- 您現在的位置：買賣IC網 > PDF目錄97867 > DS2172TN (DALLAS SEMICONDUCTOR) SPECIALTY TELECOM CIRCUIT, PQFP32 PDF資料下載
參數資料
| 型號： | DS2172TN |
| 廠商： | DALLAS SEMICONDUCTOR |
| 元件分類： | Telecom IC:Other |
| 英文描述： | SPECIALTY TELECOM CIRCUIT, PQFP32 |
| 封裝： | TQFP-32 |
| 文件頁數： | 17/22頁 |
| 文件大小： | 174K |
| 代理商： | DS2172TN |
DS2172
4 of 22
DETAILED PIN DESCRIPTION Table 1
PIN
SYMBOL
TYPE
DESCRIPTION
1TL
I
Transmit Load. A positive-going edge loads the pattern generator with
the contents of the Pattern Set Registers. The MSB of the repetitive or
pseudorandom pattern appears at TDATA after the third positive edge of
TCLK from asserting TL. TL is logically OR’ed with PCR.7 and should
be tied to VSS if not used. See Figure 8 for timing information.
2
AD0
I/O
Data Bus. An 8-bit multiplexed address/data bus.
3
AD1
I/O
Data Bus. An 8-bit multiplexed address/data bus.
4
TEST
I
Test. Set high to 3-state all output pins ( INT , ADx, TDATA, RLOS).
Should be tied to VSS to enable all outputs.
5VSS
-
Signal Ground. 0.0V. Should be tied to local ground plane.
6
AD2
I/O
Data Bus. An 8-bit multiplexed address/data bus.
7
AD3
I/O
Data Bus. An 8-bit multiplexed address/data bus.
8
AD4
I/O
Data Bus. An 8-bit multiplexed address/data bus.
9
AD5
I/O
Data Bus. An 8-bit multiplexed address/data bus.
10
AD6
I/O
Data Bus. An 8-bit multiplexed address/data bus.
11
AD7
I/O
Data Bus. An 8-bit multiplexed address/data bus.
12
VSS
-
Signal Ground. 0.0V. Should be tied to local ground plane.
13
VDD
-
Positive Supply. 5.0V.
14
BTS
I
Bus Type Select. Strap high to select Motorola bus timing; strap low to
select Intel bus timing. This pin controls the function of the RD (DS),
ALE(AS), and WR (R/ W ) pins. If BTS = 1, then these pins assume the
function listed in parenthesis ().
15
RD
(DS)
I
Read Input (Data Strobe).
16
CS
I
Chip Select. Must be low to read or write the port.
17
ALE(AS)
I
Address Latch Enable (Address Strobe). A positive going edge serves
to demultiplex the bus.
18
WR
(R/ W )
I
Write Input (Read/Write).
19
INT
O
Alarm Interrupt. Flags host controller during conditions defined in
Status Register. Active low, open drain output.
20
VDD
-
Positive Supply. 5.0V.
21
VSS
-
Signal Ground. 0.0V. Should be tied to local ground plane.
22
LC
I
Load Count. A positive-going edge latches the current bit and bit error
count into the user accessible BCR and BECR registers and clears the
internal count registers. LC is logically OR’ed with control bit PCR.4.
Should be tied to VSS if not used.
23
RLOS
O
Receive Loss Of Sync. Indicates the real time status of the receive
synchronizer. Active high output.
相關PDF資料 |
PDF描述 |
|---|---|
| DS2172 | SPECIALTY TELECOM CIRCUIT, PQFP32 |
| DS2175S | DATACOM, ELASTIC BUFFER, PDSO16 |
| DS2175 | DATACOM, ELASTIC BUFFER, PDIP16 |
| DS2175N | DATACOM, ELASTIC BUFFER, PDIP16 |
| DS2175SN | DATACOM, ELASTIC BUFFER, PDSO16 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DS2172TN/T&R | 功能描述:電信集成電路 RoHS:否 制造商:STMicroelectronics 類型:Telecom IC - Various 工作電源電壓:4.75 V to 5.25 V 電源電流: 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PQFP-100 封裝:Tray |
| DS2172TN+ | 功能描述:電信集成電路 Bit Error Rate Tester (BERT) RoHS:否 制造商:STMicroelectronics 類型:Telecom IC - Various 工作電源電壓:4.75 V to 5.25 V 電源電流: 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PQFP-100 封裝:Tray |
| DS2172TN+T&R | 制造商:Maxim Integrated Products 功能描述:BERT 32P TQFP T&R IND LEAD FREE - Tape and Reel 制造商:Maxim Integrated Products 功能描述:IC BIT ERROR RATE TESTER 32TQFP 制造商:Maxim Integrated Products 功能描述:Telecom ICs Bit Error Rate Tester (BERT) |
| DS2172TN+T&R | 功能描述:電信集成電路 Bit Error Rate Tester (BERT) RoHS:否 制造商:STMicroelectronics 類型:Telecom IC - Various 工作電源電壓:4.75 V to 5.25 V 電源電流: 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PQFP-100 封裝:Tray |
| DS2174 | 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:EBERT |
發布緊急采購，3分鐘左右您將得到回復。