參數資料
型號: DS2143N
廠商: Maxim Integrated Products
文件頁數: 12/44頁
文件大小: 0K
描述: IC CONTROLLER E1 5V LP 40-DIP
產品培訓模塊: Lead (SnPb) Finish for COTS
Obsolescence Mitigation Program
標準包裝: 10
控制器類型: E1 控制器
接口: 并行/串行
電源電壓: 4.5 V ~ 5.5 V
電流 - 電源: 10mA
工作溫度: -40°C ~ 85°C
安裝類型: 通孔
封裝/外殼: 40-DIP(0.600",15.24mm)
供應商設備封裝: 40-PDIP
包裝: 管件
DS2143/DS2143Q
2 of 44
can access. These internal registers are used to configure the device and obtain information from the E1
link. The device fully meets al l of the latest E1 specifications, including CCITT G.704, G.706, and
G.732.
1.0 INTRODUCTION
The DS2143 E1 Controller has four main sections: the receive side, the transmit side, the line interface
controller, and the parallel control port. See the Block Diagram. On the receive side, the device will
clock in the serial E1 stream via the RPOS and RNEG pins. The synchronizer will locate the frame and
multiframe patterns and establish their respective positions. This information will be used by the rest of
the receive side circuitry.
The DS2143 is an “off-line” framer, which means that all of the E1 serial stream that goes into the device
will come out of it unchanged. Once the E1 data has been framed to, the signaling data can be extracted.
The two-frame elastic store can either be enabled or bypassed.
The transmit side clocks in the unframed E1 stream at TSER and add in the framing pattern and the
signaling. The line interface control port will update line interface devices that contain a serial port. The
parallel control port contains a multiplexed address and data structure which can be connected to either a
microcontroller or microprocessor.
Reader’s Note:
This data sheet assumes a particular nomenclature of the E1 operating environment. There are 32 8-bit
timeslots in an E1 systems which are number 0 to 31. Timeslot 0 is transmitted first and received first.
These 32 timeslots are also referred to as channels with a numbering scheme of 1 to 32. Timeslot 0 is
identical to channel 1, timeslot 1 is identical to channel 2, and so on. Each timeslot (or channel) is made
up of 8 bits which are numbered 1 to 8. Bit number 1 is the MSB and is transmitted first. Bit number 8 is
the LSB and is transmitted last. Throughout this data sheet, the following abbreviations will be used:
FAS
Frame Alignment Signal
CRC4
Cyclical Redundancy Check
CAS
Channel Associated Signaling
CCS
Common Channel Signaling
MF
Multiframe
Sa
Additional bits
Si
International bits
E-bit
CRC4 Error Bits
相關PDF資料
PDF描述
DS2141AN IC CONTROLLER T1 5V 40-DIP
VI-25N-IX-S CONVERTER MOD DC/DC 18.5V 75W
DS2141AQ/T&R IC CONTROLLER T1 5V 44-PLCC
VI-24J-IX-S CONVERTER MOD DC/DC 36V 75W
DS2141AQ+T&R IC CONTROLLER T1 5V 44-PLCC
相關代理商/技術參數
參數描述
DS2143Q 功能描述:網絡控制器與處理器 IC RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流(最大值):595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray
DS2143Q/T&R 制造商:Maxim Integrated Products 功能描述:IC CONTROLLER E1 5V LP 44-PLCC 制造商:Maxim Integrated Products 功能描述:Network Controller & Processor ICs E1 Controller w/Elastic Store
DS2143Q/T&R 功能描述:網絡控制器與處理器 IC E1 Controller w/Elastic Store RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流(最大值):595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray
DS2143Q+ 功能描述:網絡控制器與處理器 IC E1 Controller w/Elastic Store RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流(最大值):595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray
DS2143QN 功能描述:網絡控制器與處理器 IC E1 Controller w/Elastic Store RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流(最大值):595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray