- 您現在的位置：買賣IC網 > PDF目錄1915 > DS2490Y (Maxim Integrated Products)IC BRIDGE CLIP USB TO 1-W 24SOIC PDF資料下載
參數資料
| 型號： | DS2490Y |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 14/50頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC BRIDGE CLIP USB TO 1-W 24SOIC |
| 標準包裝： | 1,000 |
| 應用： | USB |
| 接口： | 1 線 |
| 電源電壓： | 3 V ~ 5.5 V |
| 封裝/外殼： | 24-SOIC（0.295"，7.50mm 寬） |
| 供應商設備封裝： | 24-SOIC W |
| 包裝： | 管件 |
| 安裝類型： | 表面貼裝 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁當前第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁
DS2490
21 of 50
1-Wire RESET—This command is used to generate a reset pulse on the 1-Wire bus and to optionally
change the 1-Wire speed. The new speed will take effect only if the embedded command bit SE is set to
1. When the 1-WIRE RESET is sent after an Overdrive Skip ROM command, SE must be 1 and the new
speed must be 0x02. See MODE CONTROL section for additional communication speed information. To
switch back to regular speed, set SE = 1 and the new speed parameter to 0x00 (regular) or 0x01 (flexible).
Command parameters:
1 byte specifying new speed after the reset.
EP2 data:
None
EP3 data:
None
Result Register:
Code
Condition
SH, NRS, APP
ICP = 0, NTF = 0 or 1: An abnormal condition or
an Alarming Presence Pulse was detected
0x00
ICP = 0, NTF = 1: no error detected
None
ICP = 0, NTF = 0: no error detected
None
ICP = 1
BIT I/O - This command generates a single time slot on the 1-Wire bus and reads back the response.
Data bit d3 (D) of command byte 1 specifies the value to be written to the 1-Wire bus. This time slot may
optionally be followed by a strong pullup using embedded command bits SPU and CIB. With CIB = 1, a
requested strong pullup will only occur if the read-back revealed a 0. Data is returned to the host only if
the embedded command bit ICP = 0. If ICP = 0, the bit read from the 1-Wire device is stored in the
EP3 FIFO and is read by the host using an EP3 bulk transaction.
Command parameters:
None.
EP2 data:
None, this command gets its input data as a command parameter.
EP3 data:
Length Description
If ICP = 0: 1 byte
Bit read back from the 1-Wire device.
If ICP = 1: None
No data is returned.
Result Register:
If ICP = 1: no result data is generated.
If ICP = 0 and NTF = 1: a result value of 0x00 will be generated.
If IPC = 0 and NTF = 0: no result data is generated since there are no
error codes associated with this command.
BIT I/O Read Back Byte Table 14
bit7
bit6
bit5
bit4
bit3
bit2
bit1
bit0
0
D
BYTE I/O—This command accomplishes a direct 1-Wire write and read with optional strong pullup
after the last bit of the byte. The optional strong pullup is controlled using embedded command bit SPU.
For a write sequence, the data byte to be written is included in the command setup packet as shown in
Appendix 2. For a read sequence, the setup packet data byte value is set to 0xFF. Data is returned to the
host only if the embedded command bit ICP = 0. If ICP = 0, the byte read from the 1-Wire device is
stored in the EP3 FIFO and is read by the host using an EP3 bulk transaction.
相關PDF資料 |
PDF描述 |
|---|---|
| DS26303LN-75+A3 | IC LIU E1/T1/J1 3.3V 144-ELQFP |
| DS26324GNA2+ | IC INTERFACE LINE 16CH 256-CSBGA |
| DS26334GN+ | IC INTERFACE LINE 16CH 256-CSBGA |
| DS26401N+ | IC OCTAL FRAMER T1/E1/J1 256-BGA |
| DS26504LNB2+ | IC T1/E1/J1 64KCC ELEMENT 64LQFP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DS2490Y+ | 制造商:Maxim Integrated Products 功能描述:USB TO 1-WIRE BRIDGE 24SOIC W - Tape and Reel |
| DS24B33 | 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:1-Wire 4Kb EEPROM |
| DS24B33 R | 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:1-Wire 4Kb EEPROM |
| DS24B33 T | 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:1-Wire 4Kb EEPROM |
| DS24B33 TR | 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:1-Wire 4Kb EEPROM |
發布緊急采購，3分鐘左右您將得到回復。