參數資料
型號: DSP56311VL150
廠商: Freescale Semiconductor
文件頁數: 78/96頁
文件大?。?/td> 0K
描述: IC DSP 24BIT FIXED POINT 196-BGA
標準包裝: 126
系列: DSP56K/Symphony
類型: 定點
接口: 主機接口,SSI,SCI
時鐘速率: 150MHz
非易失內存: ROM(576 B)
芯片上RAM: 384kB
電壓 - 輸入/輸出: 3.30V
電壓 - 核心: 1.80V
工作溫度: -40°C ~ 100°C
安裝類型: 表面貼裝
封裝/外殼: 196-LBGA
供應商設備封裝: 196-MAPBGA(15x15)
包裝: 托盤
DSP56311 Technical Data, Rev. 8
1-4
Freescale Semiconductor
Signals/Connections
1.4 PLL
1.5 External Memory Expansion Port (Port A)
Note:
When the DSP56311 enters a low-power standby mode (stop or wait), it releases bus mastership and tri-
states the relevant Port A signals: A[0–17], D[0–23], AA[03], RD, WR, BB.
1.5.1
External Address Bus
Table 1-5.
Phase-Locked Loop Signals
Signal Name
Type
State During
Reset
Signal Description
CLKOUT
Output
Chip-driven
Clock Output—Provides an output clock synchronized to the internal core
clock phase.
If the PLL is enabled and both the multiplication and division factors equal one,
then CLKOUT is also synchronized to EXTAL.
If the PLL is disabled, the CLKOUT frequency is half the frequency of EXTAL.
Note: At operating frequencies above 100 MHz, this signal produces a low-
amplitude waveform that is not usable externally by other devices. Above 100
MHz, you can use the asynchronous bus arbitration option that is enabled by
the Asynchronous Bus Arbitration Enable (ABE) bit in the Operating Mode
Register. When set, the DSP enters the Asynchronous Arbitration mode,
which eliminates the BB and BG set-up and hold time requirements with
respect to CLKOUT.
PCAP
Input
PLL Capacitor—An input connecting an off-chip capacitor to the PLL filter.
Connect one capacitor terminal to PCAP and the other terminal to VCCP.
If the PLL is not used, PCAP can be tied to VCC, GND, or left floating.
PINIT
NMI
Input
PLL Initial—During assertion of RESET, the value of PINIT is written into the
PLL enable (PEN) bit of the PLL control (PCTL) register, determining whether
the PLL is enabled or disabled.
Nonmaskable Interrupt—After RESET deassertion and during normal
instruction processing, this Schmitt-trigger input is the negative-edge-triggered
NMI request internally synchronized to CLKOUT.
Table 1-6.
External Address Bus Signals
Signal Name
Type
State During
Reset, Stop,
or Wait
Signal Description
A[0–17]
Output
Tri-stated
Address Bus—When the DSP is the bus master, A[0–17] are active-high
outputs that specify the address for external program and data memory
accesses. Otherwise, the signals are tri-stated. To minimize power dissipation,
A[0–17] do not change state when external memory spaces are not being
accessed.
相關PDF資料
PDF描述
VI-B52-CY-F2 CONVERTER MOD DC/DC 15V 50W
XC9536XL-10VQG64I IC CPLD 36MCRCELL 10NS 64VQFP
DSP56311VF150 IC DSP 24BIT 150MHZ 196-BGA
GCB13DHRD CONN CARD EXTEND 26POS .050" SLD
LT3083ET#TRPBF IC REG LDO ADJ 3A TO-220-5
相關代理商/技術參數
參數描述
DSP56311VL150B1 功能描述:數字信號處理器和控制器 - DSP, DSC 24 BIT DSP PBFREE RoHS:否 制造商:Microchip Technology 核心:dsPIC 數據總線寬度:16 bit 程序存儲器大小:16 KB 數據 RAM 大小:2 KB 最大時鐘頻率:40 MHz 可編程輸入/輸出端數量:35 定時器數量:3 設備每秒兆指令數:50 MIPs 工作電源電壓:3.3 V 最大工作溫度:+ 85 C 封裝 / 箱體:TQFP-44 安裝風格:SMD/SMT
DSP56311VL150R2 功能描述:數字信號處理器和控制器 - DSP, DSC 24 BIT DSP PBFREE RoHS:否 制造商:Microchip Technology 核心:dsPIC 數據總線寬度:16 bit 程序存儲器大小:16 KB 數據 RAM 大小:2 KB 最大時鐘頻率:40 MHz 可編程輸入/輸出端數量:35 定時器數量:3 設備每秒兆指令數:50 MIPs 工作電源電壓:3.3 V 最大工作溫度:+ 85 C 封裝 / 箱體:TQFP-44 安裝風格:SMD/SMT
DSP56311VL160 功能描述:數字信號處理器和控制器 - DSP, DSC 24 BIT DSP PBFREE RoHS:否 制造商:Microchip Technology 核心:dsPIC 數據總線寬度:16 bit 程序存儲器大小:16 KB 數據 RAM 大小:2 KB 最大時鐘頻率:40 MHz 可編程輸入/輸出端數量:35 定時器數量:3 設備每秒兆指令數:50 MIPs 工作電源電壓:3.3 V 最大工作溫度:+ 85 C 封裝 / 箱體:TQFP-44 安裝風格:SMD/SMT
DSP56321 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:24-Bit Digital Signal Processor
DSP56321EVM 功能描述:開發板和工具包 - 其他處理器 DSP56321EVM RoHS:否 制造商:Freescale Semiconductor 產品:Development Systems 工具用于評估:P3041 核心:e500mc 接口類型:I2C, SPI, USB 工作電源電壓: