參數資料
型號： DSPIC30F2011-20I/SO
廠商： Microchip Technology
文件頁數： 34/66頁
文件大?。?/td> 0K
描述： IC DSPIC MCU/DSP 12K 18SOIC
產品培訓模塊： Serial Communications using dsPIC30F I2C
Serial Communications using dsPIC30F SPI
Serial Communications using dsPIC30F UART
dsPIC30F 12 bit ADC - Part 2
dsPIC30F Addressing Modes - Part 1
dsPIC30F Architecture - Part 1
dsPIC30F DSP Engine & ALU
dsPIC30F Interrupts
dsPIC30F Motor Control PWM
dsPIC Timers
Asynchronous Stimulus
dsPIC30F Addressing Modes - Part 2
dsPIC30F Architecture - Part 2
dsPIC30F 12-bit ADC Part 1
標準包裝： 42
系列： dsPIC™ 30F
核心處理器： dsPIC
芯體尺寸： 16-位
速度： 20 MIPS
連通性： I²C，SPI，UART/USART
外圍設備： 欠壓檢測/復位，POR，PWM，WDT
輸入/輸出數： 12
程序存儲器容量： 12KB（4K x 24）
程序存儲器類型： 閃存
RAM 容量： 1K x 8
電壓 - 電源 (Vcc/Vdd)： 2.5 V ~ 5.5 V
數據轉換器： A/D 8x12b
振蕩器型： 內部
工作溫度： -40°C ~ 85°C
封裝/外殼： 18-SOIC（0.295"，7.50mm 寬）
包裝： 管件
配用： XLT18SO-1-ND - SOCKET TRANSITION 18SOIC 300MIL
AC30F005-ND - MODULE SCKT DSPIC30F 18DIP/SOIC
其它名稱： DSPIC30F201120ISO
dsPIC30F Flash Programming Specification
DS70102K-page 4
2010 Microchip Technology Inc.
3.0
PROGRAMMING EXECUTIVE
APPLICATION
3.1
Programming Executive Overview
The programming executive resides in executive
memory and is executed when Enhanced ICSP
Programming mode is entered. The programming exec-
utive provides the mechanism for the programmer (host
device) to program and verify the dsPIC30F, using a
simple command set and communication protocol.
The following capabilities are provided by the
programming executive:
Read memory
- Code memory and data EEPROM
- Configuration registers
-Device ID
Erase memory
- Bulk Erase by segment
- Code memory (by row)
- Data EEPROM (by row)
Program memory
- Code memory
- Data EEPROM
- Configuration registers
Query
- Blank Device
- Programming executive software version
The programming executive performs the low-level
tasks required for erasing and programming. This
allows the programmer to program the device by
issuing the appropriate commands and data.
The programming procedure is outlined in Section 5.0
3.2
Programming Executive Code
Memory
The programming executive is stored in executive code
memory and executes from this reserved region of
memory. It requires no resources from user code
memory or data EEPROM.
3.3
Programming Executive Data RAM
The programming executive uses the device’s data
RAM for variable storage and program execution. Once
the programming executive has run, no assumptions
should be made about the contents of data RAM.
4.0
CONFIRMING THE CONTENTS
OF EXECUTIVE MEMORY
Before programming can begin, the programmer must
confirm that the programming executive is stored in exec-
utive memory. The procedure for this task is illustrated in
First, ICSP mode is entered. The unique application ID
word stored in executive memory is then read. If the
programming executive is resident, the application ID
word is 0xBB, which means programming can resume
as normal. However, if the application ID word is not
0xBB,
the
programming
executive
must
be
programmed to Executive Code memory using the
Section 11.0 “ICSP Mode” describes the process
for the ICSP programming method. Section 11.13
procedure for reading the application ID word in ICSP
mode.
FIGURE 4-1:
CONFIRMING PRESENCE
OF THE PROGRAMMING
EXECUTIVE
Is
Start
Enter ICSP Mode
Application ID
0xBB?
Resident in Memory
Yes
No
Prog. Executive is
Application ID
Read the
be Programmed
Prog. Executive must
from Address
0x8005BE
Finish
相關PDF資料
PDF描述
DSPIC30F2011-30I/SO IC DSPIC MCU/DSP 12K 18SOIC
PIC16LF87-I/P IC MCU FLASH 4KX14 EEPROM 18DIP
PIC16C711-20/P IC MCU OTP 1KX14 A/D 18DIP
SFW30R-1STE1 SFW30R-1STE1-FFC/FPC CONN
SFW25R-1STE1 SFW25R-1STE1-FFC/FPC CONN
相關代理商/技術參數
參數描述
dsPIC30F2011-30I/ML 功能描述:數字信號處理器和控制器 - DSP, DSC 28LD 30MIPS 12 KB RoHS:否 制造商:Microchip Technology 核心:dsPIC 數據總線寬度:16 bit 程序存儲器大小:16 KB 數據 RAM 大小:2 KB 最大時鐘頻率:40 MHz 可編程輸入/輸出端數量:35 定時器數量:3 設備每秒兆指令數:50 MIPs 工作電源電壓:3.3 V 最大工作溫度:+ 85 C 封裝 / 箱體:TQFP-44 安裝風格:SMD/SMT
dsPIC30F2011-30I/P 功能描述:數字信號處理器和控制器 - DSP, DSC 18LD 30MIPS 12 KB RoHS:否 制造商:Microchip Technology 核心:dsPIC 數據總線寬度:16 bit 程序存儲器大小:16 KB 數據 RAM 大小:2 KB 最大時鐘頻率:40 MHz 可編程輸入/輸出端數量:35 定時器數量:3 設備每秒兆指令數:50 MIPs 工作電源電壓:3.3 V 最大工作溫度:+ 85 C 封裝 / 箱體:TQFP-44 安裝風格:SMD/SMT
DSPIC30F2011-30I/P 制造商:Microchip Technology Inc 功能描述:16- Bit Digital Signal Controller
dsPIC30F2011-30I/SO 功能描述:數字信號處理器和控制器 - DSP, DSC 18LD 30MIPS 12 KB RoHS:否 制造商:Microchip Technology 核心:dsPIC 數據總線寬度:16 bit 程序存儲器大小:16 KB 數據 RAM 大小:2 KB 最大時鐘頻率:40 MHz 可編程輸入/輸出端數量:35 定時器數量:3 設備每秒兆指令數:50 MIPs 工作電源電壓:3.3 V 最大工作溫度:+ 85 C 封裝 / 箱體:TQFP-44 安裝風格:SMD/SMT
DSPIC30F2011-30I/SO 制造商:Microchip Technology Inc 功能描述:16- Bit Digital Signal Controller
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*