- 您現在的位置：買賣IC網 > PDF目錄10624 > EL1881CSZ (Intersil)IC VIDEO SYNC SEPARATOR 8SOIC PDF資料下載
參數資料
| 型號： | EL1881CSZ |
| 廠商： | Intersil |
| 文件頁數： | 13/13頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC VIDEO SYNC SEPARATOR 8SOIC |
| 標準包裝： | 97 |
| 類型： | 同步分離器 |
| 應用： | 驅動器，通信，PCMCIA |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 8-SOIC（0.154"，3.90mm 寬） |
| 供應商設備封裝： | 8-SOIC |
| 包裝： | 管件 |
| 產品目錄頁面： | 1247 (CN2011-ZH PDF) |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁當前第13頁
9
FN7018.2
September 15, 2011
Applications Information
Video In
Figure 24 shows a “Simplified Block Diagram” on page 11.
An AC-coupled video signal is input to Video In pin 2 via, C1
nominally 0.1F. Clamp charge current will prevent the
signal on pin 2 from going any more negative than Sync Tip
Ref, about 1.5V. This charge current is nominally about 1mA.
A clamp discharge current of about 10A is always
attempting to discharge C1 to Sync Tip Ref, thus charge is
lost between sync pulses that must be replaced during sync
pulses. The droop voltage that will occur can be calculated
from It = CV, where V is the droop voltage, I is the discharge
current, t is the time between sync pulses
(sync period - sync tip width), and C is C1.
An NTSC video signal has a horizontal frequency of
15.73kHz, and a sync tip width of 4.7s. This gives a period
of 63.6s and a time t = 58.9s. The droop voltage will then
be V = 5.9mV. This is < 2% of a nominal sync tip amplitude
of 286mV. The charge represented by this droop is replaced
in a time given by t = CV/I, where I = clamp charge current =
1mA. Here t = 590ns, about 12% of the sync pulse width of
4.7s. It is important to choose C1 large enough so that the
droop voltage does not approach the switching threshold of
the internal comparator.
Fixed Gain Buffer
The clamped video signal then passes to the fixed gain
buffer which places the sync slice level at the equivalent
level of 70mV above sync tip. The output of this buffer is
presented to the comparator, along with the slice reference.
The comparator output is level shifted and buffered to TTL
levels, and sent out as Composite Sync to pin 1.
Burst
A low-going Burst pulse follows each rising edge of sync,
and lasts approximately 3.5s for an RSET of 681kΩ.
Vertical Sync
A low-going Vertical Sync pulse is output during the start of
the vertical cycle of the incoming video signal. The vertical
cycle starts with a pre-equalizing phase of pulses with a duty
cycle of about 93%, followed by a vertical serration phase
FIGURE 22. STANDARD VERTICAL TIMING
Expanded Timing Diagrams (Continued)
EL1881
相關PDF資料 |
PDF描述 |
|---|---|
| VI-J4L-MY-F2 | CONVERTER MOD DC/DC 28V 50W |
| FMS6501MSA28X | IC VIDEO SW MATRIX 12X9 28SSOP |
| VI-J4K-MY-F4 | CONVERTER MOD DC/DC 40V 50W |
| RP13A-12RA-13PA | CONN RECEPT 13POS MALE DIP |
| VI-J4K-MY-F3 | CONVERTER MOD DC/DC 40V 50W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| EL1881CSZ-T13 | 功能描述:視頻 IC EL1881CSZ SYNC SEPERATOR RoHS:否 制造商:Fairchild Semiconductor 工作電源電壓:5 V 電源電流:80 mA 最大工作溫度:+ 85 C 封裝 / 箱體:TSSOP-28 封裝:Reel |
| EL1881CSZ-T7 | 功能描述:視頻 IC EL1881CSZ SYNC SEPERATOR RoHS:否 制造商:Fairchild Semiconductor 工作電源電壓:5 V 電源電流:80 mA 最大工作溫度:+ 85 C 封裝 / 箱體:TSSOP-28 封裝:Reel |
| EL1881CSZ-T7A | 功能描述:視頻 IC EL1881CSZ SYNC SEPERATOR RoHS:否 制造商:Fairchild Semiconductor 工作電源電壓:5 V 電源電流:80 mA 最大工作溫度:+ 85 C 封裝 / 箱體:TSSOP-28 封裝:Reel |
| EL1882C | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Sync Separator w/50% Slice, AGC |
| EL1882CN | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Sync Separator w/50% Slice, AGC |
發布緊急采購，3分鐘左右您將得到回復。