參數資料
型號: DS1682S+T&R
廠商: Maxim Integrated Products
文件頁數: 14/14頁
文件大小: 0K
描述: IC TIMEKEEPER ALARM ELAPSE 8SOIC
產品培訓模塊: Lead (SnPb) Finish for COTS
Obsolescence Mitigation Program
標準包裝: 2,500
類型: 耗用時間計數器
特點: 警報器,EEPROM
存儲容量: 10B
時間格式: 二進制
數據格式: 二進制
接口: I²C,2 線串口
電源電壓: 2.5 V ~ 5.5 V
工作溫度: -40°C ~ 85°C
安裝類型: 表面貼裝
封裝/外殼: 8-SOIC(0.154",3.90mm 寬)
供應商設備封裝: 8-SOIC
包裝: 帶卷 (TR)
Alarm
The alarm register is a 32-bit register that holds time in
quarter-second resolution. When a nonzero number is
programmed into the alarm register, the ALARM func-
tion is enabled and the DS1682 monitors the values in
the ETC for the programmed value in the alarm register.
When the ETC matches the alarm value, the alarm flag
is set.
EEPROM Array
When power is applied, the contents of the EEPROM are
transferred to the configuration register, alarm register,
ETC, event counter, and user memory. When the event
pin goes low, VCC must remain above VCC minimum for
tEW to ensure the EEPROM is properly written.
The EEPROM array for the ETC and the event counter is
made up of three banks. Each bank can be written a maxi-
mum of 50k times. The device switches between banks
based upon the value in the event counter. Resetting the
event counter before the counter reaches 50,000 causes
additional writes to the first bank, which can allow writes
in excess of 50k. If the event counter is set to greater
than 50k or 100k prior to reset, the device stays on the
selected bank. This could result in writes in excess of 50k
to one bank.
The configuration and alarm registers and the user mem-
ory are held in one bank of EEPROM. Writes at the end
of an event only occur if the data has changed in one or
more of those registers.
User-modified data in any of the registers is stored in
EEPROM only if the data was written while an event was
active and is stored when the event ends.
Event Counter Register
This 17-bit event counter register set provides the total
number of data samples logged during the life of the prod-
uct up to 131,072 separate events. The event counter
consists of 2 bytes of memory in the memory map plus
the event counter MSB bit (ECMSB) in the configuration
register. Once the event counter reaches 1FFFFh, event
counting stops.
Reset Command
If RE is set to a 1, a reset occurs when a reset command
is sent through the 2-wire bus. A reset command is issued
by writing 55h twice into memory location 1Dh. The writes
need not be consecutive. Cycling power on VCC prior to
the second write terminates the reset sequence.
Upon reset, the ETC and event counter registers are
cleared. The AF, RE, and ECMSB bits are cleared by the
device, and the configuration register becomes read-only.
The data are written to the EEPROM, and additional
resets are ignored.
When a reset command is issued, no additional command
should be issued during the EEPROM write time (tEW).
DS1682
Total-Elapsed-Time Recorder
with Alarm
www.maximintegrated.com
Maxim Integrated │ 9
相關PDF資料
PDF描述
X9258US24Z IC DGTL POT QUAD 100K 24SOIC
DS1344E-33+T&R IC RTC SPI 3.3V 20TSSOP
X9400WV24-2.7 IC DCP QUAD 10K 64TP 24TSSOP
DS1343E-33+T&R IC RTC SPI 3.3V 20TSSOP
X9260TS24Z IC XDCP DUAL 256TP 100K 24-SOIC
相關代理商/技術參數
參數描述
DS1682X 制造商:DALLAS 制造商全稱:Dallas Semiconductor 功能描述:Total Elapsed Time Recorder with Alarm
DS1683 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:Total-Elapsed-Time and Event Recorder with Alarm
DS1683_12 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:Total-Elapsed-Time and Event Recorder with Alarm
DS1683S 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:Total-Elapsed-Time and Event Recorder with Alarm
DS1683S+ 功能描述:實時時鐘 T-E-T Recorder RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 總線接口:I2C 日期格式:DW:DM:M:Y 時間格式:HH:MM:SS RTC 存儲容量:64 B 電源電壓-最大:5.5 V 電源電壓-最小:1.8 V 最大工作溫度:+ 85 C 最小工作溫度: 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube