參數資料
型號: DS2890X-000
廠商: Maxim Integrated Products
文件頁數: 25/27頁
文件大?。?/td> 0K
描述: IC POT DIGITAL 1-WIRE 100K CSP
標準包裝: 10,000
接片: 256
電阻(歐姆): 100k
電路數: 1
溫度系數: 標準值 800 ppm/°C
存儲器類型: 易失
接口: 1 線 串行
電源電壓: 2.8 V ~ 6 V
工作溫度: -40°C ~ 85°C
安裝類型: 表面貼裝
封裝/外殼: 6-XBGA,F(xiàn)CBGA
供應商設備封裝: 6-覆晶(2.82x2.54)
包裝: 帶卷 (TR)
DS2890
7 of 27
POWER and CONFIGURATION CONSIDERATIONS
1-Wire devices can typically derive operating power entirely from the 1-Wire bus by storing energy on an
internal capacitor during periods of time when the 1-Wire bus is in a high state. During bus low times the
device continues to operate from the energy stored on the internal capacitor; the capacitor is then
recharged when the bus returns to a high state. This technique of operating entirely from the 1-Wire bus
by powering from energy stored on an internal capacitor during bus low times in known as “parasite
powered” operation.
Special consideration is required with the DS2890 in that it supports two power
configurations and two related digital resistor modes: Potentiometer Configuration and Variable Resistor
Configuration. The Potentiometer Configuration requires the presence of a VDD power source to supply
the power needs of the device charge pump which must be turned on to support a terminal-to-terminal
wiper output range. The Variable Resistor configuration is supported with or without a VDD source or
enabled charge pump although resistance range, as described below, is influenced by the charge pump
state.
POTENTIOMETER CONFIGURATION
To configure and operate the DS2890 as a potentiometer as shown in Figure 5 requires the TSOC, a VDD
power source, and the device charge pump turned on (Control Register, bit CPC=1). The charge pump
must be enabled to support RL to RH terminal voltage swings at the WIPER output and as described
previously, a VDD supply must be provided to support the power requirements of the charge pump.
Figure 5. Potentiometer Configuration
RH
WIPER
RL
VDD
1-WIRE
GND
2.8V to 6.0V
Bus
Master
VARIABLE RESISTOR CONFIGURATION
The Variable Resistor configuration as shown in Figure 6 is supported by all package types with or
without an external VDD supply. As described previously, without a VDD source the charge pump must
be disabled.
Figure 6. Variable Resistor Configurations
(TO92 Package)
RH
WIPER
RL
VDD
1-WIRE
GND
2.8V to 6.0V
or
No Connect
2.8V to 6.0V
Bus
Master
RH
1-WIRE
GND
2.8V to 6.0V
Bus
Master
相關PDF資料
PDF描述
CS3102A-40-57S CONN RCPT 4POS BOX MNT W/SCKT
DS1666S-100 IC DIG POT 100K 16SOIC
DS1666S-50 IC DIG POT 50K 16SOIC
M83723/95A1412N CONN PLUG 12POS STRAIGHT W/SCKT
D38999/20MJ61PN CONN RCPT 61POS WALL MNT W/PINS
相關代理商/技術參數
參數描述
DS28CM00 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:IC/SMBus Silicon Serial Number
DS28CM00EVKIT 制造商:Maxim Integrated Products 功能描述:DS28CM00 EV-BOARD W/ MAXQ BOARD - Rail/Tube
DS28CM00R-A00+T 功能描述:序列號注冊 I2C/SMBus Silicon Serial Number RoHS:否 制造商:Maxim Integrated 數據總線寬度: 電源電壓-最大: 電源電壓-最小: 最大工作溫度: 最小工作溫度: 安裝風格: 封裝 / 箱體:
DS28CM00R-A00+U 制造商:Maxim Integrated Products 功能描述:SMBUS SILICON SERIAL NUMBER 制造商:Maxim Integrated Products 功能描述:SMBUS INTRFC 5PIN SOT-23 - Rail/Tube 制造商:Maxim Integrated Products 功能描述:SILICON SERIAL NUMBER, 5-SOT23 制造商:Maxim Integrated Products 功能描述:SILICON SERIAL NUMBER, 5-SOT23, IC Function:Silicon Serial Number IC, Brief Feat
DS28CN01 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:1Kbit IC/SMBus EEPROM with SHA-1 Engine