- 您現在的位置：買賣IC網 > PDF目錄9186 > DS3901E+T&R (Maxim Integrated Products)IC RESIST VAR TRPL 14TSSOP PDF資料下載
參數資料
| 型號： | DS3901E+T&R |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 11/20頁 |
| 文件大小： | 0K |
| 描述： | IC RESIST VAR TRPL 14TSSOP |
| 產品培訓模塊： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 標準包裝： | 2,500 |
| 接片： | 256 |
| 電阻（歐姆）： | 20k，30k，50k |
| 電路數： | 3 |
| 溫度系數： | 標準值 50 ppm/°C |
| 存儲器類型： | 非易失 |
| 接口： | I²C（設備位址） |
| 電源電壓： | 2.4 V ~ 5.5 V |
| 工作溫度： | -40°C ~ 95°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 14-TSSOP（0.173"，4.40mm 寬） |
| 供應商設備封裝： | 14-TSSOP |
| 包裝： | 帶卷 (TR) |
DS3901
Triple, 8-Bit NV Variable Resistor
with Dual Settings and User EEPROM
____________________________________________________________________
19
Reading a Single Byte from a Slave: Unlike the write
operation that uses the memory address byte to define
where the data is to be written, the read operation
occurs at the present value of the memory address
counter. To read a single byte from the slave, the mas-
ter generates a START condition, writes the slave
address byte with R/W = 1, reads the data byte with a
NACK to indicate the end of the transfer, and generates
a STOP condition.
Manipulating the Address Counter for Reads: A
dummy write cycle can be used to force the address
counter to a particular value. To do this, the master
generates a START condition, writes the slave address
byte (R/W = 0), writes the memory address where it
desires to read, generates a repeated START condition,
writes the slave address byte (R/W = 1), reads data
with ACK or NACK as applicable, and generates a
STOP condition.
Reading Multiple Bytes from a Slave: The read oper-
ation can be used to read multiple bytes with a single
transfer. When reading bytes from the slave, the master
simply ACKs the data byte if it desires to read another
byte before terminating the transaction. After the master
reads the last byte, it NACKs to indicate the end of the
transfer and generates a stop condition. This can be
done with or without modifying the address counter’s
location before the read cycle.
Applications Information
Power-Supply Decoupling
To achieve best results, it is recommended that the power
supply is decoupled with a 0.01F or a 0.1F capacitor.
Use high-quality, ceramic, surface-mount capacitors, and
mount the capacitors as close as possible to the VCC and
GND pins to minimize lead inductance.
SDA and SCL Pullup Resistors
SDA is an open-collector output on the DS3901 that
requires a pullup resistor to realize high logic levels. A
master using either an open-collector output with a
pullup resistor or a push-pull output driver can be uti-
lized for SCL. Pullup resistor values should be chosen
to ensure that the rise and fall times listed in the AC
Electrical Characteristics are within specification.
Chip Topology
TRANSISTOR COUNT: 52,353
SUBSTRATE CONNECTED TO GROUND
相關PDF資料 |
PDF描述 |
|---|---|
| DS3903E-020+T&R | IC POT NV TRIPLE 128POS 20-TSSOP |
| IDT72V71643BC | IC DGTL SW 4096X4096 144-BGA |
| DS3902U-515+ | IC RESIST VAR DUAL 8-USOP |
| DS1841N+T&R | IC RES LOG NV I2C 10-TDFN |
| MS3108E28-11S | CONN PLUG 22POS RT ANG W/SCKT |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DS3902 | 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:Dual, NV, Variable Resistors with User EEPROM |
| DS3902425 | 制造商:MAJOR 功能描述: |
| DS3902U-515 | 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:Dual, NV, Variable Resistors with User EEPROM |
| DS3902U-515+ | 功能描述:數字電位計 IC Dual NV Variable w/EEPROM RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel |
| DS3902U-515+T&R | 制造商:Maxim Integrated Products 功能描述:VARIABLE RESS W/ USER EEPROM 8USOP - Tape and Reel |
發布緊急采購，3分鐘左右您將得到回復。