- 您現在的位置：買賣IC網 > PDF目錄295877 > EL5325AIREZ-T13 (INTERSIL CORP) 12-Channel TFT-LCD Reference Voltage Generator with External Shutdown PDF資料下載
參數資料
| 型號： | EL5325AIREZ-T13 |
| 廠商： | INTERSIL CORP |
| 元件分類： | 基準電壓源/電流源 |
| 英文描述： | 12-Channel TFT-LCD Reference Voltage Generator with External Shutdown |
| 中文描述： | 12-OUTPUT THREE TERM VOLTAGE REFERENCE, PDSO28 |
| 封裝： | ROHS COMPLIANT, MO-153, HTSSOP-28 |
| 文件頁數： | 9/12頁 |
| 文件大?。?/td> | 851K |
| 代理商： | EL5325AIREZ-T13 |
6
General Description
The EL5325A provides a versatile method of providing the
reference voltages that are used in setting the transfer
characteristics of LCD display panels. The V/T
(Voltage/Transmission) curve of the LCD panel requires that
a correction is applied to make it linear; however, if the panel
is to be used in more than one application, the final curve
may differ for different applications. By using the EL5325A,
the V/T curve can be changed to optimize its characteristics
according to the required application of the display product.
Each of the eight reference voltage outputs can be set with a
10-bit resolution. These outputs can be driven to within
50mV of the power rails of the EL5325A. As all of the output
buffers are identical, it is also possible to use the EL5325A
for applications other than LCDs where multiple voltage
references are required that can be set to 10 bit accuracy.
Digital Interface
The EL5325A uses a simple 3-wire SPI compliant digital
interface to program the outputs. The EL5325A can support
the clock rate up to 5MHz.
Serial Interface
The EL5325A is programmed through a three-wire serial
interface. The start and stop conditions are defined by the
ENA signal. While the ENA is low, the data on the SDI (serial
data input) pin is shifted into the 16-bit shift register on the
positive edge of the SCLK (serial clock) signal. The MSB (bit
15) is loaded first and the LSB (bit 0) is loaded last (see
Table 1). After the full 16-bit data has been loaded, the ENA
is pulled high and the addressed output channel is updated.
The SCLK is disabled internally when the ENA is high. The
SCLK must be low before the ENA is pulled low.
To facilitate the system designs that use multiple EL5325A
chips, a buffered serial output of the shift register (SDO pin)
is available. Data appears on the SDO pin at the 16th falling
SCLK edge after being applied to the SDI pin.
To control the multiple EL5325A chips from a single three-
wire serial port, just connect the ENA pins and the SCLK
pins together, connect the SDO pin to the SDI pin on the
next chip. While the ENA is held low, the 16m-bit data is
loaded to the SDI input of the first chip. The first 16-bit data
will go to the last chip and the last 16-bit data will go to the
first chip. While the ENA is held high, all addressed outputs
will be updated simultaneously.
The Serial Timing Diagram and parameters table show the
timing requirements for three-wire signals.
The serial data has a minimum length of 16 bits, the MSB
(most significant bit) is the first bit in the signal. The bits are
allocated to the following functions (also refer to the Control
Bits Logic Table)
Bit 15 is always set to a zero
Bit 14 controls the source of the clock, see the next
section for details
Bits 13 through 10 select the channel to be written to,
these are binary coded with channel A = 0, and channel
H= 7
The 10-bit data is on bits 9 through 0. Some examples of
data words are shown in the table of Serial Programming
Examples
TABLE 1. CONTROL BITS LOGIC TABLE
BIT
NAME
DESCRIPTION
B15
Test
Always 0
B14
Oscillator
0 = Internal, 1 = External
B13
A3
Channel Address
B12
A2
Channel Address
B11
A1
Channel Address
B10
A0
Channel Address
B9
D9
Data
B8
D8
Data
B7
D7
Data
B6
D6
Data
B5
D5
Data
B4
D4
Data
B3
D3
Data
B2
D2
Data
B1
D1
Data
B0
D0
Data
EL5325A
相關PDF資料 |
PDF描述 |
|---|---|
| EL5325AIREZ-T7 | 12-Channel TFT-LCD Reference Voltage Generator with External Shutdown |
| EL5370IUZ | 100MHz Differential Twisted-Pair Drivers |
| EL5370IUZ-T13 | 100MHz Differential Twisted-Pair Drivers |
| EL5370IUZ-T7 | 100MHz Differential Twisted-Pair Drivers |
| EL5371IUZ | 250MHz Differential Twisted-Pair Drivers |
相關代理商/技術參數 |
參數描述 |
|---|---|
| EL5325AIREZ-T7 | 功能描述:LCD Gamma緩沖器 EL5325AIREZ 12CH TFT LCDFERENCE VAGE GEN RoHS:否 制造商:Maxim Integrated 輸入補償電壓: 轉換速度: 電源電壓-最大:20 V 電源電壓-最小:9 V 電源電流: 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-38 封裝:Tube |
| EL5325AIRZ | 功能描述:LCD Gamma緩沖器 EL5325AIRZ 12 CH TFT LCDFERENCE VAGE GEN RoHS:否 制造商:Maxim Integrated 輸入補償電壓: 轉換速度: 電源電壓-最大:20 V 電源電壓-最小:9 V 電源電流: 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-38 封裝:Tube |
| EL5325AIRZ-T13 | 功能描述:LCD Gamma緩沖器 EL5325AIREZ 12CH TFT LCDFERENCE VAGE GEN RoHS:否 制造商:Maxim Integrated 輸入補償電壓: 轉換速度: 電源電壓-最大:20 V 電源電壓-最小:9 V 電源電流: 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-38 封裝:Tube |
| EL5325AIRZ-T7 | 功能描述:LCD Gamma緩沖器 EL5325AIRZ 12 CH TFT LCDFERENCE VAGE GEN RoHS:否 制造商:Maxim Integrated 輸入補償電壓: 轉換速度: 電源電壓-最大:20 V 電源電壓-最小:9 V 電源電流: 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-38 封裝:Tube |
| EL5325IREZ | 功能描述:LCD Gamma緩沖器 EL5325IREZ 12 CH TFT LCDFERENCE VAGE GEN RoHS:否 制造商:Maxim Integrated 輸入補償電壓: 轉換速度: 電源電壓-最大:20 V 電源電壓-最小:9 V 電源電流: 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-38 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。