量:64 B 電源電壓-最大:5.5 V 電源電壓-最小:1.8 V 最大工作溫度:+ 85 C 最小工作溫度: 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube |
| DS1557WP-150 | 制造商:DALLAS 制造商全稱:Dallas Semiconductor 功能描述:4MEG NV Y2KC Timekeeping RAM |
| DS1558 | 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:Watchdog Clock with NV RAM Control |
| DS1558B | 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:Watchdog Clock with NV RAM Control |
| DS1558D | 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:Watchdog Clock with NV RAM Control |
發布緊急采購，3分鐘左右您將得到回復。