參數資料
型號： DS2423X
元件分類： 通用總線功能
英文描述： 4kbit 1-Wire RAM with Counter
中文描述： 4kbit的1 - Wire與反內存
文件頁數： 14/25頁
文件大?。?/td> 331K
代理商： DS2423X
DS2423
14 of 25
HARDWARE CONFIGURATION
Figure 8
Note: Depending on the 1-Wire communication speed and the bus load characteristics, the optimal pull-
up resistor (R
PU
) value will be in the 1.5k to 5k range.
1-WIRE BUS SYSTEM
The 1-Wire bus is a system which has a single bus master and one or more slaves. In all instances the
DS2423 is a slave device. The bus master is typically a microcontroller. The discussion of this bus
system is broken down into three topics: hardware configuration, transaction sequence, and 1-Wire
signaling (signal types and timing). A 1-Wire protocol defines bus transactions in terms of the bus state
during specific time slots that are initiated on the falling edge of sync pulses from the bus master. For a
more detailed protocol description, refer to Chapter 4 of the
Book of DS19xx iButton Standards
.
HARDWARE CONFIGURATION
The 1-Wire bus has only a single line by definition; it is important that each device on the bus be able to
drive it at the appropriate time. To facilitate this, each device attached to the 1-Wire bus must have open-
drain or 3-state outputs. The 1-Wire port of the DS2423 is open drain with an internal circuit equivalent
to that shown in Figure 8. A multidrop bus consists of a 1-Wire bus with multiple slaves attached. At
regular speed the 1-Wire bus has a maximum data rate of 16.3kbits per second. The speed can be boosted
to 142kbits per second by activating the Overdrive mode. The 1-Wire bus requires a pullup resistor of
approximately 5k
. The 1-Wire bus requires a pullup resistor range of 1.5k to 5k , depending on the
bus load characteristics.
The idle state for the 1-Wire bus is high. If for any reason a transaction needs to be suspended, the bus
MUST be left in the idle state if the transaction is to resume. If this does not occur and the bus is left low
for more than 16μs (Overdrive speed) or more than 120μs (regular speed), one or more devices on the bus
may be reset.
TRANSACTION SEQUENCE
The protocol for accessing the DS2423 via the 1-Wire port is as follows:
Initialization
ROM Function Command
Memory Function Command
Transaction/Data
R
PU
DS2423
相關PDF資料
PDF描述
DS2430A The CAT24FC02 is a 2-kb Serial CMOS EEPROM internally organized as 256 words of 8 bits each
DS2430 The CAT24FC02 is a 2-kb Serial CMOS EEPROM internally organized as 256 words of 8 bits each
DS2430AP The CAT24FC02 is a 2-kb Serial CMOS EEPROM internally organized as 256 words of 8 bits each
DS2430AT The CAT24FC02 is a 2-kb Serial CMOS EEPROM internally organized as 256 words of 8 bits each
DS2430AV The CAT24FC02 is a 2-kb Serial CMOS EEPROM internally organized as 256 words of 8 bits each
相關代理商/技術參數
參數描述
DS243 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Analog IC
DS2430 制造商:DALLAS 制造商全稱:Dallas Semiconductor 功能描述:256-Bit 1-Wire EEPROM
DS2430A 功能描述:電可擦除可編程只讀存儲器 RoHS:否 制造商:Atmel 存儲容量:2 Kbit 組織:256 B x 8 數據保留:100 yr 最大時鐘頻率:1000 KHz 最大工作電流:6 uA 工作電源電壓:1.7 V to 5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8
DS2430A R 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:256-Bit 1-Wire EEPROM
DS2430A T 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:256-Bit 1-Wire EEPROM
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*